Mechanically Relevant Anatomy of the Axis Vertebra and Its Relation to Hangman's Fracture: An Illustrated Essay

Biomechanical evaluation of the novel assembled internal fixed system in C2-C3 anterior cervical discectomy and fusion: a finite element analysis

BACKGROUND

To analyze and compare the biomechanical characteristics of the new combined cervical fusion device (NCCFD) and the traditional cage-plate construct (CPC) to ascertain its effectiveness in anterior cervical discectomy and fusion (ACDF) using finite element analysis.

METHODS

A finite element model of the cervical spine, inclusive of the occipital bone was created and validated. In the ACDF model, either CPC or NCCFD was implanted at the C2-C3 segment of the model. A pure moment of 1.0 Nm combined with a follower load of 50 N was directed onto the superior surfaces of the occipital bone to determine flexion, extension, lateral bending (left and right), and axial rotation (left and right). The range of motion (ROM), stress distribution at the bone-implant interface, and facet joint forces were investigated and compared between CPC and NCCFD systems.

RESULT

The results showed that the ROMs of the fused levels in both models were nearly zero, and the motions of the unfused segments were similar. In addition, the maximum displacement exhibited nearly identical values for both models. The maximum stress of NCCFD screws in lateral bending and rotational conditions is significantly higher than that of the CPC, while the NCCFD model's maximum stress remains within an acceptable range. Comparing the maximum fusion stress, it was found that the CPC experiences much lower fusion stress in anterior flexion and extension than the NCCFD, with no significant difference between the two in lateral bending and rotational states. Stress on the cage was mainly concentrated on both sides of the wings. Comparing the maximum IDP in the CPC and NCCFD, it was observed that maximum stresses rise in extension and lateral bending for both models. Lastly, stress distributions of the facet joints were generally similar across the two devices.

CONCLUSION

NCCFD not only provides the same level of biomechanical stability as CPC but also avoids postoperative complications associated with uneven force damage to the implant. The device offers a novel surgical alternative for ACDF in C2-C3 level.

Detailed observation of anatomical location and pattern in Hangman's fracture based on computed tomography three-dimensional reconstruction

OBJECTIVE

To observe the precise anatomical location and pattern of the fracture lines in Hangman's fracture.

METHODS

Three-dimensional computed CT images of 210 patients with Hangman's fracture were collected. According to the involvement of anatomical structures, the injuries were classified into facet joint injury and pure bony injury. The C2 ring was also divided into: anterior, middle, and posterior elements. The anatomical structures involvement and fracture patterns were observed.

RESULT

Total 520 anatomical structures injuries were involved in 210 patients Hangman's fractures, including 298 facet joints injuries (57.3%) and 222 bony injuries (42.7%). The most common facet joints injury was superior articular facet injury of C2, and the most common pure bony injury was pediculoisthmic component fracture. The injuries of anterior element (60.6%) were more common than that of middle (20.4%) or posterior (19.0%) element. One injury in anterior element on one side and another injury located in the anterior, middle or posterior element other side was the most common fracture pattern. Injury of middle element on one side with another injury located in the middle or posterior element could be also observed.

CONCLUSION

In Hangman's fractures, fracture lines could occur in any part of C2 ring. Facet joints injuries were more common than pure bony injuries, and the injuries of anterior element were also more common than that of middle or posterior element. The high prevalence of facet joints injuries means that most of Hangman's fractures may be involved with intra-articular injuries.

Efficiency of minimal oblique resection of the uncinate process during an anterior cervical discectomy and fusion

Hypertrophy of the uncinate process (UP) can cause radiculopathy. Minimal UP resection is considered to remove the lesion while minimizing the risk of complications. This study aimed to elucidate the surgical results of minimal oblique resection of the UP. This study is a retrospective review of about sixty segments in 34 patients who underwent anterior cervical discectomy and fusion (ACDF) with minimal oblique uncinectomy between 2016 and 2018. The cross-sectional area of the UP was measured pre- and postoperatively. The interspinous distance, segmental Cobb angle, subsidence, fusion rate, surgical time, estimated blood loss, and postoperative complications were evaluated. The mean resected areas of the UP were 17.4 ± 8.7 mm2 (25.9%) on the right and 17.3 ± 11.2 mm2 (26.2%) on the left. The difference in interspinous distance in flexion-extension was 7.1 ± 3.2 and 1.6 ± 0.6 mm pre- and postoperatively, respectively (P = .000). The fusion rate after ACDF was 91.7% when measured according to segment (55/60) and 91.2% when measured according to patients (31/34). The difference in the segmental Cobb angle in flexion-extension was 8.3 ± 6.2° and 1.9 ± 0.3° pre and postoperatively, respectively (P = .000). Subsidence occurred in 4 (11.8%) patients and 5 (8.3%) segments. The average surgical time per segment was 68.8 ± 9.3 minute, and the estimated blood loss was 48.5 ± 25.0 mL. Postoperative complications comprised 1 case each of neck swelling, wound infection, pneumonia, and gastrointestinal bleeding. Our findings therefore revealed that minimal oblique uncinectomy during an ACDF can maintain the stability of the uncovertebral joint while sufficiently decompressing the neural foramen.

