Effect of configuration on the biomechanical performance of three suture materials used in combination with a metallic bone anchor

Effect of cyclic loading on the ultimate tensile strength of small metallic suture anchors used for attaching artificial tendons in rabbits

Background –

Suture anchor failures can lead to revision surgeries which are costly and burdensome for patients. The durability of musculoskeletal reconstructions is therefore partly affected by the design of the suture anchors.

Purpose –

The purpose of the study was to quantify the strength of different suture anchors whose sizes are suitable for attaching artificial Achilles and tibialis cranialis tendons in a rabbit model, as well as determine the effect of cyclic loading on the anchoring strength.

Method –

Four anchors (two with embedded eyelet and two with raised eyelet, n=5 per group) were tested with cyclical loading (1000 cycles and 4.5 mm/sec) and without cycling, to inform the failure loads and mode of failure of the suture anchors. An eyebolt screw with smooth eyelet was used as a control for the test groups.

Results –

All samples in all groups completed 1000 cycles and failed via suture breakage in both test conditions. All anchors had failure loads exceeding the peak Achilles tendon force in rabbits during hopping gait. The data analysis showed an effect of anchor type on the maximum tensile force at failure (F max ) in all suture categories but not an effect of loading condition. Also, the Anika anchor had a significantly less adverse effect on suture strength compared to Arthrex anchor (p=0.015), IMEX anchor (p=0.004) and Jorvet anchor (p<0.001). We observed a greater percentage of failure at the mid-section for the anchors with the raised eyelets compared to the anchors with embedded eyelets, which all failed at the knot.

Conclusion –

Anchors with embedded eyelets had clinically preferred mode of failure with less adverse effects on suture and, may be more reliable than anchors with raised eyelets for attaching artificial Achilles and tibialis cranialis tendons in rabbits.

Does quality of novice hand-tied square knots improve with repetition during a single training session?

Background

Knot tying is a key surgical skill for novices, and repetition over several training sessions improves knot tying. This study examined the effects of repetition within a single training session on quality of knotted loops and compared results of novice trainees and experienced surgeons.

Methods

Using 0.55 mm nylon monofilament fishing line, novices and surgeons each hand-tied 20 knotted loops, using a 2=1=1=1 configuration (surgeon's throw and three square throws). Loops were mechanically tested with a single load to failure.

Results

All loops tolerated five newtons (N) preload. More than 70% of novice and surgeon knots failed by slipping or untying, and 8.8% of novice knots and 2.5% of surgeon's knots were considered dangerous. Surgeons' loops had less extension at preload, indicating better loop security. However, during single test to failure, there was no difference in mean extension or maximum load between surgeons and novices. There was no significant difference in results of mechanical testing or modes of failure for the first and last ten knotted loops, or the first, second, third, and fourth sets of knotted loops.

Discussion

With appropriate training, novices can construct knots as strong and secure as experienced surgeons. A large percentage of knotted loops are insecure under testing conditions; extra throws may be required when using large diameter monofilament nylon. Novices may require extra training in maintenance of loop security when constructing square knots. Tying more than five or 10 knotted loops within a single training session does not provide added benefits for novices.