Theoretical models in mechanics of the left ventricle

In vivo epicardial force and strain characterisation in normal and MLP-knockout murine hearts

The study's objective is to quantify in vivo epicardial force and strain in the normal and transgenic myocardium using microsensors.Male mice (n = 39), including C57BL/6 (n = 26), 129/Sv (n = 5), wild-type (WT) C57  ×  129Sv (n = 5), and muscle LIM protein (MLP) knock-out (n = 3), were studied under 1.5% isoflurane anaesthesia. Microsurgery allowed the placement of two piezoelectric crystals at longitudinal epicardial loci at the basal, middle, and apical LV regions, and the independent (and/or concurrent) placement of a cantilever force sensor. The findings demonstrate longitudinal contractile and relaxation strains that ranged between 4.8-9.3% in the basal, middle, and apical regions of C57BL/6 mice, and in the mid-ventricular regions of 129/Sv, WT, and MLP mice. Measured forces ranged between 3.1-8.9 mN. The technique's feasibility is also demonstrated in normal mice following afterload, occlusion-reperfusion challenges.Furthermore, the total mid-ventricular forces developed in MLP mice were significantly reduced compared to the WT controls (5.9  ±  0.4 versus 8.9  ±  0.2 mN, p < 0.0001), possibly owing to the fibrotic and stiffer myocardium. No significant strain differences were noted between WT and MLP mice.The possibility of quantifying in vivo force and strain from the normal murine heart is demonstrated with a potential usefulness in the characterisation of transgenic and diseased mice, where regional myocardial function may be significantly altered.

Computerized 2-lead resting ECG analysis for the detection of relevant coronary artery stenosis in comparison with angiographic findings

To assess the sensitivity and specificity of a new computer-enhanced resting electrocardiographic analysis device for the detection of coronary stenosis, 189 patients (aged 61.3+/-12.9 years, 57 women) scheduled for coronary angiography from 4 Asian centers were included in an observational study. Angiographic results were independently classified for hemodynamically relevant stenosis by 2 angiographers. The device calculated a severity score from 0 to 20. The score was significantly higher for patients with coronary stenosis (5.4+/-1.8 vs 1.7+/-2.1). The study device (cutoff 4.0) identified 73 of 77 patients with stenosis (sensitivity 94.8%, specificity 86.6%). Adjusted positive and negative predictive values were 78.4% and 97.1%, respectively (receiver operating characteristic area under the curve, 0.914 [95% confidence interval, 0.868-0.961]). Subgroup analysis showed no significant influence of sex, age, previous revascularization procedures, or participating center. The new computer-enhanced, resting electrocardiographic analysis device appears to identify patients with relevant coronary stenosis with high sensitivity and specificity.

Computerized two-lead resting ECG analysis for the detection of coronary artery stenosis

BACKGROUND

Resting electrocardiogram (ECG) shows limited sensitivity and specificity for the detection of coronary artery disease (CAD). Several methods exist to enhance sensitivity and specificity of resting ECG for diagnosis of CAD, but such methods are not better than a specialist's judgement. We compared a new computer-enhanced, resting ECG analysis device, 3DMP, to coronary angiography to evaluate the device's accuracy in detecting hemodynamically relevant CAD.

METHODS

A convenience sample of 423 patients without prior coronary revascularization was evaluated with 3DMP before coronary angiography. 3DMP's sensitivity and specificity in detecting hemodynamically relevant coronary stenosis as diagnosed with coronary angiography were calculated as well as odds ratios for the 3DMP severity score and coronary artery disease risk factors.

RESULTS

3DMP identified 179 of 201 patients with hemodynamically relevant stenosis (sensitivity 89.1%, specificity 81.1%). The positive and negative predictive values for identification of coronary stenosis as diagnosed in coronary angiograms were 79% and 90% respectively. CAD risk factors in a logistic regression model had markedly lower predictive power for the presence of coronary stenosis in patients than did 3DMP severity score (odds ratio 3.35 [2.24-5.01] vs. 34.87 [20.00-60.79]). Logistic regression combining severity score with risk factors did not add significantly to the prediction quality (odds ratio 36.73 [20.92-64.51]).

CONCLUSIONS

3DMP's computer-based, mathematically derived analysis of resting two-lead ECG data provides detection of hemodynamically relevant CAD with high sensitivity and specificity that appears to be at least as good as those reported for other resting and/or stress ECG methods currently used in clinical practice.

On the uniqueness of quasi-static solutions of some linear models of left ventricular mechanics

We review two models describing the material properties of heart muscle: the fluid-fiber model and the fluid-fiber-collagen model. We show that the fluid-fiber description gives rise to non-uniqueness when used in ventricular modeling while the fluid-fiber-collagen description does not. We derive a general cavity pressure-volume relation for an extended class family of linear models of the heart's left ventricle.

Residual strain in rat left ventricle

Residual stress in an organ is defined as the stress that remains when all external loads are removed. Residual stress has generally been ignored in published papers on left ventricular wall stress. To take residual stress into account in the analysis of stress distributions in a beating heart, one must first measure the residual strain in the no-load state of the heart. Residual strains in equatorial cross-sectional rings (2-3 mm thick) of five potassium-arrested rat left ventricles were measured. The effects of friction and external loading were reduced by submersing the specimen in fluid, and a hypothermic, hyperkalemic arresting solution containing nifedipine and EGTA was used to delay the onset of ischemic contracture. Stainless steel microspheres (60-100 microns) were lightly imbedded on the surface of the slices, and the coordinates of the microspheres were digitized from photographs taken before and after a radial cut was made through the left ventricular free wall. Two-dimensional strains computed from the deformation of a slice after one radial cut were defined as the residual strains in that slice. It was found that the distributions of the principal residual stretch ratios were asymmetric with respect to the radial cut: in areas where substantial transmural strain gradients existed, the distributions of strain components were different on the two sides of the radial cut. A second radial cut produced deformations significantly smaller than those produced from the first radial cut. Hence, a slice with one radial cut may be considered stress free.(ABSTRACT TRUNCATED AT 250 WORDS)

Effects of collagen microstructure on the mechanics of the left ventricle

The microstructure of the collagen sheath or weave surrounding a myocyte and the collagen struts interconnecting neighboring myocytes is incorporated into a fluid-fiber-collagen continuum description of the myocardium. The sheaths contribute to anisotropic elasticity, whereas the struts contribute to an isotropic component. Elastic moduli of the composite myocyte-sheath complex and the strut matrix are estimated from existing passive biaxial loading data from sheets of canine myocardium. The contribution of the sheath to the elasticity of the myocyte-sheath complex is critically dependent on the helical pitch angle. Calculations for a cylindrical model of the left ventricle using both a fluid-fiber and fluid-fiber-collagen stress tensor show that the collagen strut matrix tends to limit muscle fiber lengthening; increase myocardial tissue pressure during systole, with endocardial tissue pressure exceeding left ventricular pressure; decrease tissue pressure during diastole, and thus facilitate myocardial blood flow; and aid filling during ventricular relaxation by providing a suction effect that relies on a release of stored elastic energy from the previous contraction. Calculations show that this energy is stored mostly in the collagen struts.