Application of SPE Using Multi-Walled Carbon Nanotubes as Adsorbent and Rapid Resolution LC-MS-MS for the Simultaneous Determination of 11 Triazine Herbicides Residues in River Water

Deep eutectic solvent coated paper: Sustainable sorptive phase for sample preparation

Paper-based sorptive phases have gained attention recently due to the low-cost and sustainable character of the cellulosic substrate. However, the sustainability of the resulting phase can be limited by type of coating used for analytes isolation. In this article, this limitation is overcome by using deep eutectic solvents (DES) as coating. To this aim, a Thymol-Vanillin DES is synthesized and deposited on pre-cut cellulose paper strips. The paper-supported DES is employed as sorptive phase for the isolation of selected triazine herbicides for environmental waters analysis. The isolated analytes are finally determined by gas chromatography-mass spectrometry using selected ion monitoring. The method is optimized according to the critical variables that potentially affect its analytical performance such as sample volume, extractant amount, extraction time and sample ionic strength. The method was characterized in terms of sensitivity, accuracy and precision and its applicability was evaluated for the analysis of real environmental water samples. Good linearity values (R²>0.995) were obtained for all the analytes. Limits of detection (LODs) ranged from 0.4 to 0.6 µg L^-1 and the precision, expressed as relative standard deviation (RSD) was better than 14.7%. The relative recoveries, calculated in spiked well and river samples, were in the range 90-106%.

Recent advances in the extraction of triazine herbicides from water samples

Pesticides are excessively used in agriculture to improve the quality of crops by eliminating the negative effects of pests. Among the different groups of pesticides, triazine pesticides are a group of compounds that contain a substituted C₃ H₃ N₃ heterocyclic ring, and they are widely used. Triazine pesticides can be dangerous for humans as well as for the aquatic environment because of their high toxicity and endocrine disrupting effect. However, the concentration of these chemical compounds in water samples is low. Moreover, other compounds that may exist in the water samples can interfere with the determination of triazine pesticides. As a result, it is important to develop sample preparation methods that provide preconcentration of the target analyte and sufficient clean-up of the samples. Recently, a wide variety of novel microextraction and miniaturized extraction techniques (e.g., solid-phase microextraction and liquid-phase microextraction, stir bar sorptive extraction, fabric phase sorptive extraction, dispersive solid-phase extraction, and magnetic solid-phase extraction) have been developed. In this review, we aim to discuss the recent advances regarding the extraction of triazine pesticides from environmental water samples. Emphasis will be given to novel sample preparation methods and novel sorbents developed for sorbent-based extraction techniques.

Solid-phase extraction cartridges with multi-walled carbon nanotubes and effect of the oxygen functionalities on the recovery efficiency of organic micropollutants

Pristine and functionalized multi-walled carbon nanotubes (MWCNTs) were investigated as adsorbent materials inside solid-phase extraction (SPE) cartridges for extraction and preconcentration of 8 EU-relevant organic micropollutants (with different pKa and polarity) before chromatographic analysis of surface water. The recoveries obtained were > 60% for 5/8 target pollutants (acetamiprid, atrazine, carbamazepine, diclofenac, and isoproturon) using a low amount of this reusable adsorbent (50 mg) and an eco-friendly solvent (ethanol) for both conditioning and elution steps. The introduction of oxygenated surface groups in the carbon nanotubes by using a controlled HNO₃ hydrothermal oxidation method, considerably improved the recoveries obtained for PFOS (perfluorooctanesulfonic acid) and methiocarb, which was ascribed to the hydrogen bond adsorption mechanism, but decreased those observed for the pesticide acetamiprid and for two pharmaceuticals (carbamazepine and diclofenac), suggesting π–π dispersive interactions. Moreover, a good correlation was found between the recovery obtained for methiocarb and the amount of oxygenated surface groups on functionalized MWCNTs, which was mainly attributed to the increase of phenols and carbonyl and quinone groups. Thus, the HNO₃ hydrothermal oxidation method can be used to finely tune the surface chemistry (and texture) of MWCNTs according to the specific micropollutants to be extracted and quantified in real water samples.

Acute in vitro exposure to environmentally relevant atrazine levels perturbs bovine preimplantation embryo metabolism and cell number

Atrazine is a widely used herbicide known to negatively alter endocrine systems and perturb metabolism. Preimplantation exposure to pesticides may adversely affect long-term health, however few studies examine the effect of environmental levels and whether specific periods of development are particularly sensitive. In this study, the effect of acute, preimplantation atrazine exposure (days 3.5-7.5 post-fertilization) at levels detected and deemed safe in drinking water (0.02 and 20 μg/L respectively) on in vitro bovine embryo development, quality, metabolism, and gene expression was investigated. Atrazine exposure had no effect on development or quality, but significantly reduced blastocyst total cell numbers, attributable to a decrease in trophectoderm cells. Notably, atrazine (20 μg/L) markedly increased carbohydrate metabolism. Therefore, short-term exposure to environmentally relevant atrazine concentrations perturbs bovine preimplantation embryo metabolism and cell number, highlighting a potential mechanism by which atrazine can mediate embryo viability and health.

