Digital Workflow for the Design, Manufacture, and Application of Custom-Made Short Implants With Wing Retention Device

Assessment of the osteogenic effect after maxillary sinus floor elevation and simultaneous implantation with or without bone grafts by analyzing trabecular bone parameters: a retrospective study

OBJECTIVE

The aim of this population-based retrospective study was to compare the osteogenic effect of newly formed bone after maxillary sinus floor elevation (MSFE) and simultaneous implantation with or without bone grafts by quantitatively analyzing trabecular bone parameters.

METHODOLOGY

A total of 100 patients with missing posterior maxillary teeth who required MSFE and implantation were included in this study. Patients were divided into two groups: the non-graft group (n=50) and the graft group (n=50). Radiographic parameters were measured using cone beam computed tomography (CBCT), and the quality of newly formed bone was analyzed by assessing trabecular bone parameters using CTAn (CTAnalyzer, SkyScan, Antwerp, Belgium) software.

RESULTS

In the selected regions of interest, the non-graft group showed greater bone volume/total volume (BV/TV), bone surface/total volume (BS/TV), trabecular number (Tb. N), and trabecular thickness (Tb. Th) than the graft group (p<0.001). The non-graft group showed lower trabecular separation (Tb. Sp) than the graft group (p<0.001). The incidence of perforation and bleeding was higher in the graft group than in the non-graft group (p<0.001), but infection did not significantly differ between groups (p>0.05). Compared to the graft group, the non-graft group showed lower postoperative bone height, gained bone height and apical bone height (p<0.001).

CONCLUSION

MSFE with and without bone grafts can significantly improve bone formation. In MSFE, the use of bone grafts hinders the formation of good quality bone, whereas the absence of bone grafts can generate good bone quality and limited bone mass.

Biomechanical evaluation of custom-made short implants with wing retention applied in severe atrophic maxillary posterior region restoration: A three-dimensional finite element analysis

Severe bone atrophy in the maxillary posterior region poses a big challenge to implant restoration. Digitally designed and customized short implants with wing retention provide a safer and minimally invasive implant restoration scheme in such circumstances. Small titanium wings are integrated with the short implant supporting the prosthesis. Using digital designing and processing technology, the wings fixed by titanium screws can be flexibly designed, providing the main fixation. The design of the wings will influence the stress distribution and implant stability. This study analyzes the position, structure, and spread area of the wings fixture scientifically by means of three-dimensional finite element analysis. The design of the wings is set to linear, triangular, and planar styles. Under the simulated vertical and oblique occlusal forces, the implant displacement and stress between the implant and the bone surface are analyzed at different bone heights of 1 mm, 2 mm, and 3 mm. The finite element results show that the planar form can better disperse the stress. By adjusting the cusp slope to reduce the influence of lateral force, short implants with planar wing fixtures can be used safely even if the residual bone height is only 1 mm. The results of the study provide a scientific basis for the clinical application of this new customized implant.