Biotreatment of refinery spent-sulfidic caustic using an enrichment culture immobilized in a novel support matrix

Investigation of transient forms of sulfur during biological treatment of spent caustic

In the present study, the production of various transient forms of sulfur during biological oxidation of sulfidic spent caustics under haloalkaline conditions in a stirred tank bioreactor is investigated. Also, the effects of abiotic aeration (chemical oxidation), dissolved oxygen (DO) concentration and sodium concentration on forms of sulfur during biological treatment are demonstrated. Thioalkalivibrio versutus strain was used for sulfide oxidation in spent caustic (SC). The aeration had an important effect on sulfide oxidation and its final products. At DO concentrations above 2 mg l^-1, majority of sulfide was oxidized to sulfate. Maximum sulfide removal efficiency (%R) and yield of sulfate production [Formula: see text] was obtained in Na⁺ concentration ranging from 0.6 to 2 M. Abiotic aeration, which is the most important factor of production of thiosulfate, resulted in the formation of an undesired product-polysulfide. However, abiotic aeration can be used as a pretreatment to biological treatment. In the bioreactor the removal efficiency was obtained as 82.7% and various forms of sulfur such as polysulfide, biosulfur, thiosulfate and sulfate was observed during biological treatment of SC.

Study on Haloalkaliphilic Sulfur-Oxidizing Bacterium for Thiosulfate Removal in Treatment of Sulfidic Spent Caustic

Due to the disadvantages of physiochemical methods for sulfidic spent caustic treatment, attentions are drawn to the environmental-friendly biotreatments including sulfur-oxidizing halo-alkaliphiles. Thioalkalivibrio versutus DSM 13738 was grown at alkaline (pH10) autotrophic medium with sodium carbonate/bicarbonate as the sole source of carbon and amended with sodium thiosulfate as the electron and energy source. The effect of various parameters including temperature (25-40 °C), pH (8-11), NaCl concentration (0.5-5 % w/v) and sodium thiosulfate concentrations (100-750 mM) was evaluated on bacterial growth and thiosulfate removal. This strain could eliminate sodium thiosulfate at very high concentrations up to 750 mM. The results showed that the highest specific growth rate was pH 9.5 and thiosulfate removal of Thioalkalivibrio versutus occurred at pH 10.5. The optimum salt concentration for thiosulfate removal was 2.5 % w/v and 5 % NaCl and specific growth rate elevated 2.5% w/v. It was also specified that this strain thrives occurred in 37 °C and at 35 and 37 °C higher removal of thiosulfate. Following chemical oxidation of sulfide to thiosulfate, application of Thioalkalivibrio versutus could be promising for spent caustic treatment. Since thiosulfate is utilized as an energy source, highest removal efficiency occurred at marginally different conditions compared to optimal growth.

Study on Haloalkaliphilic Sulfur-Oxidizing Bacterium for Thiosulfate Removal in Treatment of Sulfidic Spent Caustic

Due to the disadvantages of physiochemical methods for sulfidic spent caustic treatment, attentions are drawn to the environmental-friendly biotreatments including sulfur-oxidizing halo-alkaliphiles.Thioalkalivibrio versutusDSM 13738 was grown at alkaline (pH10) autotrophic medium with sodium carbonate/bicarbonate as the sole source of carbon and amended with sodium thiosulfate as the electron and energy source. The effect of various parameters including temperature (25-40 °C), pH (8-11), NaCl concentration (0.5-5 % w/v) and sodium thiosulfate concentrations (100-750 mM) was evaluated on bacterial growth and thiosulfate removal. This strain could eliminate sodium thiosulfate at very high concentrations up to 750 mM. The results showed that the highest specific growth rate was pH 9.5 and thiosulfate removal ofThioalkalivibrio versutusoccurred at pH 10.5. The optimum salt concentration for thiosulfate removal was 2.5 % w/v and 5 % NaCl and specific growth rate elevated 2.5% w/v. It was also specified that this strain thrives occurred in 37 °C and at 35 and 37 °C higher removal of thiosulfate. Following chemical oxidation of sulfide to thiosulfate, application ofThioalkalivibrio versutuscould be promising for spent caustic treatment. Since thiosulfate is utilized as an energy source, highest removal efficiency occurred at marginally different conditions compared to optimal growth.

Application of a 2-step process for the biological treatment of sulfidic spent caustics

This research demonstrates the feasibility and advantages of a 2-step process for the biological treatment of sulfidic spent caustics under halo-alkaline conditions (i.e. pH 9.5; Na(+) = 0.8 M). Experiments with synthetically prepared solutions were performed in a continuously fed system consisting of two gas-lift reactors in series operated at aerobic conditions at 35 °C. The detoxification of sulfide to thiosulfate in the first step allowed the successful biological treatment of total-S loading rates up to 33 mmol L(-1) day(-1). In the second, biological step, the remaining sulfide and thiosulfate was completely converted to sulfate by haloalkaliphilic sulfide oxidizing bacteria. Mathematical modeling of the 2-step process shows that under the prevailing conditions an optimal reactor configuration consists of 40% 'abiotic' and 60% 'biological' volume, whilst the total reactor volume is 22% smaller than for the 1-step process.