Determination of triazine herbicides and their metabolites in multiple medicinal parts of traditional Chinese medicines using streamlined pretreatment and UFLC-ESI-MS/MS

A rapid, sensitive, and reliable ultra-fast liquid chromatography combined with electrospray ionization tandem mass spectrometry (UFLC-ESI-MS/MS) method was established and applied to simultaneous determination of 31 triazine herbicides and their metabolites in multiple medicinal parts of traditional Chinese medicines (TCMs). A streamlined pretreatment approach using one-step extraction and dilution was proposed, which provided high-throughput processing, excellent recovery, and negligible interference. Afterwards, multiple-reaction monitoring (MRM) and information-dependent acquisition (IDA) triggered enhanced product ion spectra (EPI) was adopted to identify and quantify the targets in a single analysis. The optimized method was then validated according to the guidelines of the European Commission for the following parameters: Matrix effects, specificity, accuracy, precision, linearity, range, and stability. The LOD and LOQ for the 31 triazine herbicides were 0.1-10 μg kg^-1 and 0.5-25 μg kg^-1, respectively. Recoveries at three concentration levels were within 67.9-120.3% with an associated precision RSD <20%. Using the proposed approach, trazines herbicides were determined from 44 commercially available TCMs. The detection rate of triazine herbicides residues was 15.9% of the total samples. Among them, atrazine, simeton, and simetryn were found in the radix, herba, and seed TCMs with values far below the referenced maximum residue limits (MRLs), but no residues were detected in either the flos or fructus. Taken together, this method has the potential to provide a means for triazines screening in extensive matrices, thereby laying the foundation for pesticide registration on TCMs. Moreover, it has the potential to guide further triazine residue control in TCMs.

Versatile magnetic carbon nanotubes for sampling and pre concentration of pesticides in environmental water

This article describes a simple, efficient, and versatile magnetic carbon nanotubes (MCNT) method for sampling and pre-concentration of pesticides in environmental water samples. The multi-walled magnetic carbon nanotubes were obtained by chemical deposition vapor (CVD) process. The MCNTs structures are formed of hydrophobic and hydrophilic fractions that provide great dispersion at any water matrix allowing simultaneously a high efficiency of pesticides sorption. Following the extraction, analytes were desorbed with minor amounts of solvent and analyzed by gas chromatography coupled mass spectrometry (GC/MS). The parameters amount of MCNTs used to extraction, desorption time, and desorption temperature were optimized. The method showed good linearity with determination coefficients between 0.9040 and 0.9733. The limits of detection and quantification were ranged between 0.51 and 2.29µgL^-1 and between 1.19 and 5.35µgL^-1 respectively. The recovery ranged from 79.9% to 111.6%. The method was applied to the determination of fifteen multiclass pesticides in real samples of environmental water collected in Minas Gerais, Brazil.

Electrochemical sensing of etoposide using carbon quantum dot modified glassy carbon electrode

In this study, carbon quantum dots were used for enhancement of the electrochemical signals of etoposide.

Carbon nanotube-based QuEChERS extraction and enhanced product ion scan-assisted confirmation of multi-pesticide residue in dried tangerine peel

Carbon nanotubes-based QuEChERS extraction and enhanced product ion scan-assisted confirmation was developed for multi-pesticide residue analysis in dried tangerine peels.

Investigation of 10 herbicides in surface waters of a horticultural production catchment in southeastern Australia

Herbicides are regularly applied in horticultural production systems and may migrate off-site, potentially posing an ecological risk to surface waterways. However, few studies have investigated the levels and potential ecotoxicological impact of herbicides in horticultural catchments in southern Australia. This study investigated the presence of 10 herbicides at 18 sites during a 5-month period in horticulturally important areas of the Yarra Valley in southeastern Australia. Seven of the 10 herbicides were detected in the streams, in 39 % of spot water samples, in 25 % of surface sediment samples, and in >70 % of the passive sampler systems deployed. Few samples contained residues of ≥2 herbicides. Simazine was the herbicide most frequently detected in water, sediment, and passive sampler samples and had the highest concentrations in water (0.67 μg/L) and sediment (260 μg/kg dry weight). Generally the concentrations of the herbicides detected were several orders of magnitude lower than reported ecotoxicological effect values, including those for aquatic plants and algae, suggesting that concentrations of individual chemicals in the catchment were unlikely to pose an ecological risk. However, little is known about the combined effects of simultaneous, low-level exposure of multiple herbicides of the same mode of action on Australian aquatic organisms nor their contribution when found in mixtures with other pesticides. Further research is required to adequately assess the risk of pesticides in Victorian aquatic environments.

Screening of endocrine-disrupting phenols, herbicides, steroid estrogens, and estrogenicity in drinking water from the waterworks of 35 Italian cities and from PET-bottled mineral water

We investigated contamination by endocrine-disrupting chemicals in drinking water from 35 major Italian cities and five popular Italian brands of bottled mineral water. The quality of Italian drinking water was assessed by combing chemical analysis with bioassay to quantify specific estrogenic contaminants and to characterize the actual biological effect of the mixture of chemicals present in drinking water including the contribution of not targeted compounds. The selected contaminants were natural and synthetic steroid estrogens, alkylphenols and bisphenol A, linuron, triazine herbicides, and their metabolites. A specific analytical method was developed based on solid phase extraction of 1 L of water and concentration to 100 μL for quantification by electrospray ionization liquid chromatography tandem mass spectrometry, achieving quantification limits of 0.05-0.36 ng/L for herbicides and 0.64-7.70 ng/L for steroids and phenols. No steroid estrogens were detected in any of the samples, while bisphenol A and nonylphenols were detected in the ranges of 0.82-102.00 and 10.30-84.00 ng/L respectively. Herbicides and their degradation products, when present, were found from slightly above the quantification limits up to 49.91 ng/L, mainly from cities in northern Italy. Chemical analyses were complemented by the performance of a bioassay for the determination of the estrogenic activity in the extracts based on the transactivation of estrogen receptor α-transfected reporter HeLa-ERE-Luciferase-Neomycin cell line. Activity was generally low with maximum estrogenicity of 13.6 pg/L estradiol equivalents.