High-performance, low-cost solar collectors for disinfection of contaminated water

Field evaluation of a novel UV water disinfection system for use in underserved rural communities

Reliable, robust, and inexpensive disinfection systems are needed to expand water security in remote and underserviced areas. This paper reports on the deployment and evaluation of a novel UV water disinfection system in a remote rural community. Prior laboratory tests indicated a 7.12 log10 reduction of the bacteriophage MS-2 at a flow rate of 9.46 L/min, which corresponds to a supplied UV dose 215 mJ/cm² . Further tests in water containing turbidity levels up to 18 NTU showed E. coli removal remaining above the 5 log10 level. Field testing was performed at a Native American reservation in Northern California where the system was used to treat groundwater obtained from a well with a known fecal contamination. The system was powered by solar panel and was operated on-demand for extended periods. Tests on the treated water showed that the system exceeded the standard of disinfection required for drinking water. PRACTITIONER POINTS: A novel system for water disinfection with UV light is described. Laboratory and field tests showed high levels of disinfection achieved even at low UVT and high turbidity. System is robust, reliable and inexpensive to produce thus suitable for use in underserved communities.

Ultraviolet A and B wavelength-dependent inactivation of viruses and bacteria in the water

UVA and UVB can be applied to solar disinfection of water. In this study, the inactivation and photoreactivation of viruses and bacteria in the UVA-B range were analyzed. MS2 and T4 bacteriophages, and Escherichia coli were used as surrogates to quantify dose-response behaviors. Inactivation in UVC was used to validate the methodology and to expand the inactivation action spectra. The results showed log-linear inactivation for MS2 and T4 in the 254-320 nm wavelength range. T4 inactivation was consistently faster than MS2 (except at 320 nm), and for both phages, inactivation decreased with increasing wavelength. The dose-response of bacteria exhibited a lag at low doses, possibly because the photons must strike a discrete number of critical targets before growth stops. A tail was present at high doses for some wavelengths, perhaps due to clumping or the presence of subgroups with higher resistance. The inactivation action spectra for bacteria exhibited a reduction in inactivation as wavelength increased. No bacterial inactivation was observed beyond 320 nm at doses applied. After inactivation at 297 nm (UVA), bacteria regained viability through photoreactivation, and repair increased with increase in photoreactivating light exposure time. This implies additional doses above inactivation thresholds are required to cause irreversible damage. These results are useful for designing solar disinfection systems.

Solar water disinfection (SODIS): a review from bench-top to roof-top

Solar water disinfection (SODIS) has been known for more than 30 years. The technique consists of placing water into transparent plastic or glass containers (normally 2L PET beverage bottles) which are then exposed to the sun. Exposure times vary from 6 to depending on the intensity of sunlight and sensitivity of the pathogens. Its germicidal effect is based on the combined effect of thermal heating of solar light and UV radiation. It has been repeatedly shown to be effective for eliminating microbial pathogens and reduce diarrhoeal morbidity including cholera. Since 1980 much research has been carried out to investigate the mechanisms of solar radiation induced cell death in water and possible enhancement technologies to make it faster and safer. Since SODIS is simple to use and inexpensive, the method has spread throughout the developing world and is in daily use in more than 50 countries in Asia, Latin America, and Africa. More than 5 million people disinfect their drinking water with the solar disinfection (SODIS) technique. This review attempts to revise all relevant knowledge about solar disinfection from microbiological issues, laboratory research, solar testing, up to and including real application studies, limitations, factors influencing adoption of the technique and health impact.

Continuous-flow solar UVB disinfection reactor for drinking water

Access to safe, reliable sources of drinking water is a long-standing problem among people in developing countries. Sustainable solutions to these problems often involve point-of-use or community-scale water treatment systems that rely on locally-available resources and expertise. This philosophy was used in the development of a continuous-flow, solar UVB disinfection system. Numerical modeling of solar UVB spectral irradiance was used to define temporal variations in spectral irradiance at several geographically-distinct locations. The results of these simulations indicated that a solar UVB system would benefit from incorporation of a device to amplify ambient UVB fluence rate. A compound parabolic collector (CPC) was selected for this purpose. Design of the CPC was based on numerical simulations that accounted for the shape of the collector and reflectance. Based on these simulations, a prototype CPC was constructed using materials that would be available and inexpensive in many developing countries. A UVB-transparent pipe was positioned in the focal area of the CPC; water was pumped through the pipe to allow exposure of waterborne microbes to germicidal solar UVB radiation. The system was demonstrated to be effective for inactivation of Escherichia coli, and DNA-weighted UV dose was shown to govern reactor performance. The design of the reactor is expected to scale linearly, and improvements in process performance (relative to results from the prototype) can be expected by use of larger CPC geometry, inclusion of better reflective materials, and application in areas with greater ambient solar UV spectral irradiance than the location of the prototype tests. The system is expected to have application for water treatment among communities in (developing) countries in near-equatorial and tropical locations. It may also have application for disaster relief or military field operations, as well as in water treatment in areas of developed countries that receive relatively intense solar UVB radiation.