ACTION OF AN INTERMITTENT BEAM OF RADIANT HEAT UPON GASEOUS MATTER

Photoacoustic imaging of occlusal incipient caries in the visible and near-infrared range

Purpose

This study aimed to demonstrate the presence of dental caries through a photoacoustic imaging system with visible and near-infrared wavelengths, highlighting the differences between the 2 spectral regions. The depth at which carious tissue could be detected was also verified.

Materials and Methods

Fifteen permanent molars were selected and classified as being sound or having incipient or advanced caries by visual inspection, radiography, and optical coherence tomography analysis prior to photoacoustic scanning. A photoacoustic imaging system operating with a nanosecond pulsed laser as the light excitation source at either 532 nm or 1064 nm and an acoustic transducer at 5 MHz was developed, characterized, and used. En-face and lateral (depth) photoacoustic signals were detected.

Results

The results confirmed the potential of the photoacoustic method to detect caries. At both wavelengths, photoacoustic imaging effectively detected incipient and advanced caries. The reconstructed photoacoustic images confirmed that a higher intensity of the photoacoustic signal could be observed in regions with lesions, while sound surfaces showed much less photoacoustic signal. Photoacoustic signals at depths up to 4 mm at both 532 nm and 1064 nm were measured.

Conclusion

The results presented here are promising and corroborate that photoacoustic imaging can be applied as a diagnostic tool in caries research. New studies should focus on developing a clinical model of photoacoustic imaging applications in dentistry, including soft tissues. The use of inexpensive light-emitting diodes together with a miniaturized detector will make photoacoustic imaging systems more flexible, user-friendly, and technologically viable.

Photoacoustic-Based Gas Sensing: A Review

The use of the photoacoustic effect to gauge the concentration of gases is an attractive alternative in the realm of optical detection methods. Even though the effect has been applied for gas sensing for almost a century, its potential for ultra-sensitive and miniaturized devices is still not fully explored. This review article revisits two fundamentally different setups commonly used to build photoacoustic-based gas sensors and presents some distinguished results in terms of sensitivity, ultra-low detection limits, and miniaturization. The review contrasts the two setups in terms of the respective possibilities to tune the selectivity, sensitivity, and potential for miniaturization.

Applications of Near Infrared Photoacoustic Spectroscopy for Analysis of Human Respiration: A Review

In this review, applications of near-infrared photoacoustic spectroscopy are presented as an opportunity to evaluate human respiration because the measurement of breath is fast, intact and simple to implement. Recently, analytical methods for measuring biomarkers in exhaled air have been extensively developed. With laser-based photoacoustic spectroscopy, volatile organic compounds can be identified with high sensitivity, at a high rate, and with very good selectivity. The literature review has shown the applicability of near-infrared photoacoustic spectroscopy to one of the problems of the real world, i.e., human health. In addition, the review will consider and explore different breath sampling methods for human respiration analysis.

[Photoacoustic monitoring of chorioretinal complex during laser coagulation of ocular fundus]

The effect of laser treatment on ocular fundus tissues depends on quite a number of factors, mostly uncontrollable, hence, laser output parameters may vary dramatically even within the same fundus. In classical procedure ('threshold' laser coagulation), these parameters are adjusted to ophthalmoscopically visible tissue color changes at the site of coagulation. However, this method does not work with modern subthreshold techniques, that are more tissue-saving and thus, produce no immediate and visible changes in the retina. Calculation methods that are used instead are much less accurate. Photoacoustic monitoring may become a real breakthrough in this field. The method involves acoustic analysis of the response to soft and short laser pulses ('test' pulses). Heating of the target by the main therapeutic laser causes alterations in its physical properties and, consequently, the laser-induced acoustic signal. This gives us an ability to monitor the temperature and thus, to evaluate the clinical effect of coagulation despite the absence of visible changes at the site. The most promising techniques of photoacoustic monitoring that are being developed are discussed here.