Seeded optical parametric generation in CdSiP2 pumped by a Raman fiber amplifier at 1.24 µm

High power tunable Raman fiber laser at 1.2 μm waveband

Development of a high power fiber laser at special waveband, which is difficult to achieve by conventional rare-earth-doped fibers, is a significant challenge. One of the most common methods for achieving lasing at special wavelength is Raman conversion. Phosphorus-doped fiber (PDF), due to the phosphorus-related large frequency shift Raman peak at 40 THz, is a great choice for large frequency shift Raman conversion. Here, by adopting 150 m large mode area triple-clad PDF as Raman gain medium, and a novel wavelength-selective feedback mechanism to suppress the silica-related Raman emission, we build a high power cladding-pumped Raman fiber laser at 1.2 μm waveband. A Raman signal with power up to 735.8 W at 1252.7 nm is obtained. To the best of our knowledge, this is the highest output power ever reported for fiber lasers at 1.2 μm waveband. Moreover, by tuning the wavelength of the pump source, a tunable Raman output of more than 450 W over a wavelength range of 1240.6-1252.7 nm is demonstrated. This work proves PDF's advantage in high power large frequency shift Raman conversion with a cladding pump scheme, thus providing a good solution for a high power laser source at special waveband.

Versatile optical frequency combs based on multi-seeded femtosecond optical parametric generation

This study proposes and demonstrates a versatile method for near- and mid-infrared optical frequency comb generation using multi-seeded femtosecond optical parametric generation. The method allows one to divide the repetition rate by an arbitrarily large integer factor, freely tune the offset frequency, and adjust the common phase offset of the comb modes. Since all possible degrees of freedom are adjustable, the proposed method manifests itself as versatile optical frequency synthesis.

Optical parametric generation in OP-GaAs waveguides pumped by a femtosecond fluoride fiber laser

We report on mid-infrared optical parametric generation in the 4-5 μm and 9-12 μm bands by pumping custom-designed orientation-patterned gallium arsenide (OP-GaAs) rib waveguides with an ultrafast femtosecond fiber laser system. This pump source is seeded by a mode-locked fluoride fiber laser with 59 MHz repetition rate and can be tuned between 2.8 and 3.2 μm using a soliton self-frequency shifting stage. The single TE and TM modes OP-GaAs crystals feature quasi-phase-matched grating periods of 85 and 90 μm and different transverse sizes thus allowing a wide spectral tunability.

The Investigation on Mid-Far Infrared Nonlinear Crystal AgGaGe5Se12 (AGGSe)

3–5, 8–14 μm mid-far infrared (MF-IR) coherent lights generated by nonlinear optical (NLO) crystals are crucial for many industrial and military applications. AgGaGe5Se12 (AGGSe) is a promising NLO candidate because of its good optical performance. In this paper, the large AGGSe single crystal of 35 mm diameter and 80 mm length was obtained by the seed-aided Bridgman method. The crystalline quality was characterized with X-ray diffraction, rocking curve, transmission spectrum. The FWHM of the (210) peak was about 0.05° and the IR transmission was about 60% (1–10 μm, 6 mm thick). Additionally, it performed well in 8 μm frequency doubling, with a maximum output power of about 41 mW, corresponding to an optical-to-optical conversion efficiency of 3.2%. The laser induced damage threshold (LIDT) value was about 200 MW/cm2 (1.06 μm, 20 ns, 1 Hz).