Monoclonal antibody fluorescent polarisation immunoassay versus 125Iode labelled ligand radioimmunoassay for the measurement of cyclosporine concentrations in whole blood

Fluorescence properties of rhodamine 800 in whole blood and plasma

We have characterized the fluorescence spectral properties of rhodamine 800 (Rh800) in plasma and blood in order to test the possibility of making clinical fluorescence measurements in whole blood without separation steps. Rh800 was used because of its absorption at red/near-infrared wavelengths away from the absorption bands of hemoglobin. We utilized the front-face illumination and detection to minimize the effects of absorption and/or scatter during measurements. The presence of Rh800 was detected in plasma and blood using steady-state fluorescence measurements. Absorption due to hemoglobin reduced the Rh800 intensity from the blood. Fluorescence lifetime measurements in plasma and blood showed that it is possible to recover lifetime parameters of Rh800 in these media. We obtained mean lifetimes of 1.90 and 1.86 ns for Rh800 in plasma and blood, respectively. Using the recently described modulation sensing method, we quantified the concentrations of Rh800 in plasma and blood. Rh800 was detected at a concentration of as low as 2 microM in both media. High anisotropy values were obtained for Rh800 in plasma and blood using steady-state and anisotropy decay measurements, implying the tight binding of this probe to the contents of these media. This binding can be exploited to monitor the concentrations of different blood components using already existing or new red-emitting probes that will be specially designed to bind to these components with high specificity. To test this possibility of direct measurements in blood, we used Rh800 to monitor albumin in the presence of red blood cells. Increase in the polarization of Rh800 as the concentration of albumin was increased in the presence of the red cells showed the feasibility of such measurements.

Noninterchangeability of specific radioimmunoassay and monoclonal antibody fluorescent polarization immunoassay in cyclosporine measurements

This study compares cyclosporine (CsA) concentrations in whole blood from patients receiving bone marrow (n = 10), renal (n = 48), heart (n = 50) or liver (n = 50) transplants, as measured by monoclonal antibody flurorescence polarization immunoassay (FPIA) and specific 125I-radioimmunoassay (RIA). The FPIA overestimated CsA by an average of 25%. Results were higher for all indications: FPIA/RIA ratios were 1.17 for bone marrow, 1.23 for renal and 1.27 for both heart and liver transplants, and these values were significantly different from 1.0. The percentage of overestimation was higher at low CsA concentrations (< or = 100 micrograms/L) than at high CsA concentrations (> or = 400 micrograms/L). In all indications, results by both methods correlated well (r > 0.96) but slopes and intercepts were different from 1.0 and 0.0, respectively, and these parameters varied greatly between the grafted populations. These findings obtained with the two methods could not be attributed to matrix effect because the mean FPIA/RIA ratio for spiked control samples was 1.0. The discrepancy between the FPIA and RIA could be explained by the lower specificity of the monoclonal antibody contained in the FPIA kit. These results suggest that FPIA is not as accurate as RIA and that the two methods are not interchangeable in CsA level measurement.