Voltammetric behavior and quantitative determination of ambazone concentrations in urine and in a pharmaceutical formulation

Highly Sensitive Determination of Tenofovir in Pharmaceutical Formulations and Patients Urine—Comparative Electroanalytical Studies Using Different Sensing Methods

This paper discusses the electrochemical behavior of antiviral drug Tenofovir (TFV) and its possible applicability towards electroanalytical determination with diverse detection strategies using square-wave voltammetry. Namely, oxidation processes were investigated using glassy carbon electrode with graphene oxide surface modification (GO/GCE), while the reduction processes, related to the studied analyte, were analyzed at a renewable silver amalgam electrode (Hg(Ag)FE). Scanning electron microscopy imaging confirmed the successful deposition of GO at the electrode surface. Catalytic properties of graphene oxide were exposed while being compared with those of bare GCE. The resultant modification of GCE with GO enhanced the electroactive surface area by 50% in comparison to the bare one. At both electrodes, i.e., GO/GCE and Hg(Ag)FE, the TFV response was used to examine and optimize the influence of square-wave excitation parameters, i.e., square wave frequency, step potential and amplitude, and supporting electrolyte composition and its pH. Broad selectivity studies were performed with miscellaneous interfering agents influence, including ascorbic acid, selected saccharides and aminoacids, metal ions, non-opioid analgesic metamizole, non-steroidal anti-inflammatory drug omeprazole, and several drugs used along with TFV treatment. The linear concentration range for TFV determination at GO/GCE and Hg(Ag)FE was found to be 0.3–30.0 µmol L^–1 and 0.5–7.0 µmol L^–1, respectively. The lowest LOD was calculated for GO/GCE and was equal to 48.6 nmol L^–1. The developed procedure was used to detect TFV in pharmaceutical formulations and patient urine samples and has referenced utilization in HPLC studies.

Improved electroanalytical characteristics for flumetralin determination in the presence of surface active compound

ABSTRACT

The use of square wave voltammetry (SWV) and square wave adsorptive stripping voltammetry (SWAdSV) in conjunction with a cyclic renewable silver amalgam film electrode for the determination of flumetralin is presented. Poor separation of two overlapped reduction peaks is significantly improved when hexadecyltrimethylammonium bromide is used as a component of the supporting electrolyte solution (together with BR buffer pH 9.5). The SW technique parameters were investigated and found optimal as follows: frequency 50 Hz, amplitude 40 mV, and step potential 5 mV. Accumulation time and potential were studied to select the optimal conditions in adsorptive voltammetry. The analytical curve was linear for the flumetralin concentration range from 1.0 × 10-6 to 1.0 × 10-5 mol dm-3 and from 5.0 × 10-9 to 1.0 × 10-7 mol dm-3 for SWV and SWAdSV, respectively. Detection limit of 6.5 × 10-10 mol dm-3 was calculated for accumulation time 60 s at -0.2 V. The repeatability of the method was determined at a flumetralin concentration level equal to 5.0 × 10-9 mol dm-3 and expressed as %RSD = 5.0% (n = 6). The proposed method was applied and validated successfully by studying the recovery of herbicide content in spiked environmental samples.

GRAPHICAL ABSTRACT