Spectroscopic evidence of pressure-induced amorphization in alpha -NaVO3

Pressure-induced bandgap engineering and photoresponse enhancement of wurtzite CuInS2 nanocrystals

Wurtzite CuInS₂ exhibits great potential for optoelectronic applications because of its excellent optical properties and good stability. However, exploring effective strategies to simultaneously optimize its optical and photoelectrical properties remains a challenge. In this study, the bandgap of wurtzite CuInS₂ nanocrystals is successfully extended and the photocurrent is enhanced synchronously using external pressure. The bandgap of wurtzite CuInS₂ increases with pressure and reaches an optimal value (1.5 eV) for photovoltaic solar energy conversion at about 5.9 GPa. Surprisingly, the photocurrent simultaneously increases nearly 3-fold and reaches the maximum value at this critical pressure. Theoretical calculation indicates that the pressure-induced bandgap extention in wurtzite CuInS₂ may be attributed to an increased charge density and ionic polarization between the In-S atoms. The photocurrent preserves a relatively high photoresponse even at 8.8 GPa, but almost disappears above 10.3 GPa. The structural evolution demonstrates that CuInS₂ undergoes a phase transformation from the wurtzite phase (P6₃mc) to the rock salt phase (Fm3̄m) at about 10.3 GPa, which resulted in a direct to indirect bandgap transition and fianlly caused a dramatic reduction in photocurrent. These results not only map a new route toward further increase in the photoelectrical performance of wurtzite CuInS₂, but also advance the current research of A^I-B^III-CVI2 materials.

A selective electrochemical sensor for caffeic acid and photocatalyst for metronidazole drug pollutant - A dual role by rod-like SrV2O6

In the present study, well-defined one-dimensional (1D) rod-like strontium vanadate (SrV2O6) was prepared by simple hydrothermal method without using any other surfactants/templates. The successful formation of rod-like SrV2O6 was confirmed by various analytical and spectroscopic techniques. Interestingly, for the first time the dual role of as-prepared rod-like SrV2O6 were employed as an electrochemical sensor for the detection of caffeic acid (CA) as well as visible light active photocatalyst for the degradation of metronidazole (MNZ) antibiotic drug. As an electrochemical sensor, the SrV2O6 modified glassy carbon electrode (GCE) demonstrated a superior electrocatalytic activity for the detection of CA by chronoamperometry and cyclic voltammetry (CVs). In addition, the electrochemical sensor exhibited a good current response for CA with excellent selectivity, wide linear response range, lower detection limit and sensitivity of 0.01-207 µM, 4 nM and 2.064 μA μM-1cm-2, respectively. On the other hand, as-synthesized rod-like SrV2O6 showed highly efficient and versatile photocatalytic performances for the degradation of MNZ, which degrades above 98% of MNZ solution under visible light irradiation within 60 min. The obtained results evidenced that the improvement of rod-like SrV2O6 might be a resourceful electrocatalyst and photocatalyst material in the probable applications of environmental and biomedical applications.

Exploring the coordination change of vanadium and structure transformation of metavanadate MgV2O6 under high pressure

Raman spectroscopy, synchrotron angle-dispersive X-ray diffraction (ADXRD), first-principles calculations, and electrical resistivity measurements were carried out under high pressure to investigate the structural stability and electrical transport properties of metavanadate MgV₂O₆. The results have revealed the coordination change of vanadium ions (from 5+1 to 6) at around 4 GPa. In addition, a pressure-induced structure transformation from the C2/m phase to the C2 phase in MgV₂O₆ was detected above 20 GPa, and both phases coexisted up to the highest pressure. This structural phase transition was induced by the enhanced distortions of MgO₆ octahedra and VO₆ octahedra under high pressure. Furthermore, the electrical resistivity decreased with pressure but exhibited different slope for these two phases, indicating that the pressure-induced structural phase transitions of MgV₂O₆ was also accompanied by the obvious changes in its electrical transport behavior.

High-throughput operando Raman-quadrupole mass spectrometer (QMS) system to screen catalytic systems

This paper describes the design and setup of a high-throughput Raman system for an array of eight parallel catalytic reactors during reaction conditions. The "operando" methodology combines in situ spectroscopy during catalytic reaction with a simultaneous activity measurement. The high-throughput operando Raman system, multi-operando, is a device that automates this operando methodology for several catalyst samples at the same time, all samples being in the same reaction conditions. We describe how the system is made, how Raman system positions and acquires spectra, and how each reactor outlet gas is selected and analyzed.