A study on the optics of copper indium gallium (di)selenide (CIGS) solar cells with ultra-thin absorber layers

Optical Design of Textured Thin-Film CIGS Solar Cells with Nearly-Invisible Nanowire Assisted Front Contacts

The conductivity of transparent front contacts can be improved by patterned metallic nanowires, albeit at the cost of optical loss. The associated optical penalty can be strongly reduced by texturization of the cell stack. Remarkably, the nanowires themselves are not textured and not covered in our design. This was shown by optical modeling where the width of the nanowire, the texture height and the texture period were varied in order to obtain a good insight into the general trends. The optical performance can be improved dramatically as the reflection, which is the largest optical loss, can be reduced by 95% of the original value. The spectra reveal absorption in the Cu(In,Ga)Se₂ (CIGS) layer of 95% and reflection below 2% over a large part of the spectrum. In essence, a virtually black CIGS cell stack can be achieved for textured cells with a metal nanogrid. Moreover, it turned out that the ratio between the width of the nanowire and the height of the texture is a critical parameter for optical losses.

Advanced light management based on periodic textures for Cu(In,Ga)Se2 thin-film solar cells

We have used 3-D optical modelling to investigate light management concepts based on periodic textures and material optimization for photovoltaic devices based on Cu(In,Ga)Se₂ (CIGS) absorber material. At first, calibration of the software based on the characterization of a reference (1500-nm thick) CIGS device was carried out. The effects of 1-D and 2-D symmetric gratings on the cell were then investigated, showing significant improvement in anti-reflection effect and in absorptance in the active layer, achieved by excitation of guided modes in the absorber. In addition, device configurations endowed with alternative back reflector and front transparent conductive oxide (TCO) were tested with the goal to quench parasitic absorption losses at front and back side. The use of In₂O₃:H (IOH) as front and back TCO, combined with an optimized 2-D grating structure, led to a 25% increase of the optical performance with respect to an equally-thick flat device. Most of the performance increase was kept when the absorber thickness was reduced from 1500 nm to 600 nm.