Shock-induced transformation of Al2O3 and LiF into semiconducting liquids

Imaging velocity interferometer system for any reflector (VISAR) diagnostics for high energy density sciences

Two variants of optical imaging velocimetry, specifically the one-dimensional streaked line-imaging and the two-dimensional time-resolved area-imaging versions of the Velocity Interferometer System for Any Reflector (VISAR), have become important diagnostics in high energy density sciences, including inertial confinement fusion and dynamic compression of condensed matter. Here, we give a brief review of the historical development of these techniques, then describe the current implementations at major high energy density (HED) facilities worldwide, including the OMEGA Laser Facility and the National Ignition Facility. We illustrate the versatility and power of these techniques by reviewing diverse applications of imaging VISARs for gas-gun and laser-driven dynamic compression experiments for materials science, shock physics, condensed matter physics, chemical physics, plasma physics, planetary science and astronomy, as well as a broad range of HED experiments and laser-driven inertial confinement fusion research.

A compact x-ray diffraction system for dynamic compression experiments on pulsed-power generators

Pulsed-power generators can produce well-controlled continuous ramp compression of condensed matter for high-pressure equation-of-state studies using the magnetic loading technique. X-ray diffraction (XRD) data from dynamically compressed samples provide direct measurements of the elastic compression of the crystal lattice, onset of plastic flow, strength-strain rate dependence, structural phase transitions, and density of crystal defects, such as dislocations. Here, we present a cost-effective, compact, pulsed x-ray source for XRD measurements on pulsed-power-driven ramp-loaded samples. This combination of magnetically driven ramp compression of materials with a single, short-pulse XRD diagnostic will be a powerful capability for the dynamic materials' community to investigate in situ dynamic phase transitions critical to equation of states. We present results using this new diagnostic to evaluate lattice compression in Zr and Al and to capture signatures of phase transitions in CdS.

Equation of State of CO_{2} Shock Compressed to 1 TPa

Equation-of-state (pressure, density, temperature, internal energy) and reflectivity measurements on shock-compressed CO_{2} at and above the insulating-to-conducting transition reveal new insight into the chemistry of simple molecular systems in the warm-dense-matter regime. CO_{2} samples were precompressed in diamond-anvil cells to tune the initial densities from 1.35  g/cm^{3} (liquid) to 1.74  g/cm^{3} (solid) at room temperature and were then shock compressed up to 1 TPa and 93 000 K. Variation in initial density was leveraged to infer thermodynamic derivatives including specific heat and Gruneisen coefficient, exposing a complex bonded and moderately ionized state at the most extreme conditions studied.

Conductivity and dissociation in liquid metallic hydrogen and implications for planetary interiors

Liquid metallic hydrogen (LMH) is the most abundant form of condensed matter in our solar planetary structure. The electronic and thermal transport properties of this metallic fluid are of fundamental interest to understanding hydrogen's mechanism of conduction, atomic or pairing structure, as well as the key input for the magnetic dynamo action and thermal models of gas giants. Here, we report spectrally resolved measurements of the optical reflectance of LMH in the pressure region of 1.4-1.7 Mbar. We analyze the data, as well as previously reported measurements, using the free-electron model. Fitting the energy dependence of the reflectance data yields a dissociation fraction of 65 ± 15%, supporting theoretical models that LMH is an atomic metallic liquid. We determine the optical conductivity of LMH and find metallic hydrogen's static electrical conductivity to be 11,000-15,000 S/cm, substantially higher than the only earlier reported experimental values. The higher electrical conductivity implies that the Jovian and Saturnian dynamo are likely to operate out to shallower depths than previously assumed, while the inferred thermal conductivity should provide a crucial experimental constraint to heat transport models.

First-principles simulations of warm dense lithium fluoride

We perform first-principles path integral Monte Carlo (PIMC) and density functional theory molecular dynamics (DFT-MD) calculations to explore warm dense matter states of LiF. Our simulations cover a wide density-temperature range of 2.08-15.70gcm^{-3} and 10^{4}-10^{9} K. Since PIMC and DFT-MD accurately treat effects of atomic shell structure, we find a pronounced compression maximum and a shoulder on the principal Hugoniot curve attributed to K-shell and L-shell ionization. The results provide a benchmark for widely used EOS tables, such as SESAME, LEOS, and models. In addition, we compute pair-correlation functions that reveal an evolving plasma structure and ionization process that is driven by thermal and pressure ionization. Finally, we compute electronic density of states of liquid LiF from DFT-MD simulations and find that the electronic gap can remain open with increasing density and temperature to at least 15.7 gcm^{-3}.

