Controlled porosity osmotic pump system for the delivery of diclofenac sodium: in-vitro and in-vivo evaluation

Redefinition to bilayer osmotic pump tablets as subterranean river system within mini-earth via three-dimensional structure mechanism

Defining and visualizing the three-dimensional (3D) structures of pharmaceuticals provides a new and important tool to elucidate the phenomenal behavior and underlying mechanisms of drug delivery systems. The mechanism of drug release from complex structured dosage forms, such as bilayer osmotic pump tablets, has not been investigated widely for most solid 3D structures. In this study, bilayer osmotic pump tablets undergoing dissolution, as well as after dissolution in a desiccated solid state were examined, and visualized by synchrotron radiation micro-computed tomography (SR-μCT). In situ formed 3D structures at different in vitro drug release states were characterized comprehensively. A distinct movement pattern of NaCl crystals from the push layer to the drug layer was observed, beneath the semi-permeable coating in the desiccated tablet samples. The 3D structures at different dissolution time revealed that the pushing upsurge in the bilayer osmotic pump tablet was directed via peripheral "roadways". Typically, different regions of the osmotic front, infiltration region, and dormant region were classified in the push layer during the dissolution of drug from tablet samples. According to the observed 3D microstructures, a "subterranean river model" for the drug release mechanism has been defined to explain the drug release mechanism.

Preparation and in Vitro Evaluation of Osmotic-Pump Lorcaserin-hydrochloride Controlled-Release Tablets

Long-term and constant-release osmotic-pump lorcaserin hydrochloride controlled-release tablets (OP LH CRTs) were prepared, to investigate the influencing factors of LH release and optimize the formulation. The mechanism of release of LH from OP LH CRTs in vitro was investigated. By establishing a high-efficiency method for measuring LH release in vitro, and optimizing it by single-factor and orthogonal experiments, the best formulation of OP LH CRTs was determined. Then, the optimal prescription of OP LH CRTs was: LH = 20.8 mg; mannitol = 100 mg, microcrystalline cellulose = 125 mg; magnesium stearate = 5 mg; cellulose acetate = 3%; polyethylene glycol 400 = 10%; dibutyl phthalate = 10%; Wetting agent and binder was 3% polyvinyl pyrrolidone (PVP) K30 ethanol solution; aperture diameter = 0.8 mm; the coating gained 3% weight. And finally, prepared OP LH CRTs were released at a constant rate in vitro and sustained for 16 h with good reproducibility between batches. Using an orthogonal experimental design, OP LH CRTs with remarkable zero-order release characteristics within 16 h were obtained, and formulation optimization was realized.