Comparison of enamel microabrasion with a combined approach to the esthetic management of fluorosed teeth

Effects of microabrasion association to at-home bleaching on hydrogen peroxide penetration and color change

PURPOSE

This study aimed to quantify the penetration of hydrogen peroxide (HP) inside the pulp cavity and color change with two different concentrations of HP to at-home bleaching associated or not with enamel microabrasion (MA).

METHODS

Forty healthy premolars were randomly divided in four groups (n = 10): only HP4%, MA + HP4%, only HP10%, MA + HP10%. The concentration (μg/ml) of HP was assessed using UV-Vis spectrophotometry. The color change (ΔEab , ΔE00 and WID ) was evaluated before and one-week after bleaching. Data were evaluated for a two-way ANOVA and the Tukey's test (α = 0.05).

RESULTS

The application of MA increased the amounts of HP inside the pulp chamber when compared to without MA, as well as PH10% when compared to PH4% (p < 0.0001). PH10% showed higher WID when compared to PH4%. No significant difference was observed when ΔEab , and ΔE00 were used.

CONCLUSIONS

The enamel MA before at-home bleaching promotes greater penetration of HP, although this procedure did not significantly affect the color change.

CLINICAL SIGNIFICANCE

Since greater penetration of HP into the pulp chamber was detected when home bleaching was applied immediately after MA, the clinician should not apply home bleaching gels in the same session when MA was performed.

Effects of Microabrasion Prior to In-office Bleaching on Hydrogen Peroxide Permeability, Color Change, and Enamel Morphology

PURPOSE

This study evaluated hydrogen peroxide (HP) diffusion within the pulp chamber, as well as color change and the surface morphology of teeth subjected to various microabrasion (MA) protocols associated or not with in-office (IO) bleaching.

METHODS

Forty sound premolars were randomly divided into the following four groups (n=10): no treatment (NC); IO bleaching only; IO immediately after MA (IMA), and IO seven days after MA (7MA). After treatments, the HP concentration (μg/mL) within the pulp chamber was determined using ultraviolet-visible (UV-Vis) spectrophotometry. The color change (ΔE*) was evaluated using the digital spectrophotometer before and 1 week after bleaching. The surface morphology was evaluated by scanning electron microscope (SEM). Data from each test were submitted to one-way ANOVA and Tukey tests (α=0.05).

RESULTS

All experimental groups exhibited higher HP concentrations compared to the NC group (p<0.00001). However, higher amounts of HP were observed for the IMA group compared to the IO and 7MA groups (p<0.00001). No significant difference in color change was observed among the groups (p<0.001). Pronounced grooves in enamel were found in the IMA and 7MA groups. However, enamel erosion areas were observed only in the 7MA group.

CONCLUSIONS

The association between MA and IO bleaching could significantly affect the amount of HP inside the pulp chamber. Therefore, it is highly recommended to wait for 1 week after MA procedures before performing IO bleaching.

Clinical Performance of Enamel Microabrasion for Esthetic Management of Stained Dental Fluorosis Teeth

CLINICAL RELEVANCE

Enamel microabrasion is an effective first-line esthetic treatment for the removal of tooth stains due to fluorosis, with an improvement in the appearance of teeth that is associated with a high level of patient acceptance.

SUMMARY

Weight-loss and surface roughness of enamel after microabrasion procedure with different agents

Abstract Introduction Enamel microabrasion is achieved by abrasion of the enamel surface and it is a quick, practical and efficient procedure. Objective It was assessed the weight loss and surface aspect of enamel after microabrasion procedures with commercial and mixtures made in-office. Material and method Eighty bovine incisors were divided into four groups (n=10): OpalustreTM (6.6% HCl + silicon carbide); Whiteness RMTM (6% HCl + silicon carbide); 37% H3PO4 + pumice and 10% HCl + pumice. Treatment was performed by 15 applications of 10s duration. The enamel weight loss was determined by the difference in weight before and after the microabrasion. The surfaces were analyzed by a surface roughness equipment and scanning electron microscopy. Data were submitted to paired-T test, one-way ANOVA and Tukey tests (α=0.05). Result It was observed significantly weight loss for all groups. The difference in weight loss ranged from 0.037±0.012 for group 37% H3PO4 and from 0.054±0.009 for group 6,6% HCl. There was a significant increase in surface roughness for all groups and 10% HCl group showed the lower results (0.65±0.09). It was observed different patterns of enamel morphology by SEM images. Conclusion The in-office mixtures resulted in the lowest enamel structure loss (37% H3PO4) and the lowest surface roughness (10% HCl).

A review on dental whitening

OBJECTIVES

To provide a narrative review on vital dental whitening chemistry, toxicity and safety, vital dental whitening techniques, whitening systems, potential side effects of whitening and cyclic whitening using products with a range of concentrations and pH values. In addition, new developments and recommendations in the field of vital dental whitening will be presented to help clinicians understand the whitening process, its advantages, limitations, and the impact of whitening concentration and pH on enamel providing guidance in tailoring whitening treatments.

