Efficient burst mode amplifier for ultra-short pulses based on cryogenically cooled Yb³⁺:CaF₂

Matrix multi-pass scheme disk amplifier

Two multi-pass optical schemes of a disk laser amplifier have been proposed. Different variants of both the schemes with the smallest amount of optical elements and a lens in the active element taken into account have been calculated. For 64 passes of radiation through the active element, the average power of ∼50  W with ∼10% optical-to-optical efficiency in a pulse-periodic regime with a repetition rate of 10 kHz and a pulse duration of 2 ns was obtained at the amplifier output. The small signal gain amounted to 200.

100 μJ pulse energy in burst-mode-operated hybrid fiber-bulk amplifier system with envelope shaping

A theoretical method was proposed to compensate the burst envelope distortion in a solid-state master-oscillator power-amplifier (MOPA) system operating in burst mode at an intra-burst repetition rate of 40 MHz. Arbitrary envelope shapes were achieved at inter-burst repetition rate of 100 kHz with 40 pulses in the burst, showing excellent agreement with the calculated ones. This is the first demonstration of arbitrary burst envelope without an adaptive feedback loop in a solid-state laser system. The maximum pulse energy of 100 μJ was achieved at inter-burst repetition rate of 40 kHz, with 10 pulses in the burst.

100-ps-pulse-duration, 100-J burst-mode laser for kHz-MHz flow diagnostics

A high-speed, master-oscillator power-amplifier burst-mode laser with ∼100  ps pulse duration is demonstrated with output energy up to 110 J per burst at 1064 nm and second-harmonic conversion efficiency up to 67% in a KD*P crystal. The output energy is distributed across 100 to 10,000 sequential laser pulses, with 10 kHz to 1 MHz repetition rate, respectively, over 10 ms burst duration. The performance of the 100 ps burst-mode laser is evaluated and been found to compare favorably with that of a similar design that employs a conventional ∼8  ns pulse duration. The nearly transform-limited spectral bandwidth of 0.15  cm(-1) at 532 nm is ideal for a wide range of linear and nonlinear spectroscopic techniques, and the 100 picosecond pulse duration is optimal for fiber-coupled spectroscopic measurements in harsh reacting-flow environments.

100 kHz, 100 ms, 400 J burst-mode laser with dual-wavelength diode-pumped amplifiers

The burst duration of an all-diode-pumped burst-mode laser is extended to 100 ms and 100 kHz (10,000 pulses) by utilizing dual-wavelength diode pumping. Total energies of 225 J at 10 kHz and 400 J at 100 kHz are achieved during the 100 ms burst period at 1064 nm. This represents an order-of-magnitude increase in the number of pulses compared with prior work, while maintaining similar or higher pulse energies. Amplitude tailoring of each pulse is used to flatten the burst profile, reducing the standard deviation in pulse energy over the 100 ms burst from 3.7% to 2.1% with a burst-to-burst standard deviation of 0.8%.

Pulse bursts with a controllable number of pulses from a mode-locked Yb-doped all fiber laser system

Pulse bursts with a controllable number of pulses per burst have been produced directly from a mode-locked Yb-doped fiber laser for the first time. Each output burst contained numerous pulses with a high pulse repetition rate of 29.4 MHz. The duration of a single pulse was 680 ps. The pulse burst had a repetition rate of 251.6 kHz. The pulse burst could easily be further amplified to a total pulse burst energy of ~795 nJ, corresponding to a total average power of 200 mW.