Plastic deformations in complex plasmas

Shear softening and hardening of a two-dimensional Yukawa solid

Langevin dynamical simulations are performed to study the elastic behaviors of two-dimensional (2D) solid dusty plasmas under the periodic shear deformation. The frequency- and strain-dependent shear moduli G(ω,γ) of our simulated 2D Yukawa solid are calculated from the ratio of the shear stress to strain in different orientations. The shear-softening and -hardening properties in different lattice orientations are discovered from the obtained G(ω,γ). The component of the elastic constant tensor corresponding to the shear deformation is also calculated, whose variation trend exactly agrees with the discovered shear-softening and -hardening features in different shear directions. It is also found that the shear modulus of the 2D Yukawa solid always increases monotonically with the frequency.

Plastic strain rate quantified from dislocation dynamics in dusty plasma shear flows

Dynamics of dislocations and defects are investigated in 2D dusty plasma experiments with two counterpropagating flows. It is experimentally demonstrated that the Orowan equation is able to accurately determine the plastic strain rate from the motion of dislocations, well agreeing with the shear rate defined from the drift velocity gradient. For a higher shear rate, the studied system is in the liquidlike flow state, as a result, the determined shear rate from the Orowan equation deviates from its definition. The obtained probability distribution function of dislocations from the experiments clearly shows that the dislocation motion can be divided into the local and gliding ones. All findings above are further verified by the corresponding Langevin dynamical simulations with various levels of shear rates. The dislocation and defect analysis results from these simulations clearly indicate that the defect and dislocation dynamics in the sheared dusty plasmas clearly exhibit two stages as the shear rate increases.

Experimental determination of shock speed versus exciter speed in a two-dimensional dusty plasma

A shock that is continuously driven by a moving exciter will propagate at a speed that depends on the exciter speed. We obtained this dependence experimentally, in a strongly coupled dusty plasma that was prepared as a single two-dimensional layer of charged microparticles. Attaining this result required an experimental advance, developing a method of driving a shock continuously, which we did using an exciter moving at a constant supersonic speed, analogous to a piston in a cylinder. The resulting compressional pulse was a shock that propagated steadily without weakening, ahead of the moving exciter. We compare our experimental results to an empirical form M_{shock}=1+sM_{exciter}, and to the prediction of a recent simulation.

Shear modulus of two-dimensional Yukawa or dusty-plasma solids obtained from the viscoelasticity in the liquid state

Langevin dynamical simulations of two-dimensional (2D) Yukawa liquids are performed to investigate the shear modulus of 2D solid dusty plasmas. Using the known transverse sound speeds, we obtain a theoretical expression of the shear modulus of 2D Yukawa crystals as a function of the screening parameter κ, which can be used as the candidate of their shear modulus. The shear relaxation modulus G(t) of 2D Yukawa liquids is calculated from the shear stress autocorrelation function, consisting of the kinetic, potential, and cross portions. Due to their viscoelasticity, 2D Yukawa liquids exhibit the typical elastic property when the time duration is much less than the Maxwell relaxation time. As a result, the infinite frequency shear modulus G_{∞}, i.e., the shear relaxation modulus G(t) when t=0, of a 2D Yukawa liquid should be related to the shear modulus of the corresponding quenched 2D Yukawa solid (with the same κ value), with all particles suddenly frozen at their locations of the liquid state. It is found that the potential portion of the infinite frequency shear modulus for 2D Yukawa liquids at any temperature well agrees with the shear modulus of 2D Yukawa crystals with the same κ obtained from the transverse sound speeds. Thus, we find that the shear modulus of 2D Yukawa solids can be obtained from the motion of individual particles of the corresponding Yukawa liquids using their viscoelastic property.

