Boosting the H2 Production Efficiency via Photocatalytic Organic Reforming: The Role of Additional Hole Scavenging System

Visible light induced degradation of perfluorooctanoic acid using iodine deficient bismuth oxyiodide photocatalyst

A bismuth oxyiodide photocatalyst having coexistent iodine deficient phases viz. Bi₄O₅I₂ and Bi₅O₇I was prepared by using a solvothermal method followed by calcination process. This has been used for the degradation of model perfluoroalkyl acids such as perfluorooctanoic acid at low concentrations (1 ppm) under simulated solar light irradiation. 94% PFOA degradation with a rate constant of 1.7 h^-1 and 65% defluorination of PFOA have been achieved following 2 h of photocatalysis. The degradation of PFOA happened by the parallel direct redox reactions with high energy photoexcited electrons at the conduction band, electrons in iodine vacancies and superoxide radicals. The degradation intermediates were analyzed by electrospray ionization-mass spectrometry in the negative mode. The catalyst was converted to a more iodine deficient Bi₅O₇I phase during photocatalysis following creation of iodine vacancies, some of which were compensated by the fluoride ions released from degraded PFOA.

Synergistic Effects of AgNPs and Biochar: A Potential Combination for Combating Lung Cancer and Pathogenic Bacteria

The synthesis of reliable biological nanomaterials is a crucial area of study in nanotechnology. In this study, Emericella dentata was employed for the biosynthesis of AgNPs, which were then combined with synthesized biochar, a porous structure created through biomass pyrolysis. The synergistic effects of AgNPs and biochar were evaluated through the assessment of pro-inflammatory cytokines, anti-apoptotic gene expression, and antibacterial activity. Solid biosynthesized AgNPs were evaluated by XRD and SEM, with SEM images revealing that most of the AgNPs ranged from 10 to 80 nm, with over 70% being less than 40 nm. FTIR analysis indicated the presence of stabilizing and reducing functional groups in the AgNPs. The nanoemulsion's zeta potential, hydrodynamic diameter, and particle distribution index were found to be -19.6 mV, 37.62 nm, and 0.231, respectively. Biochar, on the other hand, did not have any antibacterial effects on the tested bacterial species. However, when combined with AgNPs, its antibacterial efficacy against all bacterial species was significantly enhanced. Furthermore, the combined material significantly reduced the expression of anti-apoptotic genes and pro-inflammatory cytokines compared to individual treatments. This study suggests that low-dose AgNPs coupled with biochar could be a more effective method to combat lung cancer epithelial cells and pathogenic bacteria compared to either substance alone.

One Stone Two Birds: Utilization of Solar Light for Simultaneous Selective Phenylcarbinol Oxidation and H2 Production over 0D/2D-3D Pt/In2S3 Schottky Junction

Precise regulation and control solar-light-driven charges photoexcited on photocatalysts for separation-transfer and target redox reactions is an attractive and challenging pathway toward sustainability. Herein, 0D/2D-3D Pt/In2S3 Schottky junction was fabricated for simultaneous selective phenylcarbinol conversion into value-added aldehydes and production of clean energy H2 by directly utilizing photoexcited holes and electrons in one reaction system under mild reaction conditions. In contrast to pure water splitting and pure In2S3, the reaction thermodynamics and kinetics of H2 evolution on the Pt/In2S3 were significantly enhanced. The optimized 0.3% Pt/In2S3 exhibited the highest and most stable photocatalytic activity with 22.1 mmol g−1 h−1 of H2 production rate and almost 100% selectivity of benzaldehyde production. Notably, this dual-function photocatalysis also exhibited superiority in contrast to sacrificial-agent H2 evolution reactions such as lactic acid, Na2S, methanol and triethanolamine. The turnover frequency (TOF) could reach up to ~2394 h−1. The Pt clusters anchored at the electron location and strong metal-support interactions (SMSI) between Pt and In2S3 synergistically improved the spatial charge separation and directional transportation (~90.1% of the charge transport efficiency could be achieved over the Pt/In2S3 hybrid), and thus result in significant enhancement of photocatalytic H2 evolution with simultaneous benzaldehyde production.