Basilar Invagination: Surgical Treatment by Novel Anterior Implant

Introduction

Anterior retropharyngeal realignment, distraction, and atlantoaxial fixation are an option for the treatment of symptomatic basilar invagination (BI). The anterior implants for distraction and fixation for atlantoaxial joints are still evolving. We share our experience using a novel implant which can easily, safely, and rigidly fix both lateral masses to the body of the axis.

Methods

After exposing both the atlantoaxial joints anteriorly, the joints were prepared, distracted with wedge shaped autologous tricorticate bone grafts and realigned to correct the cervicomedullary strain. The atlantoaxial joints were fixed using a novel titanium plate by passing screws upwards and laterally into the lateral masses of the atlas and centrally into the body of the axis. Post-operative imaging showed effective correction of BI and atlantoaxial dislocation. Post-operative dynamic X-ray images confirmed maintenance of rigid fixation at 6 months.

Conclusion

This new plate screw construct is safe, easy, cost-efficient, and biomechanically appealing option for the treatment of symptomatic BI.

The participation of basolateral amygdala in the efficacy of acupuncture with deqi treating for functional dyspepsia

Deqi is taken as an indispensable requirement to achieve acupuncture efficacy. This study aimed to explore the central influence of deqi on the efficacy of acupuncture for functional dyspepsia (FD). 70 FD patients were randomized to receive 20 sessions' acupuncture treatment with (n = 35) and without deqi (n = 35). In each group, 25 FD patients randomly selected underwent functional magnetic resonance imaging (fMRI) scans before and after treatment. After group re-division according to deqi response, changes of amygdala subregions-based resting-state functional connectivity (rsFC) were compared between the acupuncture with and without obvious deqi group. The clinical changes of the Nepean Dyspepsia Symptom Index (NDSI) measuring FD symptoms were also used to further assess the correlation with amygdala subregions rsFC in FD patients. The decrease in the NDSI scores (pre-pos) in the obvious deqi group was significantly greater than that in the acupuncture without obvious deqi group (p < 0.05). Compared to the without obvious deqi group, the obvious deqi group showed significantly decreased the left basolateral amygdala (BLA) rsFC with bilateral insular (INS), putamen and middle/posterior cingulate cortex (MCC/PCC), right pallidum and hippocampus (HIPP) after treatment. The changed NDSI scores(pre-post) of all 41 FD patients was significantly positively correlated with their Fisher's transformed z value of the left BLA rsFC with left INS (r = 0.376, FDR corrected p = 0.015), and rsFC with right HIPP (r = 0.394, FDR corrected p = 0.015). The changed NDSI scores(pre-post) of the obvious deqi group was significantly negatively correlated with their Fisher's transformed z value of the right centromedial amygdala (CMA) rsFC with left medial prefrontal cortex (mPFC) (r = -0.463, p = 0.035). The results tested the hypothesis that the advantage of deqi on efficacy is related to affecting the BLA and CMA rsFC. It suggested that deqi might influence the abnormal rsFC within the salience network (SN), and participate in the adaptive modulation of disrupted relationship between the SN and default mode network (DMN).

Anterior retropharyngeal cage distraction with atlantoaxial plate-screw fixation for basilar invagination with atlantoaxial dislocation

The unilateral submandibular anterior retropharyngeal approach in properly selected patients offers the possibility to expose both atlantoaxial joints adequately, abrade the endplates, and graft the joint spaces. The supine position in extension permits the use of wedge-shaped cages, which reduce the invagination and correct the dislocation. Adequate bone stock is available to rigidly fix the joints using an anterior plate-screw construct without any risk to the vertebral arteries. The approach preserves the posterior tension band and the C2 root. The technique is quick, simple, and safe, and results in solid fusion of the joints over time.

The video can be found here: https://youtu.be/tT6j3Czy6tc