How to measure the effects of fluoride treatments in clinical trials? Assessment: modern versus traditional methods

Improving Clinical Visual Detection—Potential for Caries Clinical Trials

It has been the norm in caries clinical trials to measure caries increment by several different caries-recording systems, including the crude DMF-S/T index. However, there is a reserved attitude as to whether to subdivide the non-cavitated lesions and use arrested lesions in clinical trials. This has been due to the belief that it is not possible to achieve reliable data of the early stages of the disease (Radike, 1972). However, recently, Ekstrand et al. (1997, 1998) showed that it was possible: (1) to differentiate between different stages of non-cavitated occlusal lesions, (2) to differentiate between active and inactive occlusal lesions, and (3) to predict the depth of the lesion. In at least 4 other clinical studies, the reproducibility of recording initial active lesions, cavitated active lesions, and arrested lesions was found to be adequate (Carvalho et al., 1989; Nyvad et al, 1999; Ekstrand et al., 2000; Machiulskiene et al., 2001). Since caries today is a more slowly developing disease in many countries in the world, this will result in prolongation of the duration of the clinical trial, which will increase the costs. As indicated above, there is now sufficient evidence that caries can be clinically diagnosed accurately and reliably in earlier stages as well as in an arrested stage. If such stages of caries are used as outcome variables in caries clinical trials, they may have a positive influence on the trials’ duration and costs.

The efficacy of laser fluorescence to detect in vitro demineralization and remineralization of smooth enamel surfaces

OBJECTIVE

The purpose of this study was to evaluate the efficacy of the laser fluorescence (LF) device in detecting in vitro demineralization and remineralization of smooth surface caries-like lesions.

BACKGROUND DATA

The early detection of smooth surface caries-like lesions is important to provide proper management of carious lesions, and allows monitoring of them over time. Also, some authors suggest that LF could be useful in monitoring the caries pathological process.

MATERIALS AND METHODS

Seventy-eight blocks of bovine teeth were obtained, and then submitted to artificial caries lesion induction and to a pH-cycling process. Superficial microhardness (SMH) and laser fluorescence analysis were performed at baseline, after induction of caries-like lesions, and after the pH-cycling regimen to promote remineralization.

RESULTS

Friedman's and multiple comparison tests were performed for all variables. SMH analysis showed significant differences (p +/- 0.05) between baseline (286.77 +/- 1.49 Vickers hardness number [VHN] units), before (38.48 +/- 0.85 VHN), and after remineralization (131.93 +/- 2.63 VHN). Baseline values for LF were extremely low (2.71 +/- 0.05), and a statistically significant difference was observed only after remineralization (3.61 +/- 0.08), as demonstrated by the increase in LF values.

CONCLUSION

The LF device did not show efficacy for monitoring in vitro demineralization and remineralization of smooth enamel surfaces.

Caries Detection Methods Based on Changes in Optical Properties between Healthy and Carious Tissue

A conservative, noninvasive or minimally invasive approach to clinical management of dental caries requires diagnostic techniques capable of detecting and quantifying lesions at an early stage, when progression can be arrested or reversed. Objective evidence of initiation of the disease can be detected in the form of distinct changes in the optical properties of the affected tooth structure. Caries detection methods based on changes in a specific optical property are collectively referred to as optically based methods. This paper presents a simple overview of the feasibility of three such technologies for quantitative or semiquantitative assessment of caries lesions. Two of the techniques are well-established: quantitative light-induced fluorescence, which is used primarily in caries research, and laser-induced fluorescence, a commercially available method used in clinical dental practice. The third technique, based on near-infrared transillumination of dental enamel is in the developmental stages.

Ability of laser fluorescence device associated with fluorescent dyes in detecting and quantifying early smooth surface caries lesions

A laser fluorescence (LF) device is a portable tool, but it does not measure minor mineral changes. Our in vitro study aim is to propose the association of an LF with two fluorescent dyes and to evaluate the performance in detecting and quantifying early demineralization. Artificial caries lesions are created in 40 primary canine teeth using a demineralizing solution (pH=4.8) for 12, 24, 48, and 96 h. LF measurements are performed with DIAGNOdent after demineralization in these samples and in 20 sound primary teeth. Measurements with LF with 0.2-mM tetrakis(N-methylpyridyl)porphyrin (LF TMPyP) and with 4-mM protoporphyrin IX (LF PPIX) are made. The amount of calcium loss is determined by atomic emission spectrometry. A correlation between LF and LF with dyes and mineral loss and receiver operating characteristics analysis are performed, as well as comparisons of sensitivity, specificity, and accuracy values. Significant correlation is obtained with LF TMPyP and mineral loss of lesions demineralized for 24, 48, and 96 h. Better performance is achieved with LF TMPyP for all parameters than with LF alone. LF PPIX does not present good results. In conclusion, LF TMPyP provides good performance in detecting and quantifying very early enamel caries lesions.

