Respiratory Specimen Collection Booth for COVID-19 Test: Efficiency Based Newly Introduced Facility

Designing 3D-Printed Mesh-Covered Fluid Collecting Racks (MFCRs) to Prevent Moisture-Related COVID-19 Sampling Interruptions in Taiwan

Background: A sampling platform (or table) set at the patient's side in a zero-exposure screening center (booth) might be used for specimen collection during public health crises such as the COVID-19 pandemic. However, repeated sanitization causes moisture problems. Such moisture problems would not only be noted by patients but also interrupt the sampling process. In this study, we aimed to develop 3D-printed mesh-covered fluid collecting racks (MFCRs) to address surface moisture problems to determine whether MFCRs can shorten the sampling time. Methods: This was an observational, descriptive, and cross-sectional study. We observed the reasons for sampling interruptions related to surface moisture problems among patients who used MFCRs or did not (April 28-30, 2022). We used a 3D printer to make an MFCR, which measured 14.5 cm in width and length and 1.0 cm in height. The MFCR allows the ethanol to drain through the mesh into the fluid collection rack below to leave a relatively dry surface on the mesh. Finally, we calculated the median time to finish sampling between MFCRs and non-MFCRs. Results: A total of 400 patients were randomly observed (using MFCRs, n = 200; non-MFCRs, n = 200). Patients in the non-MFCR group were more likely to interrupt the sampling process (n = 39, 19.5%) by noting surface moisture problems than those in the MFCR group (n = 3, 1.5%). Two of the major interruptions, "asking questions about the moist surface" (from 12% to 1%) and "slowing down their actions" (from 4.5% to 0.5%), were obviously improved by using MFCRs. Overall, the median sampling time was significantly shorter (p < 0.001) in the group using MFCRs (0.6 min) than in the group using non-MFCRs (1.5 min). The MFCRs shortened the sampling time by 60%, which might be associated with decreasing interruptions caused by surface moisture problems. Conclusions: The 3D printed MFCRs are suitable for handling surface moisture problems caused by repeated sanitizations. More importantly, the MFCRs might be associated with decreasing interruptions caused by moisture problems.

Applications of laboratory findings in the prevention, diagnosis, treatment, and monitoring of COVID-19

The worldwide pandemic of coronavirus disease 2019 (COVID-19) presents us with a serious public health crisis. To combat the virus and slow its spread, wider testing is essential. There is a need for more sensitive, specific, and convenient detection methods of the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Advanced detection can greatly improve the ability and accuracy of the clinical diagnosis of COVID-19, which is conducive to the early suitable treatment and supports precise prophylaxis. In this article, we combine and present the latest laboratory diagnostic technologies and methods for SARS-CoV-2 to identify the technical characteristics, considerations, biosafety requirements, common problems with testing and interpretation of results, and coping strategies of commonly used testing methods. We highlight the gaps in current diagnostic capacity and propose potential solutions to provide cutting-edge technical support to achieve a more precise diagnosis, treatment, and prevention of COVID-19 and to overcome the difficulties with the normalization of epidemic prevention and control.