A novel ventriculoperitoneal shunt flow sensor based on electrically induced spatial variation in cerebrospinal fluid charge density

Introduction: Ventriculoperitoneal (VP) shunts divert cerebrospinal fluid (CSF) out of cerebral ventricles in patients with hydrocephalus or elevated intracranial pressure (ICP). Despite high failure rates, there exist limited clinically viable solutions for long-term and continuous outpatient monitoring of CSF flow rate through VP shunts. We present a novel, low-power method for sensing analog CSF flow rate through a VP shunt premised on induced spatial electrical charge variation. Methods: Two geometric variants of the proposed sensing mechanism were prototyped: linear wire (P1) and cylindrical (P2) electrodes. Normal saline was gravity-driven through P1 and a commercially available shunt system in series. True flow rates were measured using a high-precision analytical balance. Subsequently, artificial CSF was driven by a programmable syringe pump through P2. Flow rate prediction models were empirically derived and tested. Sensor response was also assessed during simulated obstruction trials. Finally, power consumption per flow measurement was measured. Results: P1 (17 mm long) and P2 (22 mm long) averaged 7.2% and 4.2% error, respectively, in flow rate measurement from 0.01 to 0.90 mL/min. Response curves exhibited an appreciably flattened profile during obstruction trials compared to non-obstructed states. P2 consumed 37.5 µJoules per flow measurement. Conclusion: We propose a novel method for accurately sensing CSF flow rate through a VP shunt and validate this method at the benchtop with normal saline and artificial CSF over a board range of flows (0.01-0.90 mL/min). The sensing element is highly power efficient, compact, insertable into existing shunt and valve assemblies, and does not alter CSF flow mechanics.

Electrical Impedance as a Noninvasive Metric of Quality in Allografts Undergoing Normothermic Ex Vivo Lung Perfusion

Ex vivo lung perfusion (EVLP) increases the pool of suitable organs for transplant by facilitating assessment and repair at normothermia, thereby improving identification of quality of marginal organs. However, there exists no current objective approach for assessing total organ edema. We sought to evaluate the use of electrical impedance as a metric to assess total organ edema in lungs undergoing EVLP. Adult porcine lungs (40 kg) underwent normothermic EVLP for 4 hours. To induce varying degrees of lung injury, the allografts were perfused with either Steen, a modified cell culture media, or 0.9% normal saline. Physiologic parameters (peak airway pressure and compliance), pulmonary artery and left atrial blood gases, and extravascular lung water measurements were evaluated over time. Wet-to-dry ratios were evaluated postperfusion. Modified Murray scoring was used to calculate lung injury. Impedance values were associated with lung injury scores ( p = 0.007). Peak airway pressure ( p = 0.01) and PaO 2 /FiO 2 ratios ( p = 0.005) were both significantly associated with reduced impedance. Compliance was not associated with impedance ( p = 0.07). Wet/dry ratios were significantly associated with impedance and Murray Scoring within perfusion groups of Steen, Saline, and Modified Cell Culture ( p = 0.0186, 0.0142, 0.0002, respectively). Electrical impedance offers a noninvasive modality for measuring lung quality as assessed by tissue edema in a porcine model of normothermic EVLP. Further studies evaluating the use of impedance to assess organ edema as a quality marker in human clinical models and abdominal organs undergoing ex vivo perfusion warrant investigation.

Hydrodynamic comparison of shunt and endoscopic third ventriculostomy in adult hydrocephalus using in vitro models and fluid-structure interaction simulation

OBJECTIVE

The comparison of the efficiency of shunt placement and endoscopic third ventriculostomy (ETV) in treating of adult hydrocephalus patients with various intensities and different obstruction intensities in the aqueduct of Sylvius (AS).

METHODS

In vitro models with separated ventricles were simulated and implemented for modeling shunt and ETV surgeries in one healthy subject and hydrocephalus patients with various intensities, as well as three different obstruction intensities in AS and under two cerebrospinal fluid (CSF) dynamic conditions. The fluid-structure interaction simulation was also carried out to validate in vitro results.

