Saponification then GC for Determination of Irganox 1010 and Irganox 1076 in a Polymer Matrix

High-throughput quantification of stabilizers in polymeric materials by flow injection tandem mass spectrometry

RATIONALE

High-throughput methods for identification and quantification of stabilizers in plastic materials are of significant importance in order to evaluate the suitability of materials of unknown origin for specific application areas, to clarify reasons for failure of materials, or for comparison of materials from different sources.

METHODS

In the present study, a highly sensitive and rapid flow injection method coupled to selected reaction monitoring mass spectrometry (MS) for comprehensive analysis of 21 polymer stabilizers in polyolefins is demonstrated. A critical factor for this approach is the choice of ionization mode, as no separation was performed prior to MS detection. Differences between several ionization techniques regarding matrix effects are reported.

RESULTS

Atmospheric pressure chemical ionization was found to be the most suitable ionization technique, with no significant matrix effects observed. The developed method has a linear dynamic range over two to three orders of magnitude with correlation coefficients better than 0.99 for all studied analytes. Following a multistep sample preparation protocol, the method allowed quantification down to minimum values of between 0.0001 and 0.04 wt% depending on the type of stabilizer. Results were compared to an established chromatographic approach and showed very good correlation (bias below 7.5%).

CONCLUSIONS

The applicability of the optimized method could be demonstrated for both the qualitative and quantitative determination of polymer stabilizers in polyolefins. Furthermore, the described approach yields a complete analysis in a much shorter time than can be achieved with commonly applied chromatographic methods.