Portable IR dye laser optofluidic microresonator as a temperature and chemical sensor

Transferable microfiber laser arrays for high-sensitivity thermal sensing

Functional microfibers have attracted extensive attention due to their potential in health monitoring, radiation cooling, power management and luminescence. Among these, polymer fiber-based microlasers have plentiful applications due to their merits of full color, high quality factor and simple fabrication. However, developing a facile approach to fabricate stable microfiber lasing devices for high-sensitivity thermal sensing is still challenging. In this research, we propose a design of a stable and transferable membrane inlaid with whispering-gallery-mode plasmon hybrid microlaser arrays for thermal sensing. By integrating plasmonic gold nanorods with polymer lasing microfiber arrays that are embedded in the polydimethylsiloxane matrix, whispering-gallery-mode lasing arrays with high quality are achieved. Based on the thermo-optical effect of the membrane, a tuning range of 1.462 nm for the lasing peak shift under temperature variation from 30.6 °C to 38.7 °C is obtained. The ultimate thermal sensing sensitivity can reach up to 0.181 nm °C-1 and the limit of detection is 0.131 °C, with a high figure of merit of 2.961 °C-1. Moreover, a stable laser linewidth can be maintained within the tuning range due to plasmon-improved photon confinement and PDMS-reduced scattering loss. This work is expected to provide a facile approach for the fabrication of high-sensitivity on-chip thermometry devices.

Optical monitoring of detergent pollutants in greywater

Large amount of wastewater is produced by washing machines and dishwashers, which are used in a daily basis. This domestic wastewater generated in households or office buildings (also called greywater) is drained directly to the drainpipes without differentiation from that with fecal contamination from toilets. Detergents are arguably the pollutants most frequently found in greywater from home appliances. Their concentrations vary in the successive stages in a wash cycle, which could be taken into account in a rational design of home appliances wastewater management. Analytical chemistry procedures are commonly used to determine the pollutant content in wastewater. They require collecting samples and their transport to properly equipped laboratories, which hampers real time wastewater management. In this paper, optofluidic devices based on planar Fabry-Perot microresonators operating in transmission mode in the visible and near infrared spectral ranges have been studied to determine the concentration of five brands of soap dissolved in water. It is found that the spectral positions of the optical resonances redshift when the soap concentration increases in the corresponding solutions. Experimental calibration curves of the optofluidic device were used to determine the soap concentration of wastewater from the successive stages of a washing machine wash cycle either loaded with garments or unloaded. Interestingly, the analysis of the optical sensor indicated that the greywater from the last water discharge of the wash cycle could be reused for gardening or agriculture. The integration of this kind of microfluidic devices into the home appliances design could lead to reduce our hydric environmental impact.

Advances of Optofluidic Microcavities for Microlasers and Biosensors

Optofluidic microcavities with high Q factor have made rapid progress in recent years by using various micro-structures. On one hand, they are applied to microfluidic lasers with low excitation thresholds. On the other hand, they inspire the innovation of new biosensing devices with excellent performance. In this article, the recent advances in the microlaser research and the biochemical sensing field will be reviewed. The former will be categorized based on the structures of optical resonant cavities such as the Fabry⁻Pérot cavity and whispering gallery mode, and the latter will be classified based on the working principles into active sensors and passive sensors. Moreover, the difficulty of single-chip integration and recent endeavors will be briefly discussed.

Luminous exothermic hollow optical elements for enhancement of biofilm growth and activity

In this work, we present a luminous-exothermic hollow optical element (LEHOE) that performs spectral beam splitting in the visible spectral range for the enhancement of biofilm growth and activity. The LEHOE is composed of a four-layer structure with a fiber core (air), cladding (SiO₂), coating I (LaB₆ film), and coating II (SiO₂-Agarose-Medium film). To clarify the physical, optical and photothermal conversion properties of the LEHOE, we determined the surface morphology and composition of the coating materials, and examined the luminous intensity and heating rate at the LEHOE surface. The biofilm activity on the biocompatible LEHOE is far greater than that of commercial fibers, and the biofilm weight on the LEHOE is 4.5 × that of the uncoated hollow optical element.