Automated detection of remineralization in simulated enamel lesions with PS-OCT

Selective Ablation of Carious Lesions using an Integrated Near-IR Imaging System and a Novel 9.3-µm CO2 Laser

Previous studies have shown that reflectance imaging at wavelengths greater than 1200-nm can be used to image demineralization on tooth occlusal surfaces with high contrast and without the interference of stains. In addition, these near-IR imaging systems can be integrated with laser ablation systems for the selective removal of carious lesions. Higher wavelengths, such as 1950-nm, yield higher lesion contrast due to higher water absorption and lower scattering. In this study, a point-to-point scanning system employing diode and fiber lasers operating at 1450, 1860, 1880, and 1950-nm was used to acquire reflected light images of the tooth surface. Artificial lesions were imaged at these wavelengths to determine the highest lesion contrast. Near-IR images at 1880-nm were used to demarcate lesion areas for subsequent selective carious lesion removal using a new compact air-cooled CO₂ laser prototype operating at 9.3-µm. The highest lesion contrast was at 1950-nm and the dual NIR/CO₂ laser system selectively removed the simulated lesions with a mean loss of only 12-µm of sound enamel.

Infrared Methods for Assessment of the Activity of Natural Enamel Caries Lesions

New diagnostic methods are needed for the accurate assessment of caries lesion activity to establish the need for surgical treatment. Detection of the highly mineralized surface layer that forms near the surface of the lesions as a result of remineralization is important for diagnosis of the lesion activity. Previous studies have demonstrated that novel imaging methods can be used to detect remineralization of artificial enamel caries lesions. In this paper, the activity of natural enamel caries lesions was assessed in-vitro via detection of the surface layer with PS-OCT and dehydration rate measurements with NIR reflectance and thermal imaging modalities. An automated approach for detecting the surface layer with PS-OCT yielded high sensitivity (= 0.79) and high specificity (= 0.93) with moderate correlation (R2 = 0.5920) with histology. Significant differences in dehydration rate measurements were found between the active and the arrested lesions using both the NIR reflectance and thermal imaging modalities. These results demonstrate that these novel imaging methods are ideally suited for nondestructive, noninvasive and quantitative measurement of lesion activity during a single clinical examination in real-time.

Assessment of remineralization via measurement of dehydration rates with thermal and near-IR reflectance imaging

OBJECTIVES

Previous studies have demonstrated that the optical changes due to the loss of water from porous lesions can be exploited to assess lesion severity with QLF, thermal and near-IR imaging. Since arrested lesions are less permeable to water due to the highly mineralized surface layer, changes in the rate of water loss can be related to changes in lesion structure. The purpose of this study was to investigate whether the rate of water loss correlates with the degree of remineralization and whether that rate can be measured using thermal and near-IR reflectance imaging.

METHODS

Artificial bovine enamel lesions (n=30) were prepared by immersion in a demineralization solution for either 8 and 24 h and they were subsequently placed in an acidic remineralization solution for different periods. The samples were dehydrated using an air spray for 30s and surfaces were imaged using a thermal camera and an InGaAs camera at 1300-1700 nm wavelengths.

RESULTS

The area enclosed by the time-temperature curve, ΔQ, from thermal imaging showed significant differences (P<0.05) between the lesion window and other windows. Near-IR reflectance intensity differences, ΔI, before and after dehydration decreased with longer periods of remineralization. Only near-IR reflectance imaging was capable of detecting significant differences (P<0.05) between the different periods of remineralization.

CONCLUSIONS

This study demonstrated that both thermal and near-IR reflectance imaging were suitable for the detection of remineralization in simulated caries lesions and near-IR wavelengths longer than 1400 nm are well suited for the assessment of remineralization.

Automated assessment of the remineralization of artificial enamel lesions with polarization-sensitive optical coherence tomography

Accurate measurement of the highly mineralized transparent surface layer that forms on caries lesions is important for diagnosis of the lesion activity because chemical intervention can slow or reverse the caries process via remineralization. Previous in-vitro and in-vivo studies have demonstrated that polarization-sensitive optical coherence tomography (PS-OCT) can nondestructively image the subsurface lesion structure and the highly mineralized transparent surface zone of caries lesions. The purpose of this study was to develop an approach to automatically process 3-dimensional PS-OCT images and to accurately assess the remineralization process in simulated enamel lesions. Artificial enamel lesions were prepared on twenty bovine enamel blocks using two models to produce varying degree of demineralization and remineralization. The thickness of the transparent surface layer and the integrated reflectivity of the subsurface lesion were measured using PS-OCT. The automated transparent surface layer detection algorithm was able to successfully detect the transparent surface layers with high sensitivity ( = 0.92) and high specificity ( = 0.97). The estimated thickness of the transparent surface layer showed a strong correlation with polarized light microscopy (PLM) measurements of all regions (R(2) = 0.90). The integrated reflectivity, ΔR, and the integrated mineral loss, ΔZ, showed a moderate correlation (R(2) = 0.32). This study demonstrates that PS-OCT can automatically measure the changes in artificial enamel lesion structure and severity upon exposure to remineralization solutions.