Improving the uniformity of holographic recording using multi-layer photopolymer: Part II. Experimental results

Holographic Grating Enhancement Induced by a Dual-Photo-Initiator System in PMMA Substrate Polymers

Polymer systems induced by the reaction between monomers and photo-initiators play a crucial role in the formation of volume-phase gratings. In this paper, we fabricated a dual-photo-initiator photopolymer by doping EY (Eosin Yellow) molecules into a TI (Titanocene, Irgacure 784@BASF) dispersed PMMA (poly-[methyl methacrylate]) substrate system, with the aim of promoting the diffusion and polymerization processes in volume holographic storage. The two-wave interference system is adopted to record a permanent grating structure in our materials. The temporal diffraction variations of photopolymerization (during the interference exposure) and dark diffusion (after the interference exposure) processes have been investigated and analyzed. Aiming to analyze the influence of EY doping ratios on holographic performances, some key parameters were examined in the experiment. We first measured the temporal evolution of diffraction efficiency, then an exponential fitting was adopted to obtain the response time. Finally, the angular selectivity was evaluated by the Bragg condition after holographic recording. Also, the temporal evolution of each component is described by the nonlocal polymerization-driven diffusion model with a dual-photo-initiator composition, theoretically. Furthermore, we experimentally achieved the holographic grating enhancement in both the dark diffusion and photopolymerization processes by doping appropriate EY concentrations, respectively. This work provides a foundation for the acceptability of TI&EY/PMMA polymers in further holographic storage research.

Theoretical design of an absorption hologram-based sensor for dose quantification in daylight photodynamic therapy

Daylight photodynamic therapy (D-PDT) is an effective and almost painless treatment for many skin conditions, where successful treatment relies on daylight activation of a topical photosensitizer. Optimization of D-PDT requires accurate assessment of light dose received. There is a requirement for a small-area sensor that can be placed adjacent to the treatment site to facilitate accurate dose quantification. Here, a novel, to the best of our knowledge, configuration for a D-PDT dose sensor, consisting of a holographic absorption grating fabricated in a photosensitive film, is presented. Theoretical modeling of the sensor's response (i.e., change in grating diffraction efficiency due to change in grating absorption modulation, α₁, on exposure to daylight) was conducted using Kogelnik's coupled-wave theory. The influence of the different grating parameters (initial film absorption, thickness, spatial frequency, and reconstruction wavelength) on the sensor response was examined and revealed that the initial absorption and grating thickness values have a large impact on both the magnitude and rate of the D-PDT sensor response. The optimum design for an absorption grating-based D-PDT sensor is described.

Holographic response characteristics influenced by an absorptive diffusion polymerization model in bulk TI/PMMAs

Dynamic formation of a volume holographic grating is mainly caused by the diffusion polymerization of a photoinitiator in TI/poly-(methyl methacrylates) (PMMAs). Here, we consider the time-dependent absorption coefficient in this material to establish an absorption modulated diffusion polymerization model. An experimental and theoretical investigation in TI/PMMAs with different sample thicknesses (1-3 mm) is presented. It is indicated that the thickness can regulate the holographic sensitivity and constancy in TI/PMMAs. Furthermore, we also examined the dark diffusion process, multiplexed gratings recording, pre-exposure holographic enhancement, and long-term full exposure in TI/PMMAs with different thicknesses to analyze their holographic sensitivity and constancy. It is predicted that, in general, the absorption characteristics in TI/PMMA can be further affected by changing its thickness, thus it is able to satisfy different requirements in high-density holographic memories.