Ventral distraction-stabilization in 5 continuous sites for the treatment of cervical spondylomyelopathy in a Great Dane

Biomechanical effects of a titanium intervertebral cage as a stand-alone device, and in combination with locking plates in the canine caudal cervical spine

Objective

To evaluate the change in ex vivo biomechanical properties of the canine cervical spine, due to an intervertebral cage, both as a stand‐alone device and in combination with plates.

Study Design

Experimental ex vivo study.

Animals

Cervical spinal segments (C5‐C7) from eight canine cadavers.

Methods

The range of motion (ROM) and elastic zone stiffness (EZS) of the spines were determined with a four‐point bending device in flexion/extension, lateral bending, and axial rotation for four conditions: native, discectomy, cage (at C6‐C7), and cage with plates (at C6‐C7). The disc height index (DHI) for each condition was determined using radiography.

Results

Discectomy resulted in overall increased ROM (p < .01) and EZS (p < .05) and decreased DHI (p < .005) when compared to the native condition. Placement of the cage increased DHI (p < .001) and restored total ROM during flexion/extension, lateral bending and axial rotation, and EZS during flexion/extension to the level of the native spine. Application of the plates further reduced the total ROM during flexion/extension (p < .001) and lateral bending (p < .001), but restored ROM in extension and EZS during lateral bending. No implant failure, subsidence, or significant cage migration occurred during loading.

Conclusion

An anchorless intervertebral cage used as a stand‐alone device was able to restore the disc height and spinal stability to the level of the native cervical spine, whereas the addition of plates further reduced the spinal unit mobility.

Clinical Significance

This study implies that the intervertebral cage may be used as a stand‐alone device in the spinal unit fixation in the canine cervical spine.

Surgical management and long-term outcome of dogs with cervical spondylomyelopathy with an anchored intervertebral titanium device

OBJECTIVE

To assess the short- and long-term outcome of an anchored intervertebral titanium device (C-LOX) for the treatment of 10 dogs with disc-associated cervical spondylomyelopathy (DACSM) and 1 dog with osseous-associated cervical spondylomyelopathy.

DESIGN

Retrospective case series.

METHODS

Dogs were included if they were diagnosed with either DACSM or osseous-associated cervical spondylomyelopathy via myelography with or without advanced imaging and underwent surgical distraction and stabilisation of the affected intervertebral disc with a C-LOX implant. Assessment included short-term neurological outcome, radiography immediately and 6 weeks' postsurgery, owner questionnaire and veterinary clinical assessment.

RESULTS

The mean follow-up time was 12 months. Improvement in neurological status was noted in 10 of 11 dogs. Screw loosening or subsidence occurred in five dogs. Revision surgery was performed in two dogs due to implant fracture (n = 1) and recurrence of spinal cord compression due to endplate subsidence around the implant (n = 1). Adjacent segment disease occurred in three dogs (30%) with DACSM at a mean of 11 months postsurgery.

CONCLUSION

The use of the C-LOX implant for dogs with cervical spondylomyelopathy resulted in a high rate of initial neurological improvement; however, there is a moderate incidence of minor and major complications that is comparable to previously described distraction-stabilisation techniques.