Enhancement effect of an ethanol/Panasate 800 binary vehicle on anti-inflammatory drug permeation across excised hairless mouse skin

Mucosal Delivery of Cannabidiol: Influence of Vehicles and Enhancers

In this study, the mucosal permeation and deposition of cannabidiol (CBD) with neat and binary vehicles were investigated. Permeation experiments were performed using static diffusion cells coupled with fresh porcine esophageal mucosa. The CBD-vehicle solutions were applied at a fixed dose (~5 mg/cm²), and the corresponding permeation parameters were calculated. In neat vehicles, the permeation flux (J_ss) ranged from 0.89 ± 0.15 to 179.81 ± 23.46 µg·cm^-2·h^-1, while the CBD deposition ranged from 11.5 ± 1.8 to 538.3 ± 105.3 μg·cm^-2. Propylene glycol (PG) and diethylene glycol monoethyl ether (DEGEE) yielded the highest permeability (P_s) and CBD deposition, while medium-chain triglycerides (MCT) yielded the lowest P_s and deposition. This was due to the difference in apparent partition coefficient (K), which is related to the solubility of CBD in the vehicle. The PG:DEGEE binary vehicle boosted J_ss (1.5-1.6 fold) and deposition (2.0-2.7 folds) significantly, compared to neat DEGEE. The combination of DEGEE with MCT dramatically enhanced J_ss (11-44 fold) and deposition (1.6-4.7 fold). The addition of lipophilic enhancers, laurocapram, and oleic acid, to PG:DEGEE and DEGEE:MCT vehicles significantly reduced J_ss (0.3-0.7 fold) and deposition (0.4-0.8 fold) while nerolidol had no effect. These permeation reductions were found to be related to modification of the K and/or diffusivity values. This study provides useful basic information for the development of CBD formulations intended for transmucosal delivery.

Optimization of ibuprofen gel formulations using experimental design technique for enhanced transdermal penetration

The aims of this study were to develop a transdermal gel formulation for ibuprofen using experimental design techniques and to evaluate its pharmacokinetic properties. The three factors chosen for factorial design were the concentrations of drug, polyoxyethylene(5)cetyl/oleyl ether and ethanol and the levels of each factor were low, medium and high. Skin permeation rates and lag times of ibuprofen were evaluated using the Franz-type diffusion cell in order to optimize the gel formulation. The permeation rate of ibuprofen significantly increased in proportion to the drug concentration, but significantly decreased in proportion to POE(5)cetyl/oleyl ether concentration. Ethanol concentration was inversely proportional to the lag time. The pharmacokinetic properties of the optimized formulation were compared with those of two marketed products in rats. The relative bioavailability of ibuprofen gel compared to the two marketed products was 228.8% and 181.0%. In conclusion, a transdermal ibuprofen gel was formulated successfully using the technique of experimental design and these results helped in finding the optimum formulation for transdermal drug release.

The use of complexation with alkanolamines to facilitate skin permeation of mefenamic acid

The preparation of mefenamic acid (MH)-alkanolamine [monoethanolamine, diethanolamine, triethanolamine and propanolamine] complexes was attempted to increase the transdermal flux of MH. A lipophilic enhancer system consisting of isopropyl myristate (IPM) and ethanol (9:1; EI system) produced a marked enhancement of MH flux from the alkanolamine complexes through hairless rat skin membrane. Among the alkanolamines examined, the propanolamine complex had the greatest enhancing effect on the permeation of MH. The observed permeation enhancement of MH-alkanolamine complexes by the EI system was explained by an analysis based on a two-layer diffusion model. The stratum corneum immersed in IPM forms a continuous phase of vehicle and stratum corneum and, from the phase, ethanol transport the MH-alkanolamine complexes to the epidermis and dermis, and the complexes, which are more water soluble than MH, exhibit increased partition into the epidermis and dermis, as the flux increases.