Biodegradation and photo-Fenton degradation of bisphenol A, bisphenol S and fluconazole in water

Bisphenol A, bisphenol S, and fluconazole are ubiquitous environmental pollutants and their removal from water is of utmost importance. As the biodegradation of these compounds is usually not enough effective, often other degradation methods are required. The study presents the difference between biodegradation and photo-Fenton degradation with a much higher efficiency obtained in the latter process. Levels of biodegradation and chemical degradation were assessed based on high-performance liquid chromatography determination. Optimization of the photo-Fenton removal of bisphenol A, bisphenol S, and fluconazole resulted in about 100 % primary degradation of both bisphenols during 10-20 min and almost 90 % primary degradation of fluconazole within an hour. Degradation products formed in the process were identified using liquid chromatography with mass spectrometry and showed central scission of bisphenol S with the formation of phenol and sulfuric acid while for bisphenol A and fluconazole the oxidation resulted in much smaller structural changes.

Removal of Bisphenol A and Its Potential Substitutes by Biodegradation

The possibility of removing bisphenol A and its five potential substitutes (bisphenols S, F, AF, E, and B) was tested using microorganism consortia from river water and activated sludge from municipal and rural wastewater treatment plants. For most bisphenols, biodegradation with activated sludge was faster than with river water and a greater extent of biodegradation was also achieved. However, only bisphenol A and bisphenol F underwent 100% primary biodegradation while other bisphenols degraded no more than about 50% which has some important implications in case of their increased usage. Metabolic activity in biodegradation liquors was also tested and it showed higher activity in the tests with activated sludge than with river water. However, there was no clear connection between the decline of metabolic activity and the extent of biodegradation as decreased activity was observed for two easily degrading bisphenols and two others with little biodegradability. It can be assumed that two different phenomena are involved in this process including depletion of nutrients for easily degradable bisphenol A and absence of nutrients for bacteria incapable of primary degradation of bisphenol AF and bisphenol S.

CATALOGIC 301C model - validation and improvement

In Europe, REACH legislation encourages the use of alternative in silico methods such as (Q)SAR models. According to the recent progress of Chemical Substances Control Law (CSCL) in Japan, (Q)SAR predictions are also utilized as supporting evidence for the assessment of bioaccumulation potential of chemicals along with read across. Currently, the effective use of read across and QSARs is examined for other hazards, including biodegradability. This paper describes the results of external validation and improvement of CATALOGIC 301C model based on more than 1000 tested new chemical substances of the publication schedule under CSCL. CATALOGIC 301C model meets all REACH requirements to be used for biodegradability assessment. The model formalism built on scientific understanding for the microbial degradation of chemicals has a well-defined and transparent applicability domain. The model predictions are adequate for the evaluation of the ready degradability of chemicals.