Bisphenol S Adsorption Behavior on Ferralsol and Biochar Modified Soil with Dissolved Organic Matter

The epidemiology of cryptorchidism and potential risk factors, including endocrine disrupting chemicals

Congenital cryptorchidism, also known as undescended testis, is the condition where one or both testes are not in place in the scrotum at birth and is one of the most common birth defects in boys. Temporal trends and geographic variation in the prevalence of cryptorchidism from 1% to 9% have been reported in prospective cohort studies. The testes develop in the abdominal cavity and descend to the scrotum in two phases, which should be completed by gestational week 35. Thus, the risk of cryptorchidism is higher in preterm boys. In many cases a spontaneous descent occurs during the first months of life during the surge of gonadotropins and testosterone. If not, the testis is usually brought down to the scrotum, typically by surgery, to increase future fertility chances and facilitate cancer surveillance. The increasing frequency of impaired semen quality and testicular cancer, with which cryptorchidism is associated, represents a concern for male reproductive health in general and a need to understand its risk factors. The risk of cryptorchidism is closely related to gestational factors (preterm birth, low birth weight and intrauterine growth restriction), and especially maternal smoking seems to be a risk factor. Evidence is accumulating that the increasing prevalence of cryptorchidism is also related to prenatal exposure to environmental chemicals, including endocrine disrupting compounds. This association has been corroborated in rodents and supported by ecological studies. Conducting human studies to assess the effect of endocrine disrupting chemicals and their interactions is, however, challenged by the widespread concomitant exposure of all humans to a wide range of chemicals, the combined effect of which and their interactions are highly complex.

Effect of interaction between dissolved organic matter and iron/manganese (hydrogen) oxides on the degradation of organic pollutants by in-situ advanced oxidation techniques

Iron and manganese (hydrogen) oxides (IMHOs) exhibit excellent redox capabilities for environmental pollutants and are commonly used in situ chemical oxidation (ISCO) technologies for the degradation of organic pollutants. However, the coexisting dissolved organic matter (DOMs) in surface environments would influence the degradation behavior and fate of organic pollutants in IMHOs-based ISCO. This review has summarized the interactions and mechanisms between DOMs and IMHOs, as well as the properties of DOM-IMHOs complexes. Importantly, the promotion or inhibition impact of DOM was discussed from three perspectives. First, the presence of DOMs may hinder the accessibility of active sites on IMHOs, thus reducing their efficiency in degrading organic pollutants. The formation of compounds between DOMs and IMHOs alters their stability and activity in the degradation process. Second, the presence of DOMs may also affect the generation and transport of active species, thereby influencing the oxidative degradation process of organic pollutants. Third, specific components within DOMs also participate and affect the degradation pathways and rates. A comprehensive understanding of the interaction between DOMs and IMHOs helps to better understand and predict the degradation process of organic pollutants mediated by IMHOs in real environmental conditions and contributes to the further development and application of IMHO-mediated ISCO technology.

Assessment of potential mobility of selected micropollutants in agricultural soils of the Czech Republic using their sorption predicted from soil properties

The sorption of organic contaminants in soils and sediment is a crucial factor affecting their mobility in the vadose zone environment. The Freundlich sorption isotherms were evaluated for eleven micropollutants and eight soils. The highest Freundlich sorption coefficients, K_F, were obtained for triclosan (324 ± 153 cm^3/nμg^1-1/ng^-1) followed by sertraline (120 ± 74), venlafaxine (74.3 ± 41.2), telmisartan (33.3 ± 13.6), atorvastatin (8.66 ± 4.78), bisphenol S (8.03 ± 4.87), lamotrigine (6.92 ± 3.02), 2-phenylbenzimidazole-5-sulfonic acid (3.77 ± 2.25), memantine (3.42 ± 1.64), 1-methyl-1H-benzotriazole (2.05 ± 0.99), and valsartan (0.88 ± 0.89). The K_F values for the individual compounds were correlated with soil properties. Multiple linear regressions were used to derive equations for predicting the K_F values using the soil properties. The first set of equations contained mainly properties with the strongest correlations with the K_F values, e.g., a base cation saturation for positively charged compounds or a hydrolytic acidity for negatively charged compounds. The second set of equations contained properties included in the map of agricultural soils of the Czech Republic. These equations always indicated positive correlations with oxidizable organic carbon and clay content. They also included either a negative or positive correlation with pH_KCl. A positive correlation with pH_KCl was obtained for venlafaxine, memantine, and sertraline, which were mostly positively charged. A negative correlation with pH_KCl was obtained for the remaining compounds. The second set of equations, the soil map, and the database of soil properties were used to predict the K_F value distributions within the Czech agricultural soils. It resulted in similar K_F distributions' patterns for valsartan, lamotrigine, atorvastatin, and telmisartan (with a positive correlation between K_F and hydrolytic acidity), which considerably differed from the K_F patterns for the other compounds. These maps were used to delineate areas with a leaching potential of the compounds toward groundwater that will serve as a tool for assessing a potential groundwater vulnerability.