Linkage-Affected Donor–Acceptor Covalent Organic Frameworks for Photocatalytic Hydrogen Production

The depletion of traditional fossil energy and the resulting environmental pollution forces people to explore new energy sources. Direct use of solar energy is now a viable solution for solving these problems. Covalent organic frameworks (COFs) are a porous crystalline material; their well-defined two-dimensional or three-dimensional frameworks can ensure the orderly arrangement of photoelectric active units, giving them potential photoelectric conversion applications. The tunable structural features endow COFs many advantages in photocatalytic hydrogen production under visible light. This review comprehensively summarizes the research progress on photoelectronic donor–acceptor (D-A) COFs with tunable structure for photocatalytic hydrogen evolution and will provide a feasible guiding strategy for applying this type of COFs in photocatalytic hydrogen production.

Al-Dalain S, Al-Dmour R, Alahmad A, Batarseh MI. Accumulation, Source Identification, and Cancer Risk Assessment of Polycyclic Aromatic Hydrocarbons (PAHs) in Different Jordanian Vegetables

The accumulation of polyaromatic hydrocarbons in plants is considered one of the most serious threats faced by mankind because of their persistence in the environment and their carcinogenic and teratogenic effect on human health. The concentrations of sixteen priority polycyclic aromatic hydrocarbons (16 PAHs) were determined in four types of edible vegetables (tomatoes, zucchini, eggplants, and cucumbers), irrigation water, and agriculture soil, where samples were collected from the Jordan Valley, Jordan. The mean total concentration of 16 PAHs (∑16PAHs) ranged from 10.649 to 21.774 µg kg−1 in vegetables, 28.72 µg kg−1 in soil, and 0.218 µg L−1 in the water samples. The tomato samples posed the highest ∑16PAH concentration level in the vegetables, whereas the zucchini samples had the lowest. Generally, the PAHs with a high molecular weight and four or more benzene rings prevailed among the studied samples. The diagnostic ratios and the principal component analysis (PCA) revealed that the PAH contamination sources in soil and vegetables mainly originated from a pyrogenic origin, traffic emission sources, and biomass combustion. The bioconcentration factors (BCF) for ∑16PAHs have been observed in the order of tomatoes > cucumbers and eggplants > zucchini. A potential cancer risk related to lifetime consumption was revealed based on calculating the incremental lifetime cancer risk of PAHs (ILCR). Therefore, sustainable agricultural practices and avoiding biomass combusting would greatly help in minimizing the potential health risk from dietary exposure to PAHs.

Commemorative Issue in Honor of Professor Gerhard Ertl on the Occasion of His 85th Birthday

This Special Issue (SI) is dedicated to Professor Gerhard Ertl on his eighty-fifth birthday [...]

Selective reduction of nitrate to nitrogen by Fe0-Cu0-CuFe2O4 composite coupled with carbon dioxide anion radical under UV irradiation

