The design of novel metronidazole benzoate structures: exploring stoichiometric diversity

A Metformin-Ferulic Acid Salt with Improved Biopharmaceutical Parameters

Though ferulic acid presents great hypoglycemic potential, it possesses limited aqueous solubility, and low oral bioavailability. When associated with metformin, the first-choice drug in Type 2 diabetes treatment, FA demonstrates synergistic hypoglycemic effects, however, it also causes certain undesirable dose-related effects. This study aimed to develop a new ferulic acid - metformin multicomponent system, and incorporate it into a solid dosage form with improved biopharmaceutical parameters. A novel metformin: ferulate (1:1) salt (MFS) was produced, which was properly characterized using differing analytical techniques, including single crystal analysis. Also during the course of the study, a new polymorph of the metformin free base was observed. The MFS was obtained using solvent evaporation methods, which achieved high yields in reproducible process, as well as a 740-fold increase in ferulic acid aqueous solubility. The MFS tablets developed met quality control requirements for this dosage form, as well as revealing excellent performance in vitro dissolution tests, presenting dissolution efficiency values of 95.4 ± 0.5%. Additionally, physicochemical instability was not observed in a study at 40 °C for 3 months for both MFS powder and its tablet form. The MFS product developed is a promising candidate for further Type 2 diabetes clinical study.

Metronidazole Cocrystal Polymorphs with Gallic and Gentisic Acid Accessed through Slurry, Atomization Techniques, and Thermal Methods

In this study, key features of metronidazole (MNZ) cocrystal polymorphs with gallic acid (GAL) and gentisic acid (GNT) were elucidated. Solvent-mediated phase transformation experiments in 30 solvents with varying properties were employed to control the polymorphic behavior of the MNZ cocrystal with GAL. Solvents with relative polarity (RP) values above 0.35 led to cocrystal I°, the thermodynamically stable form. Conversely, solvents with RP values below 0.35 produced cocrystal II, which was found to be only 0.3 kJ mol-1 less stable in enthalpy. The feasibility of electrospraying, including solvent properties and process conditions required, and spray drying techniques to control cocrystal polymorphism was also investigated, and these techniques were found to facilitate exclusive formation of the metastable MNZ-GAL cocrystal II. Additionally, the screening approach resulted in a new, high-temperature polymorph I of the MNZ-GNT cocrystal system, which is enantiotropically related to the already known form II°. The intermolecular energy calculations, as well as the 2D similarity between the MNZ-GAL polymorphs and the 3D similarity between MNZ-GNT polymorphs, rationalized the observed transition behaviors. Furthermore, the evaluation of virtual cocrystal screening techniques identified molecular electrostatic potential calculations as a supportive tool for coformer selection.

Cocrystals "Divorce and Marriage": When a Binary System Meets an Active Multifunctional Synthon in a Ball Mill

A well-defined and stable "AB" binary system in the presence of "C" a crystalline synthon ground in a ball mill undergoes selective transformation in the solid state according to the equation AB+C→AC+B. When the amount of C is increased two times then the equation AB+2C→AC+BC is valid. The other variants are more complex. The pathway BC+A is allowed and leads to the AC and B products. The pathway AC+B is not preferred, and no transformation is observed. These non-obvious correlations were observed for cocrystal of barbituric acid (BA):thiobarbituric acid (TBA) recently reported by Shemchuk et al. (Chem. Commun. 2016, 52, 11815-11818) in the presence of 1-hydroxy-4,5-dimethyl-imidazole 3-oxide (HIMO). This synthon shows high affinity for the BA_0.5 TBA_0.5 cocrystal as well for its individual components, BA and TBA. Single-quantum, double-quantum (SQ-DQ) 2D ¹ H very fast MAS NMR with a spinning rate of 60 kHz was employed as a basic and most diagnostic tool for the study of cocrystals transformations. Analysis of the experimental data was supported by theoretical calculations, including computation of the stabilization energy, E^stab , defined as the energy difference between the energy of a co-crystal and the sum of the energies of particular components in the respective stoichiometric ratios. Two mechanisms of synthon replacement have been proposed. Pathway 1 assumes a concerted mechanism of substitution. In this approach, synthon attack is synchronized in time with the departure of one of the components of the binary system. Pathway 2 implies a non-concerted process, with an intermediate stage in which three separate components are present. Evidence suggesting a preference for Pathway 2 is shown.