RESULTS

The efficiency of both methods in reducing the maximum CSF pressure in the subarachnoid space (MCPS) decreased by an increase in the patient's intensities. Contrary to shunting, the efficiency of ETV in reducing MCPS demonstrated a decline (8.3-16.4%) by an increase in obstruction levels in AS. Based on the findings, shunt efficiency in decreasing MCPS in patients with low intensity was more remarkable compared to ETV. However, ETV was more efficient than shunt in the patient with intracranial hypertension. Further, shunt placement and ETV led to a significant reduction in the amplitude of CSF pressure in the SAS (ACPS) in patients with sneezing, coughing, Valsalva maneuver, and exercising effects in contrast to other patients. Moreover, ACPS reduction was not related to the intensity of the disease in both treatment methods. In contrast to shunt, an increase in the obstruction level in AS led to a reduction in ACPS in ETV in both CSF dynamic conditions.

CONCLUSIONS

The noises from irregular disorders increased the discharging of CSF after shunt placement, and activities such as sneezing, coughing, Valsalva maneuvers, and exercising increased the risk of shunt overdrainage by 10.4~47.8%, especially in the patient with intracranial hypertension. Based on the proposed in vitro ETV and shunt models, an increase of head compliance was higher in ETV compared to the shunt. Eventually, an increase in the obstruction level of AS after ETV led to a decline in head compliance in contrast to shunt.

Piezoresistor-Embedded Multifunctional Magnetic Microactuators for Implantable Self-Clearing Catheter

Indwelling catheters are used widely in medicine to treat various chronic medical conditions. However, chronic implantation of catheters often leads to a premature failure due to biofilm accumulation. Previously we reported on the development of a self-clearing catheter by integrating polymer-based microscale magnetic actuators. The microactuator provides an active anti-biofouling mechanism to disrupt and remove adsorbed biofilm on demand using an externally applied stimulus. During an in vivo evaluation of self-clearing catheter, we realized that it is important to periodically monitor the performance of implanted microactuators. Here we integrate gold-based piezoresistive strain-gauge on our magnetic microactuators to directly monitor the device deflection with good sensitivity (0.035%/Deg) and linear range (±30°). With the integrated strain-gauge, we demonstrate the multi-functional capabilities of our magnetic microactuators that enable device alignment, flow-rate measurement, and obstruction detection and removal towards the development of chronically implantable self-clearing smart catheter.

Parylene MEMS patency sensor for assessment of hydrocephalus shunt obstruction

Neurosurgical ventricular shunts inserted to treat hydrocephalus experience a cumulative failure rate of 80 % over 12 years; obstruction is responsible for most failures with a majority occurring at the proximal catheter. Current diagnosis of shunt malfunction is imprecise and involves neuroimaging studies and shunt tapping, an invasive measurement of intracranial pressure and shunt patency. These patients often present emergently and a delay in care has dire consequences. A microelectromechanical systems (MEMS) patency sensor was developed to enable direct and quantitative tracking of shunt patency in order to detect proximal shunt occlusion prior to the development of clinical symptoms thereby avoiding delays in treatment. The sensor was fabricated on a flexible polymer substrate to eventually allow integration into a shunt. In this study, the sensor was packaged for use with external ventricular drainage systems for clinical validation. Insights into the transduction mechanism of the sensor were obtained. The impact of electrode size, clinically relevant temperatures and flows, and hydrogen peroxide (H2O2) plasma sterilization on sensor function were evaluated. Sensor performance in the presence of static and dynamic obstruction was demonstrated using 3 different models of obstruction. Electrode size was found to have a minimal effect on sensor performance and increased temperature and flow resulted in a slight decrease in the baseline impedance due to an increase in ionic mobility. However, sensor response did not vary within clinically relevant temperature and flow ranges. H2O2 plasma sterilization also had no effect on sensor performance. This low power and simple format sensor was developed with the intention of future integration into shunts for wireless monitoring of shunt state and more importantly, a more accurate and timely diagnosis of shunt failure.