Tracking and Linking of Microparticle Trajectories During Mode-Coupling Induced Melting in a Two-Dimensional Complex Plasma Crystal

In this article, a strategy to track microparticles and link their trajectories adapted to the study of the melting of a quasi two-dimensional complex plasma crystal induced by the mode-coupling instability is presented. Because of the three-dimensional nature of the microparticle motions and the inhomogeneities of the illuminating laser light sheet, the scattered light intensity can change significantly between two frames, making the detection of the microparticles and the linking of their trajectories quite challenging. Thanks to a two-pass noise removal process based on Gaussian blurring of the original frames using two different kernel widths, the signal-to-noise ratio was increased to a level that allowed a better intensity thresholding of different regions of the images and, therefore, the tracking of the poorly illuminated microparticles. Then, by predicting the positions of the microparticles based on their previous positions, long particle trajectories could be reconstructed, allowing accurate measurement of the evolution of the microparticle energies and the evolution of the monolayer properties.

Anisotropic confinement effects in a two-dimensional plasma crystal

The spectral asymmetry of the wave-energy distribution of dust particles during mode-coupling-induced melting, observed for the first time in plasma crystals by Couëdel et al. [Phys. Rev. E 89, 053108 (2014)PLEEE81539-375510.1103/PhysRevE.89.053108], is studied theoretically and by molecular-dynamics simulations. It is shown that an anisotropy of the well confining the microparticles selects the directions of preferred particle motion. The observed differences in intensity of waves of opposed directions are explained by a nonvanishing phonon flux. Anisotropic phonon scattering by defects and Umklapp scattering are proposed as possible reasons for the mean phonon flux.

Slow plastic creep of 2D dusty plasma solids

We report complex plasma experiments, assisted by numerical simulations, providing an alternative qualitative link between the macroscopic response of polycrystalline solid matter to small shearing forces and the possible underlying microscopic processes. In the stationary creep regime we have determined the exponents of the shear rate dependence of the shear stress and defect density, being α=1.15±0.1 and β=2.4±0.4, respectively. We show that the formation and rapid glide motion of dislocation pairs in the lattice are dominant processes.

Dislocation dynamics during plastic deformations of complex plasma crystals

The internal structures of most periodic crystalline solids contain defects. This affects various important mechanical and thermal properties of crystals. Since it is very difficult and expensive to track the motion of individual atoms in real solids, macroscopic model systems, such as complex plasmas, are often used. Complex plasmas consist of micrometer-sized grains immersed into an ion-electron plasma. They exist in solidlike, liquidlike, and gaseouslike states and exhibit a range of nonlinear and dynamic effects, most of which have direct analogies in solids and liquids. Slabs of a monolayer hexagonal complex plasma were subjected to a cycle of uniaxial compression and decompression of large amplitudes to achieve plastic deformations, both in experiments and simulations. During the cycle, the internal structure of the lattice exhibited significant rearrangements. Dislocations (point defects) were generated and displaced in the stressed lattice. They tended to glide parallel to their Burgers vectors under load. It was found that the deformation cycle was macroscopically reversible but irreversible at the particle scale.

Three-dimensional structure of Mach cones in monolayer complex plasma crystals

The structure of Mach cones in a crystalline complex plasma has been studied experimentally using an intensity sensitive imaging, which resolved particle motion in three dimensions. This revealed a previously unknown out-of-plane cone structure, which appeared due to excitation of the vertical wave mode. The complex plasma consisted of micron sized particles forming a monolayer in a plasma sheath of a gas discharge. Fast particles, spontaneously moving under the monolayer, created Mach cones with multiple structures. The in-plane cone structure was due to compressional and shear lattice waves.

Static and dynamic shear viscosity of a single-layer complex plasma

The static and dynamic (complex) shear viscosity of a single-layer dusty plasma is measured by applying, respectively, a stationary and a periodically modulated shear stress, induced by the light pressure of manipulating laser beams. Under static conditions we observe a decrease of the viscosity with increasing shear rate, the so-called shear-thinning behavior. Under oscillating shear both the magnitude and the ratio of the dissipative and elastic contributions to the complex viscosity show strong frequency dependence, as the system changes from viscous to elastic in nature with increasing excitation frequency. Accompanying molecular dynamics simulations explain and support the experimental observations.