Optimization of a High-Performance Liquid Chromatography Method to Quantify Bilirubin and Separate It From Its Photoproducts: Effect of Column Length, pH, Mobile Phase Composition, and Flow Rate

Simultaneous determination of free biliverdin and free bilirubin in serum: A comprehensive LC-MS approach

BACKGROUND

Prognosis, diagnosis, and treatment of several diseases strongly rely on the sensitive, selective, and accurate determination of specific biomarkers in relevant biological samples. Free biliverdin and free bilirubin represent important new biomarkers of oxidative stress, however, the lack of suitable analytical methods for their determination has hindered progress in biomedical and clinical research.

RESULTS

Here, we introduce a first comprehensive approach for robust and simultaneous determination of these bilins in serum using liquid chromatography - mass spectrometry (LC-MS). The developed analytical method exhibits linearity for both analytes within the concentration range of 0.5-100 nM, with limits of detection and quantitation determined at 0.1 nM and 0.5 nM, respectively. Moreover, several analytical pitfalls related to the intrinsic molecular structures of free bilirubin and free biliverdin and their trace concentration levels in biological samples are discussed here in detail for the first time. We have shown that the solubility, chemical stability, and affinity of these bilins to various materials strongly depend on the solvent, pH, and addition of stabilizing and chelating agents. Finally, the validated LC-MS method was successfully applied to the analysis of both bilins in fetus bovine serums, yielding higher free bilirubin/biliverdin ratios compared with previously reported values for human serum.

SIGNIFICANCE

Failure to recognize and address the challenges presented here often leads to substantial analytical errors and consequently biased interpretation of the obtained results. This pertains not only to LC-MS, but also to many other analytical platforms due to the compound-derived sources of error.

Fabrication of Organic Hec Nanocomposites Modified with Lysine as a Potential Adsorbent for Bilirubin Removal

As one of the typical phyllosilicate clays, hectorite (Hec) has some excellent characteristics and has been greatly applied in adsorption field for the removal of dye, endotoxin, etc. In this study, organic Hec nanocomposites modified with L-Lysine (Lys/Hec NCs) were prepared via solution intercalation method for BR removal. The effects of ionic strength, pH values, initial concentration of BR, and BSA concentration on the adsorption capacity for BR of Lys/Hec NCs were investigated. Results indicated that the adsorption capacity for BR of nanocomposites could reach 40 mg/g when the initial bilirubin concentration was 200 mg/L. However, the adsorption amount of Lys/Hec NCs decreased with increasing the concentration of BSA, but Lys/Hec NCs could still maintain a higher adsorption rate. The adsorption kinetics and adsorption isotherms indicated that the adsorption process of Lys/Hec NCs agreed well with the pseudo-second-order model and the Langmuir isotherm, respectively. Moreover, Lys/Hec NCs also exhibited excellent cytocompatibility. These obtained results demonstrate that Lys/Hec NCs prepared in this study had great potential to be used in hemoperfusion.

Selective bilirubin sensor fabrication based on doped IAO nanorods for environmental remediation

In this approach, low-dimensional facile IAO nanorods were prepared by using the hydrothermal technique, which is efficiently applied to develop a non-enzymatic sensor coated with GCE probe by electrochemical reduction method.

Development of new methods for determination of bilirubin

The ever-increasing demand for a sensitive, rapid and reliable method for determination of serum bilirubin level has been inciting the interest of the researchers to develop new methods for both laboratory set up and point of care applications. These efforts embrace measurement of different forms of bilirubin, such as, unconjugated (free and albumin bound) bilirubin, conjugated (direct) bilirubin, and total (both conjugated and unconjugated) bilirubin in the serum that may provide critical information useful for diagnosis of many diseases and metabolic disorders. Herein, an effort has been made to provide a broad overview on the subject starting from the conventional spectroscopy based analytical methods widely practiced in the laboratory setup along with the sophisticated instrument based sensitive methods suitable for determination of different forms of bilirubin to various portable low cost systems applicable in point of care (POC) settings. In all these discussions emphasis is given on the novel methods and techniques bearing potential to measure the bilirubin level in biological samples reliably with less technical complexity and cost. We expect that this review will serve as a ready reference for the researchers and clinical professionals working on the subject and allied fields.

The fluorescence quenching of Ru(bipy)32+ : an application for the determination of bilirubin in biological samples

A simple, sensitive and efficient fluorescence method has been established for the quantitative analysis of bilirubin. The fluorometric determination method was based on the kinetic quenching of ruthenium(II) fluorescence. The quenching effect may be due to the complexation reaction of bilirubin with ruthenium(II). Therefore, the effects of ruthenium concentrations and different surfactants have been studied. Under the optimized experimental parameters, the fluorescence intensity decreased proportionally with the bilirubin concentration and linearity was established in the range of 3.3 × 10^-7 to 3.0 × 10^-4  M bilirubin. The detection limit calculated from the calibration graph was found to be 5.2 × 10^-8  M. The relative standard deviation (RSD) of 10 consecutive measurements of 8.0 × 10^-6  M bilirubin was 3.0%, while the recoveries of bilirubin in both human serum and urine samples were obtained in the range 94.0-99.5%. The interference study shows that the developed fluorescence based technique is fast, easy to carry out and shows negligible interference. The developed technique was successfully applied for the analysis of bilirubin in human urine and serum samples. All the experimental results and quality parameters confirmed the sensitivity and reproducibility of the proposed technique for bilirubin determination in human urine and serum samples.