Influence of the graphene layer on the strong coupling in the hybrid Tamm-plasmon polariton mode

Suppressing the radiation loss by hybrid Tamm-surface plasmon BIC modes

Tamm plasmon polaritons (TPPs), localized near the boundary of a dielectric Bragg reflector (DBR) and a thin metal film, have attracted much attention for the lower ohm loss and flexible excitation. However, the radiation loss resulting from the direct coupling to the surroundings hinders their applications. Here, we propose and experimentally demonstrate a new type of hybrid plasmonic quasi-bound state in the continuum (BIC) in a Tamm-surface plasmon polariton system to suppress the radiation loss. Leveraging the scattering of the periodic metal array, the TPP interacts with the surface plasmon polariton (SPP) mode and form a Friedrich-Wintgen type quasi-BIC state that originated from the interference of two surface waves with different natures. Through angle resolved reflectance spectrum measurement, the hybrid plasmonic quasi-BIC was observed in the experiment. Our work proposes a new method to design a high Q mode in plasmonic systems, and thus holds promise for applications in the field of light matter interactions.

Tamm and surface plasmon hybrid modes in anisotropic graphene-photonic-crystal structure for hemoglobin detection

We propose Tamm plasmon (TP) and surface plasmon (SP) hybrid modes for hemoglobin (Hb) detection in anisotropic graphene-photonic-crystal (GPC) structures. The proposed GPC sensor shows polarization-dependent responses due to the in-plane anisotropic property. The reflection profiles of the proposed sensor exhibit two reflectivity minima due to the simultaneous excitation of TP and SP modes. When used to detect Hb, the TP mode offers a greater figure-of-merit (FoM) than the SP mode. Using a Fourier mode spectral analysis, we observe energy coupling from the TP to the SP mode when the incident light's polarization changes, providing an option to enhance the sensor's sensitivity. We propose a double dips method (DDM) to detect Hb based on the simultaneous excitation of TP and SP modes. Using DDM, the proposed sensor offers a maximum sensitivity of 314.5 degrees/RIU and a FoM of 1746 RIU-1 when the Hb level is 189 g/L. The proposed anisotropic GPC sensor offers possible applications for highly sensitive bio-molecule detection with high FoM.

Hybrid Tamm and quasi-BIC microcavity modes

The microcavity in the form of a liquid crystal defect layer embedded in a one-dimensional photonic crystal is considered. The microcavity mode has a tunable radiation decay rate in the vicinity of a bound state in the continuum. It is demonstrated that coupling between the microcavity mode and a Tamm plasmon polariton results in hybrid Tamm-microcavity modes with a tunable Q factor. The measured spectral features of hybrid modes are explained in the framework of the temporal coupled mode theory.

Coupled Tamm Phonon and Plasmon Polaritons for Designer Planar Multiresonance Absorbers

Wavelength-selective absorbers (WS-absorbers) are of interest for various applications, including chemical sensing and light sources. Lithography-free fabrication of WS-absorbers can be realized via Tamm plasmon polaritons (TPPs) supported by distributed Bragg reflectors (DBRs) on plasmonic materials. While multifrequency and nearly arbitrary spectra can be realized with TPPs via inverse design algorithms, demanding and thick DBRs are required for high quality-factors (Q-factors) and/or multiband TPP-absorbers, increasing the cost and reducing fabrication error tolerance. Here, high Q-factor multiband absorption with limited DBR layers (3 layers) is experimentally demonstrated by Tamm hybrid polaritons (THPs) formed by coupling TPPs and Tamm phonon polaritons when modal frequencies are overlapped. Compared to the TPP component, the Q-factors of THPs are improved twofold, and the angular broadening is also reduced twofold, facilitating applications where narrow-band and nondispersive WS-absorbers are needed. Moreover, an open-source algorithm is developed to inversely design THP-absorbers consisting of anisotropic media and exemplify that the modal frequencies can be assigned to desirable positions. Furthermore, it is demonstrated that inversely designed THP-absorbers can realize same spectral resonances with fewer DBR layers than a TPP-absorber, thus reducing the fabrication complexity and enabling more cost-effective, lithography-free, wafer-scale WS-absorberss for applications such as free-space communications and gas sensing.

Strong Coupling between Tamm and Surface Plasmons for Advanced Optical Bio-Sensing

The total internal reflection ellipsometry method was used to analyse the angular spectra of the hybrid Tamm and surface plasmon modes and to compare their results with those obtained using the conventional single SPR method. As such type of measurement is quite common in commercial SPR devices, more detailed attention was paid to the analysis of the p-polarization reflection intensity dependence. The conducted study showed that the presence of strong coupling in the hybrid plasmonic modes increases the sensitivity of the plasmonic-based sensors due to the reduced losses in the metal layer. The experimental results and analysis of the optical responses of three different plasmonic-based samples indicated that the optimized Tamm plasmons ΔRp(TP) and optimized surface plasmons ΔRp(SP) samples produce a response that is about five and six times greater than the conventional surface plasmon resonance ΔRp(SPR) in angular spectra. The sensitivity of the refractive index unit of the spectroscopic measurements for the optimized Tamm plasmon samples was 1.5 times higher than for conventional SPR, while for wavelength scanning, the SPR overcame the optimized TP by 1.5 times.

Hybrid Tamm-surface plasmon polariton mode for highly sensitive detection of protein interactions

The total internal reflection ellipsometry (TIRE) method was used for the excitation and study of the sensitivity properties of the hybrid Tamm plasmon polariton - surface plasmon polariton (TPP-SPP) and single surface plasmon resonance (SPR) modes of the GCSF receptor immobilization. Additionally, the optimized sensitivity of the hybrid TPP-SPP mode was investigated and compared with the single SPR mode when the BSA proteins formed a layer on the gold surface. The dispersion relations for the hybrid TPP-SPP and single SPR modes were used to explain the enhanced sensitivity of the ellipsometric parameters for the hybrid TPP-SPP mode over the conventional SPR. The SPP component (δΔ_h-SPP/δλ=53.9°/nm) of the hybrid TPP-SPP mode was about 6.4 times more sensitive than single SPR (δΔ_SPR/δλ=8.4°/nm) for the BSA protein layer on the gold film. It was found that the sensitivity of the hybrid plasmonic mode can be made controllable by using the strong coupling effect between the TPP and SPP components. The strong coupling regime reduces absorption and scattering losses of the metal for the SPP component in the hybrid TPP-SPP mode and, as a result, narrows the plasmonic resonance.