Dynamic compression of dense oxide (Gd3Ga5O12) from 0.4 to 2.6 TPa: Universal Hugoniot of fluid metals

Materials at high pressures and temperatures are of great current interest for warm dense matter physics, planetary sciences, and inertial fusion energy research. Shock-compression equation-of-state data and optical reflectivities of the fluid dense oxide, Gd3Ga5O12 (GGG), were measured at extremely high pressures up to 2.6 TPa (26 Mbar) generated by high-power laser irradiation and magnetically-driven hypervelocity impacts. Above 0.75 TPa, the GGG Hugoniot data approach/reach a universal linear line of fluid metals, and the optical reflectivity most likely reaches a constant value indicating that GGG undergoes a crossover from fluid semiconductor to poor metal with minimum metallic conductivity (MMC). These results suggest that most fluid compounds, e.g., strong planetary oxides, reach a common state on the universal Hugoniot of fluid metals (UHFM) with MMC at sufficiently extreme pressures and temperatures. The systematic behaviors of warm dense fluid would be useful benchmarks for developing theoretical equation-of-state and transport models in the warm dense matter regime in determining computational predictions.

Experimental and ab initio investigations of microscopic properties of laser-shocked Ge-doped ablator

Plastic materials (CH) doped with mid-Z elements are used as ablators in inertial confinement fusion (ICF) capsules and in their surrogates. Hugoniot equation of state (EOS) and electronic properties of CH doped with germanium (at 2.5% and 13% dopant fractions) are investigated experimentally up to 7 Mbar using velocity and reflectivity measurements of shock fronts on the GEKKO laser at Osaka University. Reflectivity and temperature measurements were updated using a quartz standard. Shocked quartz reflectivity was measured at 532 and 1064 nm. Theoretical investigation of shock pressure and reflectivity was then carried out by ab initio simulations using the quantum molecular dynamics (QMD) code abinit and compared with tabulated average atom EOS models. We find that shock states calculated by QMD are in better agreement with experimental data than EOS models because of a more accurate description of ionic structure. We finally discuss electronic properties by comparing reflectivity data to a semiconductor gap closure model and to QMD simulations.

The electrical conductivity of Al2O3 under shock-compression

Sapphire (Al2O3) crystals are used below 100 GPa as anvils and windows in dynamic-compression experiments because of their transparency and high density. Above 100 GPa shock pressures, sapphire becomes opaque and electrically conducting because of shock-induced defects. Such effects prevent temperature and dc conductivity measurements of materials compressed quasi-isentropically. Opacities and electrical conductivities at ~100 GPa are non-equilibrium, rather than thermodynamic parameters. We have performed electronic structure calculations as a guide in predicting and interpreting shock experiments and possibly to discover a window up to ~200 GPa. Our calculations indicate shocked sapphire does not metallize by band overlap at ~300 GPa, as suggested previously by measured non-equilibrium data. Shock-compressed Al2O3 melts to a metallic liquid at ~500 GPa and 10,000 K and its conductivity increases rapidly to ~2000 Ω(-1)cm(-1) at ~900 GPa. At these high shock temperatures and pressures sapphire is in thermal equilibrium. Calculated conductivity of Al2O3 is similar to those measured for metallic fluid H, N, O, Rb, and Cs. Despite different materials, pressures and temperatures, and compression techniques, both experimental and theoretical, conductivities of all these poor metals reach a common end state typical of strong-scattering disordered materials.

Experimental evidence of new tetragonal polymorphs of silicon formed through ultrafast laser-induced confined microexplosion

Ordinary materials can transform into novel phases at extraordinary high pressure and temperature. The recently developed method of ultrashort laser-induced confined microexplosions initiates a non-equilibrium disordered plasma state. Ultra-high quenching rates overcome kinetic barriers to the formation of new metastable phases, which are preserved in the surrounding pristine crystal for subsequent exploitation. Here we demonstrate that confined microexplosions in silicon produce several metastable end phases. Comparison with an ab initio random structure search reveals six energetically competitive potential phases, four tetragonal and two monoclinic structures. We show the presence of bt8 and st12, which have been predicted theoretically previously, but have not been observed in nature or in laboratory experiments. In addition, the presence of the as yet unidentified silicon phase, Si-VIII and two of our other predicted tetragonal phases are highly likely within laser-affected zones. These findings may pave the way for new materials with novel and exotic properties.

Ab initio calculation of shocked xenon reflectivity

Reflectivity of shocked compressed xenon plasma is calculated within the framework of the density functional theory approach. Dependencies on the frequency of incident radiation and on the plasma density are analyzed. The Fresnel formula for the reflectivity is used. The longitudinal expression in the long-wavelength limit is applied for the calculation of the imaginary part of the dielectric function. The real part of the dielectric function is calculated by means of the Kramers-Kronig transformation. The results are compared with experimental data. The approach for the calculation of plasma frequency is developed.

Evidence for a phase transition in silicate melt at extreme pressure and temperature conditions

Laser-driven shock compression experiments reveal the presence of a phase transition in MgSiO(3) over the pressure-temperature range 300-400 GPa and 10 000-16 000 K, with a positive Clapeyron slope and a volume change of ∼6.3 (±2.0) percent. The observations are most readily interpreted as an abrupt liquid-liquid transition in a silicate composition representative of terrestrial planetary mantles, implying potentially significant consequences for the thermal-chemical evolution of extrasolar planetary interiors. In addition, the present results extend the Hugoniot equation of state of MgSiO(3) single crystal and glass to 950 GPa.

