Tight-binding study of hydrogen on the C(111), C(100), and C(110) diamond surfaces

Tight Binding Modeling of Properties Related to Field Emission from Nanodiamond Clusters

The electronic structure of nanodiamond clusters containing between 34 and 913 carbon atoms was calculated using a tight-binding Hamiltonian. All clusters had shapes represented by an octahedron with (111) facets with the top and the bottom vertices truncated to introduce (100) surfaces. The tight-binding Hamiltonian consisted of environment-dependent matrix elements, and C-H parameters fit to reproduce energy states of the cyclic C6 and methane. The calculations predict a density of states similar to bulk diamond for clusters with radii greater than ∼2.5nm, and insignificant differences in the potential distribution between the clusters and bulk diamond for radii greater than ∼1nm. Hydrogen passivated nanodiamond clusters are estimated to have an electron affinity of approximately -1.8 eV.

Atomic-scale friction on diamond: a comparison of different sliding directions on (001) and (111) surfaces using MD and AFM

Atomic force microscopy (AFM) experiments and molecular dynamics (MD) simulations were conducted to examine single-asperity friction as a function of load, surface orientation, and sliding direction on individual crystalline grains of diamond in the wearless regime. Experimental and simulation conditions were designed to correspond as closely as state-of-the-art techniques allow. Both hydrogen-terminated diamond (111)(1 x 1)-H and the dimer row-reconstructed diamond (001)(2 x 1)-H surfaces were examined. The MD simulations used H-terminated diamond tips with both flat- and curved-end geometries, and the AFM experiments used two spherical, hydrogenated amorphous carbon tips. The AFM measurements showed higher adhesion and friction forces for (001) vs (111) surfaces. However, the increased friction forces can be entirely attributed to increased contact area induced by higher adhesion. Thus, no difference in the intrinsic resistance to friction (i.e., in the interfacial shear strength) is observed. Similarly, the MD results show no significant difference in friction between the two diamond surfaces, except for the specific case of sliding at high pressures along the dimer row direction on the (001) surface. The origin of this effect is discussed. The experimentally observed dependence of friction on load fits closely with the continuum Maugis-Dugdale model for contact area, consistent with the occurrence of single-asperity interfacial friction (friction proportional to contact area with a constant shear strength). In contrast, the simulations showed a nearly linear dependence of the friction on load. This difference may arise from the limits of applicability of continuum mechanics at small scales, because the contact areas in the MD simulations are significantly smaller than the AFM experiments. Regardless of scale, both the AFM and MD results show that nanoscale tribological behavior deviates dramatically from the established macroscopic behavior of diamond, which is highly dependent on orientation.