Biological treatment of refinery spent caustics under halo-alkaline conditions

The present research demonstrates the biological treatment of refinery sulfidic spent caustics in a continuously fed system under halo-alkaline conditions (i.e. pH 9.5; Na(+)= 0.8M). Experiments were performed in identical gas-lift bioreactors operated under aerobic conditions (80-90% saturation) at 35°C. Sulfide loading rates up to 27 mmol L(-1)day(-1) were successfully applied at a HRT of 3.5 days. Sulfide was completely converted into sulfate by the haloalkaliphilic sulfide-oxidizing bacteria belonging to the genus Thioalkalivibrio. Influent benzene concentrations ranged from 100 to 600 μM. At steady state, benzene was removed by 93% due to high stripping efficiencies and biodegradation. Microbial community analysis revealed the presence of haloalkaliphilic heterotrophic bacteria belonging to the genera Marinobacter, Halomonas and Idiomarina which might have been involved in the observed benzene removal. The work shows the potential of halo-alkaliphilic bacteria in mitigating environmental problems caused by alkaline waste.

Acyl-homoserine lactones can induce virus production in lysogenic bacteria: an alternative paradigm for prophage induction

Prophage typically are induced to a lytic cycle under stressful environmental conditions or when the host's survival is threatened. However, stress-independent, spontaneous induction also occurs in nature and may be cell density dependent, but the in vivo signal(s) that can trigger induction is unknown. In the present study, we report that acyl-homoserine lactones (AHL), the essential signaling molecules of quorum sensing in many gram-negative bacteria, can trigger phage production in soil and groundwater bacteria. This phenomenon also was operative in a lambda lysogen of Escherichia coli. In model coculture systems, we monitored the real-time AHL production from Pseudomonas aeruginosa PAO1 using an AHL bioluminescent sensor and demonstrated that lambda-prophage induction in E. coli was correlated with AHL production. As a working model in E. coli, we show that the induction responses of lambda with AHL remained unaffected when recA was deleted, suggesting that this mechanism does not involve an SOS response. In the same lambda lysogen we also demonstrated that sdiA, the AHL receptor, and rcsA, a positive transcriptional regulator of exopolysaccharide synthesis, are involved in the AHL-mediated induction process. These findings relate viral reproduction to chemical signals associated with high host cell abundance, suggesting an alternative paradigm for prophage induction.

Prevalence of lysogeny among soil bacteria and presence of 16S rRNA and trzN genes in viral-community DNA

Bacteriophages are very abundant in the biosphere, and viral infection is believed to affect the activity and genetic diversity of bacterial communities in aquatic environments. Lysogenic conversion, for example, can improve host fitness and lead to phage-mediated horizontal gene transfer. However, little is known about lysogeny and transduction in the soil environment. In this study we employed atrazine-impregnated Bio-Sep beads (a cell immobilization matrix) to sample active microbiota from soils with prior pesticide exposure history. Once recovered from soil, the bead communities were induced with mitomycin C (MC), and viral and bacterial abundances were determined to evaluate the incidence of inducible prophage in soil bacteria. The inducible fraction calculated within bead communities was high (ca. 85%) relative to other studies in aquatic and sedimentary environments. Moreover, the bacterial genes encoding 16S rRNA and trzN, a chlorohydrolase gene responsible for dehalogenation of atrazine, were detected by PCR in the viral DNA fraction purified from MC-induced bead communities. A diverse collection of actinobacterial 16S rRNA gene sequences occurred within the viral DNA fraction of induced, water-equilibrated beads. Similar results were observed in induced atrazine-equilibrated beads, where 77% of the cloned sequences were derived from actinobacterial lineages. Heterogeneous 16S rRNA gene sequences consisting of fragments from two different taxa were detected in the clone libraries. The results suggest that lysogeny is a prevalent reproductive strategy among soil bacteriophages and that the potential for horizontal gene transfer via transduction is significant in soil microbial communities.

Evaluation of support matrices for immobilization of anaerobic consortia for efficient carbon cycling in waste regeneration

Efficient metabolism of fatty acids during anaerobic waste digestion requires development of consortia that include "fatty acid consuming H(2) producing bacteria" and methanogenic bacteria. The objective of this research was to optimize methanogenesis from fatty acids by evaluating a variety of support matrices for use in maintaining efficient syntrophic-methanogenic consortia. Tested matrices included clays (montmorillonite and bentonite), glass beads (106 and 425-600mum), microcarriers (cytopore, cytodex, cytoline, and cultispher; conventionally employed for cultivation of mammalian cell lines), BioSep beads (powdered activated carbon), and membranes (hydrophilic; nylon, polysulfone, and hydrophobic; teflon, polypropylene). Data obtained from headspace methane (CH(4)) analyses as an indicator of anaerobic carbon cycling efficiency indicated that material surface properties were important in maintenance and functioning of the anaerobic consortia. Cytoline yielded significantly higher CH(4) than other matrices as early as in the first week of incubation. 16S rRNA gene sequence analysis from crushed cytoline matrix showed the presence of Syntrophomonas spp. (butyrate oxidizing syntrophs) and Syntrophobacter spp. (propionate oxidizing syntrophs), with Methanosaeta spp. (acetate utilizing methanogen), and Methanospirillum spp. (hydrogen utilizing methanogen) cells. It is likely that the more hydrophobic surfaces provided a suitable surface for adherence of cells of syntrophic-methanogenic consortia. Cytoline also appeared to protect entrapped consortia from air, resulting in rapid methanogenesis after aerial exposure. Our study suggests that support matrices can be used in anaerobic digestors, pre-seeded with immobilized or entrapped consortia on support matrices, and may be of value as inoculant-adsorbents to rapidly initiate or recover proper system functioning following perturbation.