A line-imaging velocity interferometer technique for shock diagnostics without x-ray preheat limitation

A study was conducted with a line-imaging velocity interferometer on sandwich targets at the Shen Guang-III prototype laser facility in China, with the goal of eliminating the preheat effect. A sandwich target structure was used to reduce the x-ray preheat limitation (radiation temperature ~170 eV) in a radiative drive shock experiment. With a thick ablator, the preheat effect appeared before the shock arrived at the window. After adding a shield layer of high-Z material on the ablator, x-rays which penetrated the ablator were so weak that the blank-out effect could not be measured. This experiment indicates that the sandwich target may provide a valuable technique in experiments such as equation of state and shock timing for inertial confinement fusion studies.

Evidence of superdense aluminium synthesized by ultrafast microexplosion

At extreme pressures and temperatures, such as those inside planets and stars, common materials form new dense phases with compacted atomic arrangements and unusual physical properties. The synthesis and study of new phases of matter at pressures above 100 GPa and temperatures above 10(4) K--warm dense matter--may reveal the functional details of planet and star interiors, and may lead to materials with extraordinary properties. Many phases have been predicted theoretically that may be realized once appropriate formation conditions are found. Here we report the synthesis of a superdense stable phase of body-centred-cubic aluminium, predicted by first-principles theories to exist at pressures above 380 GPa. The superdense Al phase was synthesized in the non-equilibrium conditions of an ultrafast laser-induced microexplosion confined inside sapphire (α-Al(2)O(3)). Confined microexplosions offer a strategy to create and recover high-density polymorphs, and a simple method for tabletop study of warm dense matter.

Insulator-to-conducting transition in dense fluid helium

By combining diamond-anvil-cell and laser-driven shock wave techniques, we produced dense He samples up to 1.5 g/cm(3) at temperatures reaching 60 kK. Optical measurements of reflectivity and temperature show that electronic conduction in He at these conditions is temperature-activated (semiconducting). A fit to the data suggests that the mobility gap closes with increasing density, and that hot dense He becomes metallic above approximately 1.9 g/cm(3). These data provide a benchmark to test models that describe He ionization at conditions found in astrophysical objects, such as cold white dwarf atmospheres.

Achieving high-density states through shock-wave loading of precompressed samples

Materials can be experimentally characterized to terapascal pressures by sending a laser-induced shock wave through a sample that is precompressed inside a diamond-anvil cell. This combination of static and dynamic compression methods has been experimentally demonstrated and ultimately provides access to the 10- to 100-TPa (0.1-1 Gbar) pressure range that is relevant to planetary science, testing first-principles theories of condensed matter, and experimentally studying a new regime of chemical bonding.

Ab initio molecular dynamics simulations of dense boron plasmas up to the semiclassical Thomas-Fermi regime

We build an "all-electron" norm-conserving pseudopotential for boron which extends the use of ab initio molecular dynamics simulations up to 50 times the normal density rho0. This allows us to perform ab initio simulations of dense plasmas from the regime where quantum mechanical effects are important to the regime where semiclassical simulations based on the Thomas-Fermi approach are, by default, the only simulation method currently available. This study first allows one to establish, for the case of boron, the density regime from which the semiclassical Thomas-Fermi approach is legitimate and sufficient. It further brings forward various issues pertaining to the construction of pseudopotentials aimed at high-pressure studies.

Dissociation of liquid silica at high pressures and temperatures

Liquid silica at high pressure and temperature is shown to undergo significant structural modifications and profound changes in its electronic properties. Temperature measurements on shock waves in silica at 70-1,000 GPa indicate that the specific heat of liquid rises SiO(2) well above the Dulong-Petit limit, exhibiting a broad peak with temperature that is attributable to the growing structural disorder caused by bond breaking in the melt. The simultaneous sharp rise in optical reflectivity of liquid SiO(2) indicates that such dissociation causes the electrical and therefore thermal conductivities of silica to attain metalliclike values of 1-5 x 10(5) S/m and 24-600 W/m x K, respectively.

Simulations of the optical properties of warm dense aluminum

Using quantum molecular dynamics simulations, we show that the optical properties of aluminum change drastically along the nonmetal metal transition observed experimentally. As the density increases and the many-body effects become important, the optical response gradually evolves from the one characteristic of an atomic fluid to the one of a simple metal. We show that quantum molecular dynamics combined with the Kubo-Greenwood formulation naturally embodies the two limits and provides a powerful tool to calculate and benchmark the optical properties of various systems as they evolve into the warm dense matter regime.

Shock compressing diamond to a conducting fluid

Laser generated shock reflectance data show that diamond undergoes a continuous transition from optically absorbing to reflecting between Hugoniot pressures 600<P(H)<1000 GPa. The data are consistent with diamond having a thermal population of carriers at P(H) approximately 600 GPa, undergoing band overlap metallization at P(H) approximately 1000 GPa and melting at 800<P(H)<1000 GPa. The results agree well with an equation of state model that predicts that elemental carbon remains solid throughout the interior of Neptune.