DATA

Data were gathered using the following keywords: dental whitening, roughness, hardness, sensitivity, hydrogen peroxide, whitening pH, whitening concentration, whitening chemistry, colour, and toxicity.

SOURCES

An electronic search was performed using PubMed and Scopus databases. Bibliographic material from papers reviewed was then used to find other relevant publications.

CONCLUSIONS

The effectiveness of vital dental whitening depends on many factors, such as the concentration/pH of the whitening agent, application duration, chemical additives, and re-mineralising agents used. Developing new whitening products and technologies such as nano-additives and alternative carrier systems is showing promising results, and might prove efficient in maximising whitening benefits by accelerating the whitening reaction and/or minimising expected reversible/irreversible enamel structural damage.

Smile Makeover by Veneers – Case Report

Ceramic veneers have evolved in the last few years as an aesthetic restoration in the field of aesthetic dentistry. It is a conservative option as compared to full coverage crowns for improving the patients smile. Ceramic veneers are widely used for smile designing in patients with fluorosis, midline diastema, hypoplastic teeth, and peg shape laterals. Clinical relevance: This article highlights the smile designing of a young patient with fluorosis using ceramic veneers, which not only improves the smile of the patient but has positive psychological benefits.

Enamel Microabrasion and Dental Bleaching on Teeth Presenting Severe-pitted Enamel Fluorosis: A Case Report

The present clinical case report describes the clinical steps of enamel microabrasion associated with dental bleaching to restore severely-pitted fluorosed teeth. The process of removing the fluorotic superficial stains started by using macroabrasion with a water-cooled fine tapered 3195 FF diamond bur. Rubber dam isolation of the operative field was used to remove the remaining enamel stains and superficial irregularities with the Opalustre microabrasive compound (6.6% hydrochloric acid associated with silicon carbide particles) followed by polishing using fluoridated paste and subsequent 2% neutral fluoride gel topical application. After one month, dental bleaching was performed using 10% carbamide peroxide in custom-formed acetate trays for two hours/day for 42 days. The association of enamel microabrasion with dental bleaching was effective for reestablishing the dental esthetics of a patient with severe dental fluorosis.

Esthetic recovery of teeth presenting fluorotic enamel stains using enamel microabrasion and home-monitored dental bleaching

This clinical report describes the enamel microabrasion technique for removing maxillary and mandibular hard fluorotic enamel stains followed by home-monitored home dental bleaching. The removal of fluorotic enamel stains utilized macroabrasion with a water-cooled, fine-tapered 3195 FF diamond bur followed microabrasion with the application of Prema Compound (Premier Dental Products Co, Norristown, PA, USA). Home-monitored dental bleaching was performed 14 days after enamel microabrasion using a 10% carbamide peroxide gel for 2 h/day. The wearing time of the acetate tray/dental bleaching was quantified by a microsensor from TheraMon microelectronic system (Sales Agency Gschladt, Hargelsberg, Austria) that was completely embedded in the acetate trays. The teeth were bleached effectively during 23 days. The mean wearing time of the acetate trays/dental bleaching product was 1.54 h/day, for the upper and lower arches. The patient reported satisfaction with the treatment. The association of enamel microabrasion and home dental bleaching was an excellent clinical treatment for teeth affected with enamel fluorosis.

Power bleaching enhances resin infiltration masking effect of dental fluorosis. A randomized clinical trial

OBJECTIVES

Patients with moderate dental fluorosis often feel esthetically compromised. Aim of this RCT was to evaluate the objectively and self-assessed masking effect of resin infiltration alone or in combination with in-office bleaching on dental fluorosis in adults.

METHODS

Twenty-seven patients (9 male, 18 female, 24.81 ± 3.7 yrs) with 410 fluorotic teeth (TF 1-4) were randomly assigned to a treatment (BLI) or control group (NBLI). Patients underwent in-office bleaching (25% H₂O₂) in the BLI or a placebo bleaching (ACP gel) in the NBLI group followed by resin infiltration after two weeks. Standardized digital photographs were obtained at baseline; after bleaching; before and after resin infiltration and after 1, 3, and 6 months. Color differences (ΔE) between sound and fluorotic areas were calculated and patient satisfaction was evaluated using a VAS (1-10).

RESULTS

Statistical analysis revealed significant differences in the mean ΔE values 6 months after resin infiltration between the BLI (ΔE = 1.41) and the NBLI group (ΔE = 4.33) (p = 0.024). VAS values increased after resin infiltration (p < 0.05) in both groups. After 3 months patients in the BLI group had higher VAS values than in the NBLI group (p = 0.029).

