Elastic properties of a confined fluid

Viscoelastic response of fluid trapped between two dissimilar van der Waals surfaces

Employing grand canonical Monte-Carlo and molecular dynamics simulations, the viscoelastic response of trapped fluid under molecularly thin confinement by walls having different wall-fluid interaction strengths, is investigated. With increase in slit asymmetry, given by the ratio of interaction strengths of the wall having strong wall-fluid interaction to that of the wall with weak wall-fluid interaction, a crossover in effective density of the fluid film, from rarer (R) to denser (D) than the bulk density is observed. Upon increasing asymmetry further, the dense fluid (F) layers undergo bond-orientational (S) ordering. The variation of viscoelastic relaxation time with scaled asymmetry shows a universal behavior, independent of slit width, with two distinct regimes. Below a critical value of asymmetry, the viscoelastic relaxation time is a slowly varying function of asymmetry, comparable with the structural relaxation time. Beyond the critical asymmetry, on the other hand, viscoelastic response time shows a sharp increase upon increasing asymmetry, deviating markedly from the structural relaxation time. Interestingly the critical asymmetry value is found to correlate with R to D crossover. The microscopic origin of the two-regime universal behavior of viscoelastic response time is found to stem from the fact that below critical asymmetry, the overall viscoelastic behaviour of the slit is dominated by that of the fast relaxing layer close to the weakly attracting surface, while above the critical asymmetry, the relaxation behaviour is guided by the dense fluid layer adjacent to the strongly attracting wall. In vicinity of fluid to ordering transition, the loss and storage moduli merge for low frequencies as in gel-like mechanical behaviour. The storage modulus takes over the loss modulus in the phase co-existence region even before the long ranged order sets in. Our findings bear important implications for fluid transport in hetero-structured geometry in nanotechnology.

Effect of pore geometry on the compressibility of a confined simple fluid

Fluids confined in nanopores exhibit properties different from the properties of the same fluids in bulk; among these properties is the isothermal compressibility or elastic modulus. The modulus of a fluid in nanopores can be extracted from ultrasonic experiments or calculated from molecular simulations. Using Monte Carlo simulations in the grand canonical ensemble, we calculated the modulus for liquid argon at its normal boiling point (87.3 K) adsorbed in model silica pores of two different morphologies and various sizes. For spherical pores, for all the pore sizes (diameters) exceeding 2 nm, we obtained a logarithmic dependence of fluid modulus on the vapor pressure. Calculation of the modulus at saturation showed that the modulus of the fluid in spherical pores is a linear function of the reciprocal pore size. The calculation of the modulus of the fluid in cylindrical pores appeared too scattered to make quantitative conclusions. We performed additional simulations at higher temperature (119.6 K), at which Monte Carlo insertions and removals become more efficient. The results of the simulations at higher temperature confirmed both regularities for cylindrical pores and showed quantitative difference between the fluid moduli in pores of different geometries. Both of the observed regularities for the modulus stem from the Tait-Murnaghan equation applied to the confined fluid. Our results, along with the development of the effective medium theories for nanoporous media, set the groundwork for analysis of the experimentally measured elastic properties of fluid-saturated nanoporous materials.

Local shear viscosity of strongly inhomogeneous dense fluids: from the hard-sphere to the Lennard-Jones fluids

This work aims at providing a tractable approach to model the local shear viscosity of strongly inhomogeneous dense fluids composed of spherical molecules, in which the density variations occur on molecular distance. The proposed scheme, which relies on the local density average model, has been applied to the quasi-hard-sphere, the Week-Chandler-Andersen and the Lennard-Jones fluids. A weight function has been developed to deal with the hard-sphere fluid given the specificities of momentum exchange. To extend the approach to the smoothly repulsive potential, we have taken into account that the non-local contributions to the viscosity due to the interactions of particles separated by a given distance are temperature dependent. Then, using a simple perturbation scheme, the approach is extended to the Lennard-Jones fluids. It is shown that the viscosity profiles of inhomogeneous dense fluids deduced from this approach are consistent with those directly computed by non-equilibrium molecular dynamics simulations.