Removal of instrument signature from mariner 9 television images of Mars

Methodology for high accuracy contact angle measurement

A new version of axisymmetric drop shape analysis (ADSA) called ADSA-NA (ADSA-no apex) was developed for measuring interfacial properties for drop configurations without an apex. ADSA-NA facilitates contact angle measurements on drops with a capillary protruding into the drop. Thus a much simpler experimental setup, not involving formation of a complete drop from below through a hole in the test surface, may be used. The contact angles of long-chained alkanes on a commercial fluoropolymer, Teflon AF 1600, were measured using the new method. A new numerical scheme was incorporated into the image processing to improve the location of the contact points of the liquid meniscus with the solid substrate to subpixel resolution. The images acquired in the experiments were also analyzed by a different drop shape technique called theoretical image fitting analysis-axisymmetric interfaces (TIFA-AI). The results were compared with literature values obtained by means of the standard ADSA for sessile drops with the apex. Comparison of the results from ADSA-NA with those from TIFA-AI and ADSA reveals that, with different numerical strategies and experimental setups, contact angles can be measured with an accuracy of less than 0.2 degrees. Contact angles and surface tensions measured from drops with no apex, i.e., by means of ADSA-NA and TIFA-AI, were considerably less scattered than those from complete drops with apex. ADSA-NA was also used to explore sources of improvement in contact angle resolution. It was found that using an accurate value of surface tension as an input enhances the accuracy of contact angle measurements.

Automated detection of BB pixel clusters in digital fluoroscopic images

Small ball bearings (BBs) are often used to characterize and correct for geometric distortion of x-ray image intensifiers. For quantitative applications the number of BBs required for accurate distortion correction is prohibitively large for manual detection. A method to automatically determine the BB coordinates is described. The technique consists of image segmentation, pixel coalescing and centroid calculation. The dependence of calculated BB coordinates on segmentation threshold was also evaluated and found to be within the uncertainty of measurement.

Digital radiotherapy simulator

We describe a prototype digital radiotherapy simulator which consists of a conventional simulator gantry, digital spot imager, and image correction and reconstruction software. The ability of the digital spot imager to acquire a diagnostic quality image directly in digital format during simulation offers unique possibilities in clinical practice. Applications include prescription of multileaf collimator, on-line patient setup verification, remote consultation and treatment planning. In addition, we discuss the possibility of using the digital simulator as a volume-CT scanner capable of obtaining three-dimensional anatomical information in a single scan.

Cone-beam CT for radiotherapy applications

Clinical implementation of cone-beam tomography has been hampered by the lack of two-dimensional electronic x-ray detectors that can encompass the full width of the body. We encountered the undersized detector problem in our development of a cone-beam CT system for radiotherapy applications. In order to mitigate the problem, we developed an algorithm which permits an increased reconstruction volume to be imaged using a detector of a given size. We describe the algorithm and report on its implementation using a radiotherapy simulator configured with a digital fluorography unit.