Tunable Bloch surface waves in anisotropic photonic crystals based on lithium niobate thin films

Bloch Surface Waves in Open Fabry-Perot Microcavities

Thanks to the increasing availability of technologies for thin film deposition, all-dielectric structures are becoming more and more attractive for integrated photonics. As light-matter interactions are involved, Bloch Surface Waves (BSWs) may represent a viable alternative to plasmonic platforms, allowing easy wavelength and polarization manipulation and reduced absorption losses. However, plasmon-based devices operating at an optical and near-infrared frequency have been demonstrated to reach extraordinary field confinement capabilities, with localized mode volumes of down to a few nanometers. Although such levels of energy localization are substantially unattainable with dielectrics, it is possible to operate subwavelength field confinement by employing high-refractive index materials with proper patterning such as, e.g., photonic crystals and metasurfaces. Here, we propose a computational study on the transverse localization of BSWs by means of quasi-flat Fabry-Perot microcavities, which have the advantage of being fully exposed toward the outer environment. These structures are constituted by defected periodic corrugations of a dielectric multilayer top surface. The dispersion and spatial distribution of BSWs' cavity mode are presented. In addition, the hybridization of BSWs with an A exciton in a 2D flake of tungsten disulfide (WS₂) is also addressed. We show evidence of strong coupling involving not only propagating BSWs but also localized BSWs, namely, band-edge and cavity modes.

Total Internal Reflection Ellipsometry Approach for Bloch Surface Waves Biosensing Applications

A one-dimensional photonic crystal with an additional TiO₂ layer, supporting Bloch surface waves (BSW), was used for enhanced signal sensitivity for the detection of protein interaction. To compare the optical response of BSW and photonic crystals (PC), bovine serum albumin and specific antibodies against bovine serum were used as a model system. The results obtained show the enhanced sensitivity of p- and s-BSW components for the 1D PC sample with an additional TiO₂ layer. Furthermore, a higher sensitivity was obtained for the BSW component of p-polarization in the PC sample with an additional TiO₂ layer, where the sensitivity of the ellipsometric parameter Ψ was five times higher and that of the Δ parameter was eight times higher than those of the PC sample. The capabilities of BSW excitations are discussed from the sensitivity point of view and from the design of advanced biosensing.

Strong Coupling between Tamm and Surface Plasmons for Advanced Optical Bio-Sensing

The total internal reflection ellipsometry method was used to analyse the angular spectra of the hybrid Tamm and surface plasmon modes and to compare their results with those obtained using the conventional single SPR method. As such type of measurement is quite common in commercial SPR devices, more detailed attention was paid to the analysis of the p-polarization reflection intensity dependence. The conducted study showed that the presence of strong coupling in the hybrid plasmonic modes increases the sensitivity of the plasmonic-based sensors due to the reduced losses in the metal layer. The experimental results and analysis of the optical responses of three different plasmonic-based samples indicated that the optimized Tamm plasmons ΔRp(TP) and optimized surface plasmons ΔRp(SP) samples produce a response that is about five and six times greater than the conventional surface plasmon resonance ΔRp(SPR) in angular spectra. The sensitivity of the refractive index unit of the spectroscopic measurements for the optimized Tamm plasmon samples was 1.5 times higher than for conventional SPR, while for wavelength scanning, the SPR overcame the optimized TP by 1.5 times.

Hybrid Tamm-surface plasmon polariton mode for highly sensitive detection of protein interactions

The total internal reflection ellipsometry (TIRE) method was used for the excitation and study of the sensitivity properties of the hybrid Tamm plasmon polariton - surface plasmon polariton (TPP-SPP) and single surface plasmon resonance (SPR) modes of the GCSF receptor immobilization. Additionally, the optimized sensitivity of the hybrid TPP-SPP mode was investigated and compared with the single SPR mode when the BSA proteins formed a layer on the gold surface. The dispersion relations for the hybrid TPP-SPP and single SPR modes were used to explain the enhanced sensitivity of the ellipsometric parameters for the hybrid TPP-SPP mode over the conventional SPR. The SPP component (δΔ_h-SPP/δλ=53.9°/nm) of the hybrid TPP-SPP mode was about 6.4 times more sensitive than single SPR (δΔ_SPR/δλ=8.4°/nm) for the BSA protein layer on the gold film. It was found that the sensitivity of the hybrid plasmonic mode can be made controllable by using the strong coupling effect between the TPP and SPP components. The strong coupling regime reduces absorption and scattering losses of the metal for the SPP component in the hybrid TPP-SPP mode and, as a result, narrows the plasmonic resonance.