CONCLUSIONS

Findings of this study suggest that resin infiltration alone can effectively mask mild to moderate dental fluorosis in young adults. In-office bleaching with 25% H₂O₂ before resin infiltration provides significantly better masking effects.

CLINICAL SIGNIFICANCE

Resin infiltration is a safe and efficient treatment option for masking fluorotic opacities. A priori in-office bleaching with 25% H₂O₂ enhances the masking effect. This controlled clinical trial is registered in the German Clinical Trials Register #DRKS00010465.

Dental hypomineralization treatment: A systematic review

INTRODUCTION

Defects in the maturation stage of amelogenesis result in a normal volume of enamel but insufficient mineralization, called hypomineralization. Molar-incisor hypomineralization (MIH), amelogenesis imperfecta and dental fluorosis (DF) are examples of such defects.

OBJECTIVE

To evaluate the effectiveness of the treatments applied to the different forms of dental hypomineralization.

MATERIALS AND METHODS

PubMed, Scopus, Cochrane Library, Web of Science, and Embase were screened. The research was limited to studies published in English, Spanish, and Portuguese, until May 30, 2018. The research question was formulated following the Population, Intervention, Comparison, Outcome strategy. The quality of the methodology of each article was evaluated employing the Cochrane Handbook for Systematic Reviews.

RESULTS

From the initial research, 7895 references were obtained, of which 33 were included in the systematic review. The following treatments were reported: desensitizing and remineralizing products, resin infiltration, restorations, fissure sealants, tooth bleaching, enamel microabrasion and calcium, and vitamins supplements.

CONCLUSIONS

Although the results are suggestive, there is a clear need for a greater uniformity of the methodologies, thus allowing for the development of clinical guidelines. Nevertheless, it was possible to identify several effective treatments for teeth with MIH (arginine pastes or fluoride varnishes) and DF (tooth bleaching and/or enamel microabrasion).

CLINICAL SIGNIFICANCE

Because MIH, amelogenesis imperfecta, and DF are commonly seen in dental daily practice, it is extremely important to analyze the literature regarding its treatment.

Restoration of Fluorosis Stained Teeth: A Case Study

Dental fluorosis manifests by too much ingestion of fluoride resulting in disturbances in enamel mineralization. The result is intrinsic discolorations in the maxillary and mandibular teeth with a poor esthetic appearance. In challenging cases, an esthetic result may be achieved only by a combination of techniques. This case report demonstrates a combination of modalities used to treat a patient presenting with atypical staining as a result of high-level exposure to ingested fluoride present in the drinking water as a child. Conservative treatment consisted of a combination of in-office bleaching to reduce the discoloration and porcelain veneers to create an esthetic result.

Microabrasion in tooth enamel discoloration defects: three cases with long-term follow-ups

Superficial irregularities and certain intrinsic stains on the dental enamel surfaces can be resolved by enamel microabrasion, however, treatment for such defects need to be confined to the outermost regions of the enamel surface. Dental bleaching and resin-based composite repair are also often useful for certain situations for tooth color corrections. This article presented and discussed the indications and limitations of enamel microabrasion treatment. Three case reports treated by enamel microabrasion were also presented after 11, 20 and 23 years of follow-ups.

Acceptability, efficacy and safety of two treatment protocols for dental fluorosis: a randomized clinical trial

OBJECTIVES

This parallel randomized clinical trial evaluated the efficacy of two treatments for removing fluorosis stains.

METHODS

Seventy individuals living in an area endemic for fluorosis, with at least four maxillary anterior teeth presenting fluorosis with a Thylstrup and Fejerskov index from 1 to 7, were randomized into two treatment groups (n=35): GI - enamel microabrasion or GII - microabrasion associated with at-home bleaching. Microabrasion was performed using 37% phosphoric acid and pumice and, at-home tooth bleaching was performed with 10% carbamide peroxide. Areas of enamel opacities were recorded by digital camera at baseline and 1-month (1M) after treatment. Two blinded examiners evaluated the reduction in the area (mm(2)) of opacity using software. Two visual analogue scales were used: one for recording tooth sensitivity and/or gingival irritation ranging from 1 (none) to 5 (severe) and the other to evaluate participant satisfaction with the treatment used ranging from 1 (no improvement) to 7 (exceptional improvement).

RESULTS

1M after treatment, both groups showed a significant reduction in the area of enamel opacity (p=0.0001) and there was no difference between groups (p=0.1). Most of the participants from both treatment groups reported no or mild tooth sensitivity and gingival irritation (p>0.05). Participants reported that they were happy with the improvement in dental appearance, however, individuals from GII reported that they were happier than those from GI (p=0.004).

CONCLUSIONS

Both treatment protocols were effective in reducing fluoride stains, however, when home bleaching was associated to enamel microabrasion, patients reported a major satisfaction with dental appearance.