Nutrients recovery from livestock wastewater by batch and gas bubble-column studies with biochar, nano-composite material, and ammonium magnesium phosphate hydrate

The breeding of livestock raises substantial environmental concerns, especially the efficient management of nutrients and pollution. This research is designed to assess the potency of char and modified char in diluting nutrient concentrations in livestock wastewater. The characteristics of graphene oxide, struvite, and calcium-modified char were inspected, defining their efficacy in both batch and bed-column investigations of nutrient sorption. Various factors, including sorption capacity, time of contact, ion levels, a decrease in ion levels over time, and sorption kinetics, have been considered, along with their appropriateness for respective models. The first evaluation of the options concluded that 600 °C char was better since it exhibited higher removal efficiency. Modified char sorption data at 600 °C was used to adjust the models "PSOM, Langmuir", and "Thomas". The models were applied to both batch and bed-column experiments. The maximum phosphate sorption was 110.8 mg/g, 85.73 mg/g, and 82.46 mg/g for B-GO, B-S, and B-C modified chars respectively, in the batch experiments. The highest phosphate sorption in column experiments, at a flow rate of 400 μl/min, was 51.23 mg per 10 g of sorbent. This corresponds to a sorption rate of 5.123 mg/g. B-GO and B-S modified chars showed higher sorption capacities; this was observed in both the batch and bed-column studies. This displayed the capability of graphene oxide and struvite-modified chars for efficient ion and nutrient uptake, whether in single or multi-ion environments, making them a very good candidate for nutrient filtration in livestock wastewater treatment. Additionally, B-GO char enhanced the sorption of phosphate, resulting in augmented seed germination and seedling growth. These results reveal that B-GO char can be used as a possible substitute for chemical fertilizers.

An Update on Graphene Oxide: Applications and Toxicity

Graphene oxide (GO) has attracted much attention in the past few years because of its interesting and promising electrical, thermal, mechanical, and structural properties. These properties can be altered, as GO can be readily functionalized. Brodie synthesized the GO in 1859 by reacting graphite with KClO3 in the presence of fuming HNO3; the reaction took 3-4 days to complete at 333 K. Since then, various schemes have been developed to reduce the reaction time, increase the yield, and minimize the release of toxic byproducts (NO2 and N2O4). The modified Hummers method has been widely accepted to produce GO in bulk. Due to its versatile characteristics, GO has a wide range of applications in different fields like tissue engineering, photocatalysis, catalysis, and biomedical applications. Its porous structure is considered appropriate for tissue and organ regeneration. Various branches of tissue engineering are being extensively explored, such as bone, neural, dentistry, cartilage, and skin tissue engineering. The band gap of GO can be easily tuned, and therefore it has a wide range of photocatalytic applications as well: the degradation of organic contaminants, hydrogen generation, and CO2 reduction, etc. GO could be a potential nanocarrier in drug delivery systems, gene delivery, biological sensing, and antibacterial nanocomposites due to its large surface area and high density, as it is highly functionalized with oxygen-containing functional groups. GO or its composites are found to be toxic to various biological species and as also discussed in this review. It has been observed that superoxide dismutase (SOD) and reactive oxygen species (ROS) levels gradually increase over a period after GO is introduced in the biological systems. Hence, GO at specific concentrations is toxic for various species like earthworms, Chironomus riparius, Zebrafish, etc.

Influence of Solvents on the Electroactivity of PtAl/rGO Catalyst Inks and Anode in Direct Ethanol Fuel Cell

This paper presents research on the effects of common solvents such as n-butyl acetate, isopropanol, and ethanol on the properties and electroactivity of catalyst ink based on PtAl/rGO. The inks prepared by mixing PtAl/rGO catalyst, Nafion solution (5 wt%), and solvent were coated on carbon cloth by the spin coating method. The results obtained showed that ethanol was the most suitable solvent for the preparation of catalyst ink with a volume ratio between catalyst slurry and solvent of 1 : 1 (CI-EtOH (1/1) ink). The surface of the CI-EtOH (1/1) coated electrode was smooth, flat, and even and had no cracks due to the increase of Nafion mobility, resulting in significant improvement in the interaction between Pt particles and ionomer. Moreover, the electrochemical activity of the CI-EtOH (1/1) ink in ethanol electrooxidation reaction, in both acidic and alkaline media, has the highest value, with the forward current density, IF, reaching 1793 mA mgPt−1 and 4751 mA mgPt−1, respectively. In the application in direct ethanol fuel cell (DEFC), the CI-EtOH ink-coated anode also exhibited the highest power density in both PEM-DEFC (with a proton exchange membrane) and AEM-DEFC (with an anion exchange membrane) at 19.10 mW cm−2 and 27.07 mW cm−2, respectively.

Green Synthesis Characterization and Thermotropic Behaviour of O-Linked Glycopyranosides of Phenolic Esters

Focusing on green chemistry protocols, a series of carbohydrate derivatives (5a–l) have been synthesized by Fischer glycosylation of α-D-glucose, D-xylose, and α-maltose with several nonpolar phenolic ester aglycones (3a–d) derived from menthol by employing solid-supported Si-H+ as the catalyst. In order to study the extent of mesomorphism in target molecules, the thermotropic behaviour has been studied by using the thermoanalytic DSC/TGA technique and polarized optical microscope. Phase transitions in the DSC thermograms of 5a–l with two endothermic melting point peaks and various exothermic crystalline transitions exhibits the existence of mesophases. However, optical photomicrographs revealed that the new glycopyranosides formed smectic A phases. Moreover, all the compounds (3a–d and 5a–l) were confirmed by FTIR and 1H NMR.