A phantom study for ground-glass nodule detectability using chest digital tomosynthesis with iterative reconstruction algorithm by ten observers: association with radiation dose and nodular characteristics

Tomosynthesis in pediatrics: a retrospective of its application in the world practice and own data

Tomosynthesis is a modern effective and informative method of low-dose X-ray diagnostics, which allows obtaining a significant number of layered images with the subsequent volumetric image reconstruction. The use of tomosynthesis provides a one-time examination of a large anatomical area without loss of the image quality and diagnostics of difficult-to-visualize pathological changes that are not detected by digital radiography. The article presents an overview of the problem of improving low-dose imaging options in the radiation diagnostics, as well as the authors own data on the use of tomosynthesis for the diagnosis of community-acquired pneumonia in children.

Improved digital chest tomosynthesis image quality by use of a projection-based dual-energy virtual monochromatic convolutional neural network with super resolution

We developed a novel dual-energy (DE) virtual monochromatic (VM) very-deep super-resolution (VDSR) method with an unsharp masking reconstruction algorithm (DE–VM–VDSR) that uses projection data to improve the nodule contrast and reduce ripple artifacts during chest digital tomosynthesis (DT). For estimating the residual errors from high-resolution and multiscale VM images from the projection space, the DE–VM–VDSR algorithm employs a training network (mini-batch stochastic gradient-descent algorithm with momentum) and a hybrid super-resolution (SR) image [simultaneous algebraic reconstruction technique (SART) total-variation (TV) first-iterative shrinkage–thresholding algorithm (FISTA); SART–TV–FISTA] that involves subjective reconstruction with bilateral filtering (BF) [DE–VM–VDSR with BF]. DE-DT imaging was accomplished by pulsed X-ray exposures rapidly switched between low (60 kV, 37 projection) and high (120 kV, 37 projection) tube-potential kVp by employing a 40° swing angle. This was followed by comparison of images obtained employing the conventional polychromatic filtered backprojection (FBP), SART, SART–TV–FISTA, and DE–VM–SART–TV–FISTA algorithms. The improvements in contrast, ripple artifacts, and resolution were compared using the signal-difference-to-noise ratio (SDNR), Gumbel distribution of the largest variations, radial modulation transfer function (radial MTF) for a chest phantom with simulated ground-glass opacity (GGO) nodules, and noise power spectrum (NPS) for uniform water phantom. The novel DE–VM–VDSR with BF improved the overall performance in terms of SDNR (DE–VM–VDSR with BF: 0.1603, without BF: 0.1517; FBP: 0.0521; SART: 0.0645; SART–TV–FISTA: 0.0984; and DE–VM–SART–TV–FISTA: 0.1004), obtained a Gumbel distribution that yielded good images showing the type of simulated GGO nodules used in the chest phantom, and reduced the ripple artifacts. The NPS of DE–VM–VDSR with BF showed the lowest noise characteristics in the high-frequency region (~0.8 cycles/mm). The DE–VM–VDSR without BF yielded an improved resolution relative to that of the conventional reconstruction algorithms for radial MTF analysis (0.2–0.3 cycles/mm). Finally, based on the overall image quality, DE–VM–VDSR with BF improved the contrast and reduced the high-frequency ripple artifacts and noise.

Low-dose chest CT and the impact on nodule visibility

INTRODUCTION

The need to continually optimise CT protocols is essential to ensure the lowest possible radiation dose for the clinical task and individual patient. The aim of this study was to explore the effect of reducing effective mAs on nodule detection and radiation dose across six scanners.

METHODS

An anthropomorphic chest phantom was scanned using a low-dose chest CT protocol, with the effective mAs lowered to the lowest permissible level. All other acquisition parameters remained consistent. Images were evaluated by five radiologists to determine their sensitivity in detecting six simulated nodules within the phantom. Image noise was calculated together with DLP.

RESULTS

The lowest possible mAs achievable ranged from 7 to 19 mAs. The two highest mAs setting (17 mAs + 19 mAs) had kV modulation enabled (100 kV instead of 120 kV) which consequently resulted in a higher nodule detection rate. Overall nodule detection averaged at 91% (range 80-97%). Out of a possible 180 nodules, 16 were missed, with 12 of those 16 being the same nodule. Noise was double for the Somatom Sensation scanner when compared to the others; however, this scanner did not have iterative reconstruction and it was installed over 10 years ago. There was a strong correlation between image noise and scanner age.

CONCLUSION

This study highlighted that nodules can be detected at very low effective mAs (<20 mAs) but only when other acquisition parameters are optimised i.e. iterative reconstruction and kV modulation. Nodule detection rates were affected by nodule location and image noise.

IMPLICATIONS FOR PRACTICE

This study consolidates previous findings on how to successfully optimise low-dose chest CT. It also highlights the difficulty with standardisation owing to factors such as scanner age and different vendor attributes.