Remineralisation study of artificial root caries lesions after fluoride treatment. An in vitro study using Electric Caries Monitor and Transversal Micro-Radiography

AIMS

To evaluate and compare remineralisation of root caries lesions after in vitro treatment with various fluoride (F) agents using an Electric Caries Monitor (ECM) and Transversal Micro-Radiography (TMR).

MATERIALS

Permanent human teeth were extracted and root surface specimens were sectioned, prepared (n = 35), and randomly allocated into seven different experimental groups (groups 1-7).

METHODS

Root surfaces were demineralised in an acidified gel (pH = 5.0) for 3 weeks followed by various F treatments and stored in a standardised remineralising solution at 37 degrees C for 6 weeks. The root surfaces were treated twice daily with different dentifrice slurries for 2 min, either with a neutral placebo dentifrice without F (group 5); or a neutral sodium fluoride (NaF) 1400 p.p.m. F dentifrice (group 1); or a neutral 1250 p.p.m. F dentifrice (group 6); or an acid dentifrice (pH 4.7) with 1400 p.p.m. F containing amine fluoride (AmF) (groups 3 and 4) or a 1250 p.p.m. (pH 4.7) AmF dentifrice (group 6). In groups 1, 2, 5, 6, and 7, the root surfaces were additionally rinsed for 2 min with a neutral non-F placebo solution. In groups 3 and 4, rinsing were performed for 2 min with an acid (pH 4.7) 250 p.p.m. F solution, containing 125 p.p.m. F as AmF and 125 p.p.m. F as potassium fluoride (KF), once or twice per day respectively. ECM was used to measure electrical resistance on root surfaces at baseline and after 3 and 6 weeks respectively. TMR technique was used to measure and compare root surface lesion depths and mineral loss.

RESULTS

Six weeks daily treatment with a dentifrice slurry containing AmF followed by rinsing with a combination of equal amounts of AmF and KF solution twice a day showed a statistical significant higher ECM values compared with the other groups. TMR data measuring lesion depths and mineral loss reduction supported the results of the ECM findings.

CONCLUSIONS

Daily application of a dentifrice slurry containing 1400 p.p.m. F as AmF combined with twice daily rinsing with a 250 p.p.m. F solution containing equal amount of AmF and KF significantly remineralise primary root caries lesions in vitro. ECM and TMR are valuable complementary methods in order to analyse the remineralisation processes.

Effects of Drying Time and the Presence of Plaque on the in vitro Performance of Laser Fluorescence in Occlusal Caries of Primary Teeth

The diode laser fluorescence device was introduced to diagnose caries lesions in occlusal and smooth surfaces. Despite promising results, much variation has been found in the protocol of utilization. The goal of this study was to evaluate the influence of dental plaque and drying time on the laser fluorescence (DIAGNOdent) performance in occlusal sites of primary molars. For the drying time study, 63 suspected occlusal sites in primary molars were used. The same sites were evaluated in four different conditions: (1) moist teeth, (2) teeth dried for 3 s with a 3-in-1 syringe, (3) teeth dried for 15 s, and (4) dehydrated teeth. For the plaque experiment, we selected 28 occlusal sites. After the baseline laser fluorescence readings, plaque collected from children was placed on the suspected site. New laser fluorescence measurements were performed. For both studies, we compared the laser fluorescence values, as well as sensitivity, specificity, accuracy, and area under ROC curve. For different drying times, the more dehydrated the teeth, the higher the values. Nevertheless, the performance of the method did not change significantly, except for dehydrated teeth. In the presence of plaque, the laser fluorescence values were reduced, and the evaluated parameters were worse than with no plaque. In conclusion, the hydration state of the teeth did not change the results significantly, but the presence of plaque worsened the performance of the laser fluorescence method.