Functionalization effects on the electrical properties of multi-walled carbon nanotube-polyacrylamide composites

Notable electrical and mechanical properties of polyacrylamide (PAM) with graphene oxide (GO) and single-walled carbon nanotubes (SWCNTs)

In the present investigation, a polyacrylamide (PAM) – graphene oxide (GO)-single-walled carbon nanotubes (SWNTs) composite has been prepared through a cost effective solution cast method and physical properties (electrical and mechanical) measurements have been carried out. The GO sheets contain oxygen functional groups which enhance the interfacial adhesion with the polymer matrix, while the SWNTs act as wires joining the GO together in the composite matrix. This interconnected network creates a conducting path, lowering film resistance and improving PAM films’ electrical, mechanical, and thermal properties. Raman study demonstrated that carbon nanofiller (SWNTs, GO) and polymer PAM have good interfacial bonding. The electrical conductivity and mechanical characteristics (hardness and elastic modulus) of these composite films were enhanced at a loading of 15 wt% GO and 15 wt% SWNTs in PAM matrix. Electrical conductivity of GO (15 wt%) – SWNTs (15 wt%)-PAM composite film was found to be 2.8 × 10−2 S/cm, which is five orders of magnitude higher than that of the PAM polymer. In comparison to pure PAM polymer, the elastic modulus and hardness are found to be 1.14 and 65 times higher, respectively.

Dichlorobenzene: an effective solvent for epoxy/graphene nanocomposites preparation

It is generally recognized that dimethylformamide (DMF) and ethanol are good media to uniformly disperse graphene, and therefore have been used widely in the preparation of epoxy/graphene nanocomposites. However, as a solvent to disperse graphene, dichlorobenzene (DCB) has not been fully realized by the polymer community. Owing to high values of the dispersion component (δ_d) of the Hildebrand solubility parameter, DCB is considered as a suitable solvent for homogeneous graphene dispersion. Therefore, epoxy/graphene nanocomposites have been prepared for the first time with DCB as a dispersant; DMF and ethanol have been chosen as the reference. The colloidal stability, mechanical properties, thermogravimetric analysis, dynamic mechanical analysis and scanning electron microscopic images of nanocomposites have been obtained. The results show that with the use of DCB, the tensile strength of graphene has been improved from 64.46 to 69.32 MPa, and its flexural strength has been increased from 97.17 to 104.77 MPa. DCB is found to be more effective than DMF and ethanol for making stable and homogeneous graphene dispersion and composites.

Ti3C2Tx(MXene)–polyacrylamide nanocomposite films

Herein we report on the synthesis and characterization of MXene–polyacrylamide (PAM) nanocomposite films. The as-prepared composites are flexible and the conductivity was increased significantly to 3.3 × 10⁻²S m⁻¹with only 6 wt% MXene loading.