Optical Dispersions of Bloch Surface Waves and Surface Plasmon Polaritons: Towards Advanced Biosensors

The total internal reflection ellipsometry (TIRE) method was used for the excitation and study of the sensitivity features of surface plasmon polariton (SPP) and Bloch surface waves (BSWs) resonances. For the BSWs generation distributed Bragg gratings were formed on the tops of the substrates (BK7 glass substrate), which had six bilayers of ~120 nm SiO₂ and ~40 nm TiO₂ and 40 nm of TiO₂ on the top. The SPP sample consisted of the BK7 glass prism and a gold layer (45 nm). Numerical calculations of the optical dispersions and the experimental TIRE data have shown that SPP resonance overtake the BSWs in wavelength scanning by a factor of about 17. However, for the ellipsometric parameters Ψ and Δ in the vicinity of excitations, the BSW sensitivity is comparable with SPP. The obtained resolutions were Δ S P P = 7.14 × 10 - 6 R I U , Ψ S P P = 1.7 × 10 - 5 R I U for the SPP and Δ B S W = 8.7 × 10 - 6 R I U , Ψ B S W = 2.7 × 10 - 5 R I U for the BSW. The capabilities of both surface excitations are discussed from the sensitivity point of view in the design of these advanced biosensors.

Bloch surface waves at the telecommunication wavelength with lithium niobate as the top layer for integrated optics

Lithium niobate (LN)-based devices are widely used in integrated and nonlinear optics. This material is robust and resistive to high temperatures, which makes the LN-based devices stable, but challenging to fabricate. In this work, we report on the design, manufacturing, and characterization of engineered dielectric media with thin-film LN (TFLN) on top for the coupling and propagation of electromagnetic surface waves at telecommunication wavelengths. The designed one-dimensional photonic crystal (1DPhC) sustains Bloch surface waves (BSWs) at the multilayer-air interface at 1550 nm wavelength with a propagation detected over a distance of 3 mm. The working wavelength and improved BSW propagation parameters open the way for exploration of nonlinear properties of BSW-based devices. It is also expected that these novel devices potentially would be able to modify BSW propagation and coupling by external thermal-electrical stimuli due to the improved quality of the TFLN top layer of 1DPhC.

Hybrid Tamm-surface plasmon polaritons mode for detection of mercury adsorption on 1D photonic crystal/gold nanostructures by total internal reflection ellipsometry

Spectroscopic ellipsometry was used for the generation and study of the hybrid TPP-SPP mode as a sensor probe for the real-time formation of amalgam structures on the surface of a plasmon active gold layer. The Au/Hg amalgam formation features and the mercury atoms' penetration into the gold layer were determined by means of the experimental TIRE data and a regression analysis of a multi-layer model containing the index-profile amalgam layer. The hybrid TPP-SPP mode behavior of the coupled excitations provided more information about the mercury atoms' penetration into the gold layer than the single TPP and SPP resonances did. The present study demonstrated the possibility of using the hybrid TPP-SPP mode to design advanced optical gas sensor technologies.

Polarization controlled directional propagation of Bloch surface wave

Bloch surface waves (BSWs) are recently developing alternative to surface plasmon polaritons (SPPs). Due to dramatically enhanced propagation distance and strong field confinement these surface states can be successfully used in on-chip all-optical integrated devices of increased complexity. In this work we propose a highly miniaturized grating based BSW coupler which is gathering launching and directional switching functionalities in a single element. This device allows to control with polarization the propagation direction of Bloch surface waves at subwavelength scale, thus impacting a large panel of domains such as optical circuitry, function design, quantum optics, etc.