4D Flat Panel Conebeam CTA for In Vivo Imaging of the Microvasculature of the Human Cortex with a Novel Software Prototype

Three-dimensional super resolution ultrasound imaging with a multi-frequency hemispherical phased array

BACKGROUND

High resolution imaging of the microvasculature plays an important role in both diagnostic and therapeutic applications in the brain. However, ultrasound pulse-echo sonography imaging the brain vasculatures has been limited to narrow acoustic windows and low frequencies due to the distortion of the skull bone, which sacrifices axial resolution since it is pulse length dependent.

PURPOSE

To overcome the detect limit, a large aperture 256-module sparse hemispherical transmit/receive array was used to visualize the acoustic emissions of ultrasound-vaporized lipid-coated decafluorobutane nanodroplets flowing through tube phantoms and within rabbit cerebral vasculature in vivo via passive acoustic mapping and super resolution techniques.

METHODS

Nanodroplets were vaporized with 55 kHz burst-mode ultrasound (burst length = 145 μs, burst repetition frequency = 9-45 Hz, peak negative acoustic pressure = 0.10-0.22 MPa), which propagates through overlying tissues well without suffering from severe distortions. The resulting emissions were received at a higher frequency (612 or 1224 kHz subarray) to improve the resulting spatial resolution during passive beamforming. Normal resolution three-dimensional images were formed using a delay, sum, and integrate beamforming algorithm, and super-resolved images were extracted via Gaussian fitting of the estimated point-spread-function to the normal resolution data.

RESULTS

With super resolution techniques, the mean lateral (axial) full-width-at-half-maximum image intensity was 16 ± 3 (32 ± 6) μm, and 7 ± 1 (15 ± 2) μm corresponding to ∼1/67 of the normal resolution at 612 and 1224 kHz, respectively. The mean positional uncertainties were ∼1/350 (lateral) and ∼1/180 (axial) of the receive wavelength in water. In addition, a temporal correlation between nanodroplet vaporization and the transmit waveform shape was observed, which may provide the opportunity to enhance the signal-to-noise ratio in future studies.

CONCLUSIONS

Here, we demonstrate the feasibility of vaporizing nanodroplets via low frequency ultrasound and simultaneously performing spatial mapping via passive beamforming at higher frequencies to improve the resulting spatial resolution of super resolution imaging techniques. This method may enable complete four-dimensional vascular mapping in organs where a hemispherical array could be positioned to surround the target, such as the brain, breast, or testicles.

4D-DSA for Assessment of the Angioarchitecture and Grading of Cranial Dural AVF

BACKGROUND AND PURPOSE

Time-resolved 3D rotational angiography (4D-DSA) has been used to demonstrate details of the angioarchitecture of AVM, whereas it has rarely been used to describe features of dural AVF. In this exploratory study, we analyzed dural AVFs with a novel 4D software prototype, developed and provided by Siemens, to determine whether identification of the location of the fistulous point, grading, and treatment planning were feasible.

MATERIALS AND METHODS

4D-DSA volumes were calculated from existing 3D rotational angiography data sets of patients with dural AVFs. The 4D-DSA volumes were displayed in a virtual DSA mode and MPR or MIP in 3 orthogonal planes and compared with 2D-DSA by 2 experienced neuroradiologists. Fusions with unenhanced CT or MR images were used to improve visualization of adjacent anatomic structures.

RESULTS

Comparison with 2D-DSA showed that evaluation of the fistulous point and grading according to the classification of Borden, Cognard, or Barrow was feasible in 26 of 27 cases. In 8 of 27 cases, 4D-DSA was considered advantageous for determining the fistulous point and the course of the draining vein in the dural AVF with cortical venous drainage, especially in the frontoethmoidal and frontoparietal regions. In 6 cases, the display of angioarchitecture was considered inferior to that of 2D-DSA due to motion artifacts, suboptimal selection of the injected vessel, and lack of temporal resolution.

CONCLUSIONS

Detailed analysis of dural AVFs according to the standardized display of 4D-DSA volumes was feasible and helpful in understanding the angioarchitecture in selected cases. Further improvement and validation of the 4D software should solidify the complementary role of 4D-DSA to conventional 2D-DSA series.

Flat-panel conebeam CT in the clinic: history and current state

Research into conebeam CT concepts began as soon as the first clinical single-slice CT scanner was conceived. Early implementations of conebeam CT in the 1980s focused on high-contrast applications where concurrent high resolution ( < 200    μ m ), for visualization of small contrast-filled vessels, bones, or teeth, was an imaging requirement that could not be met by the contemporaneous CT scanners. However, the use of nonlinear imagers, e.g., x-ray image intensifiers, limited the clinical utility of the earliest diagnostic conebeam CT systems. The development of consumer-electronics large-area displays provided a technical foundation that was leveraged in the 1990s to first produce large-area digital x-ray detectors for use in radiography and then compact flat panels suitable for high-resolution and high-frame-rate conebeam CT. In this review, we show the concurrent evolution of digital flat panel (DFP) technology and clinical conebeam CT. We give a brief summary of conebeam CT reconstruction, followed by a brief review of the correction approaches for DFP-specific artifacts. The historical development and current status of flat-panel conebeam CT in four clinical areas-breast, fixed C-arm, image-guided radiation therapy, and extremity/head-is presented. Advances in DFP technology over the past two decades have led to improved visualization of high-contrast, high-resolution clinical tasks, and image quality now approaches the soft-tissue contrast resolution that is the standard in clinical CT. Future technical developments in DFPs will enable an even broader range of clinical applications; research in the arena of flat-panel CT shows no signs of slowing down.

4D-DSA: Development and Current Neurovascular Applications

Originally described by Davis et al in 2013, 4D-Digital Subtraction Angiography (4D-DSA) has developed into a commercially available application of DSA in the angiography suite. 4D-DSA provides the user with 3D time-resolved images, allowing observation of a contrast bolus at any desired viewing angle through the vasculature and at any time point during the acquisition (any view at any time). 4D-DSA mitigates some limitations that are intrinsic to both 2D- and 3D-DSA images. The clinical applications for 4D-DSA include evaluations of AVMs and AVFs, intracranial aneurysms, and atherosclerotic occlusive disease. Recent advances in blood flow quantification using 4D-DSA indicate that these data provide both the velocity and geometric information necessary for the quantification of blood flow. In this review, we will discuss the development, acquisition, reconstruction, and current neurovascular applications of 4D-DSA volumes.