Zero-valent iron (Fe⁰) has been widely used for the reduction of nitrate, but the end reduction product is mainly ammonium. Here, a novel strategy for selective reduction of nitrate (NO₃^-) to nitrogen gas (N₂) with high efficiency and N₂ selectivity was investigated using Fe-based material (Fe⁰-Cu⁰-CuFe₂O₄) combined with citric acid (CA) and ultraviolet (UV) irradiation. In this strategy, the nitrate was firstly reduced to nitrite (NO₂^-) by Fe⁰-Cu⁰-CuFe₂O₄/UV process, and then the produced NO₂^- could be further reduced to N₂ by carbon dioxide anion radicals (CO₂^•-) which was generated from CA that was added later. In this process, the selective reduction of NO₃^- to NO₂^- was a key step. For this purpose, we synthesized Fe⁰-Cu⁰-CuFe₂O₄ composite by simple chemical replacement and in-situ growth process, which made it have a delicate structure with good contact between Cu and Fe and CuFe₂O₄. The selective reduction of NO₃^- to NO₂^- in Fe⁰-Cu⁰-CuFe₂O₄/UV process was due to that the Cu⁰ was the electron enrichment center and the photo-generated hole could suppress the NO₃^- reduction to NH₄⁺ by Fe²⁺. In this proposed strategy, 100% NO₃^- removal efficiency and 96.3% N₂ selectivity were achieved when the initial NO₃^- concentration was 30 mg N/L and the reduction time was 60 min. The denitrification mechanism of the Fe⁰-Cu⁰-CuFe₂O₄/UV/CA system was proposed.

The Role of Metal Nanoparticles in Promoting Photocatalysis by TiO2

In this review, we highlight the role played by metal nanoparticles (NPs) in photocatalytic oxidation with titania as a support. This is presented in two parts, namely, partial photo-oxidation in which an organic sacrificial agent is oxidised in anaerobic conditions to produce hydrogen (photo-reforming), and photo-oxidative mineralisation of organics in aerobic conditions. We present some rules for such reactions that dictate which organic molecules can react readily, and which metals are likely to be useful for such reactions. Generally, the presence of metal NPs enhances enormously the ability of titania to yield hydrogen from photo-reforming, and a wide range of molecules can be used, including biomass. The metal NPs most used are those that are easily reduced, that is, the precious metals. The large enhancement in rate seen with metal for hydrogen production is not so extreme for the oxidation reactions, but is still significant. An important factor in all of this catalysis is the nature of the interaction between the metal NPs, which can play a multiplicity of chemical and electronic roles, and the photoactive support. A sharp dependency of rate on loading of metal is found, with maximum rates at ~0.5–2 wt% loading, depending on the metal used. The source of this dependency is the bifunctional nature of the system, in which the intimacy of both materials is crucial to performance. This rate variation is linked to the interface between the two, which is then linked to the size of the metal NPs. In fact, the rate is proportional to an area adjacent to the metal particles that we call the expanding photocatalytic area and overlap (EPAO) kinetic model. This model describes the dependence well. Rising rates with increasing coverage of particles is associated with increase in this total area but, at the maximum, these areas overlap and at higher loadings the available active area diminishes, reproducing the observed behaviour well.

Application of EPR Spectroscopy in TiO2 and Nb2O5 Photocatalysis

The interaction of light with semiconducting materials becomes the center of a wide range of technologies, such as photocatalysis. This technology has recently attracted increasing attention due to its prospective uses in green energy and environmental remediation. The characterization of the electronic structure of the semiconductors is essential to a deep understanding of the photocatalytic process since they influence and govern the photocatalytic activity by the formation of reactive radical species. Electron paramagnetic resonance (EPR) spectroscopy is a unique analytical tool that can be employed to monitor the photoinduced phenomena occurring in the solid and liquid phases and provides precise insights into the dynamic and reactivity of the photocatalyst under different experimental conditions. This review focus on the application of EPR in the observation of paramagnetic centers formed upon irradiation of titanium dioxide and niobium oxide photocatalysts. TiO2 and Nb2O5 are very well-known semiconductors that have been widely used for photocatalytic applications. A large number of experimental results on both materials offer a reliable platform to illustrate the contribution of the EPR studies on heterogeneous photocatalysis, particularly in monitoring the photogenerated charge carriers, trap states, and surface charge transfer steps. A detailed overview of EPR-spin trapping techniques in mechanistic studies to follow the nature of the photogenerated species in suspension during the photocatalytic process is presented. The role of the electron donors or the electron acceptors and their effect on the photocatalytic process in the solid or the liquid phase are highlighted.