Selective removal of demineralized enamel using a CO2 laser coupled with near-IR reflectance imaging

Effects of 9,300 nm Carbon Dioxide Laser on Dental Hard Tissue: A Concise Review

A carbon dioxide laser at 9,300 nm has a high absorption affinity for water and a shallow depth of penetration. It can be used for soft tissue surgery and hemostasis. Besides, it matches well with the absorption characteristic of hydroxyapatite in enamel and dentine. Therefore, the laser possesses a great ability for energy transfer to dental hard tissues. It has a low risk of thermo-damage to the dentine-pulp complex because it has a shallow depth of heat absorption. Hence, the laser is safe for dental hard tissue preparation. A carbon dioxide laser at 9,300 nm can effectively alter the chemical structure of teeth. It increases the ratio of calcium to phosphorus and converts the carbonated hydroxyapatite to the purer hydroxyapatite of enamel and dentine. It can alter the surface morphology of a tooth through surface melting, fusion, and ablation of dentine and enamel. At higher power, it removes caries lesions. It can enhance the success of restoration by increasing the bond strength of dental adhesives to the dentine and enamel. A carbon dioxide laser at 9,300 nm can also be used with fluoride for caries prevention. The advancement of technology allows the laser to be delivered in very short pulse durations and high repetition rates (frequency). Consequently, the laser can now be used with high peak power. The objective of this review is to discuss the effects and potential use of a 9,300 nm carbon dioxide laser on dental hard tissue.

Near-IR image-guided laser ablation of demineralization on tooth occlusal surfaces

INTRODUCTION

Studies have shown that reflectance images at near-IR wavelengths coincident with higher water absorption are well-suited for image-guided laser ablation of carious lesions since the contrast between sound and demineralized enamel is extremely high and interference from stains is minimized. The objective of this study was to demonstrate that near-IR reflectance images taken at a wavelength range of 1,500-1,700 nm can be used to guide a 9.3 μm CO(2) laser for the selective ablation of early demineralization on tooth occlusal surfaces.

METHODS

The occlusal surfaces of ten sound human molars were used in this in vitro study. Shallow simulated caries lesions with random patterns and varying depth and position were produced on tooth occlusal surfaces. Sequential near-IR reflectance images at 1,500-1,700 nm were used to guide the laser for the selective removal of the demineralized enamel. Digital microscopy and polarization sensitive optical coherence tomography (PS-OCT) were used to assess selectivity.

RESULTS

Images taken before and after lesion removal suggest that the demineralized areas were removed with high selectivity. Although the estimated volume of tissue ablated was typically higher than the initial lesion volume measured with PS-OCT, the volume of enamel removed by the laser correlated well with the initial lesion volume.

CONCLUSION

Sequential near-IR reflectance images at 1,500-1,700 nm can be used to guide a 9.3 μm CO(2) laser for the selective ablation of early demineralization on tooth occlusal surfaces.