Remarkable adsorbent for removal of bisphenol A and S from water: Porous carbon derived from melamine/polyaniline

Recently, contamination of water resources with various organics such as bisphenols is a problem worldwide. Here, we developed nitrogen-enriched porous carbons (N-PDCs) from pyrolysis of melamine-loaded polyaniline (PANI), for the first time. The N-PDCs and PANI-derived carbons (PDCs, without using melamine) were characterized and applied in adsorptive removal of two typical bisphenols, such as bisphenol A and S (BPA and BPS, respectively), from water under a wide range of conditions. Via this research, we found that one N-PDC (N-PDC-700, obtained at 700 °C) showed very remarkable performances in adsorption of BPA (Q₀: 961 mg/g) and BPS (Q₀: 971 mg/g) under pH of 7.0. In other words, N-PDC-700 has Q₀ value for BPS around 2 times as much as that of the most effective adsorbent, MIL-101-NH₂. Moreover, the Q₀ value of N-PDC-700 for BPA is the second highest, after the sp² C dominant N-doped carbon. The plausible adsorption mechanism could be suggested based on the adsorption of BPA under a wide range of pH values. Finally, the N-PDC-700 was easily recycled for several uses, suggesting the potential application in adsorption of bisphenols from water.

Adsorption of emerging contaminants from water and wastewater by modified biochar: A review

Emerging contaminants (ECs), a group of relatively low-concentration but high-toxicity pollutants in the environment, have attracted widespread attention in recent years. These trace pollutants can be enriched in organisms and finally transferred to human bodies, posing a potential hazard to public health. Biochar, a low-cost and high-efficiency adsorbent, has been used to treat ECs in water. However, due to certain limitations of pristine biochar, such as poor adsorption capacity, narrow adsorption range, and other shortcomings, it is necessary to modify biochar to improve its applications in water treatment for ECs. Currently, there are a lot of reports on the removal of ECs from water by modified biochar. These studies explored different modification methods to functionalize biochar with various physicochemical properties, which resulted in distinct adsorption effects, behaviors and mechanisms of modified biochar on different ECs. There is a need to systematically review and digest the knowledge on the adsorption of ECs on modified biochar. In this review, recent biochar modification methods used in ECs removal are firstly summarized, and the adsorption performance and mechanisms of modified biochar on typical ECs are then systematically reviewed. Finally, the main research directions and trends, as well as recommendations and suggestions for future development are pointed out.

Experimental Investigation of Consolidation Properties of Nano-Bentonite Mixed Clayey Soil

As a new soil improvement method, adding nano-bentonite can enhance the engineering properties of soil. To study the stabilization effect of nano-bentonite on soil consolidation properties, a series of one-dimensional odometer tests were conducted on a clayey soil with different nano-bentonite mixing contents (i.e., 0.5%, 1%, 1.5%, and 2%). The effects of nano-bentonite on the coefficient of consolidation and permeability of the test soil were analyzed. The results show that adding a certain amount of nano-bentonite does not significantly affect the original consolidation characteristics of soil samples, but displays a notable effect on accelerating water drainage. Among all the soil samples, when the nano-bentonite mixing content is 0.5%, the final compression amount is the largest and the final void ratio is the smallest. The coefficients of consolidation and permeability increase with increasing nano-bentonite mixing content under high stress state. The test results indicate that nano-bentonite can facilitate internal cementation of soil particles, which effectively reduces the compressibility of clayey soil.

Bisphenols as a Legacy Pollutant, and Their Effects on Organ Vulnerability

Bisphenols are widely used in the synthesis of polycarbonate plastics, epoxy resins, and thermal paper, which are used in manufacturing items of daily use. Packaged foods and drinks are the main sources of exposure to bisphenols. These chemicals affect humans and animals by disrupting the estrogen, androgen, progesterone, thyroid, and aryl hydrocarbon receptor functions. Bisphenols exert numerous harmful effects because of their interaction with receptors, reactive oxygen species (ROS) formation, lipid peroxidation, mitochondrial dysfunction, and cell signal alterations. Both cohort and case-control studies have determined an association between bisphenol exposure and increased risk of cardiovascular diseases, neurological disorders, reproductive abnormalities, obesity, and diabetes. Prenatal exposure to bisphenols results in developmental disorders in animals. These chemicals also affect the immune cells and play a significant role in initiating the inflammatory response. Exposure to bisphenols exhibit age, gender, and dose-dependent effects. Even at low concentrations, bisphenols exert toxicity, and hence deserve a critical assessment of their uses. Since bisphenols have a global influence on human health, the need to discover the underlying pathways involved in all disease conditions is essential. Furthermore, it is important to promote the use of alternatives for bisphenols, thereby restricting their uses.

Liquefaction of Biomass and Upgrading of Bio-Oil: A Review

The liquefaction of biomass is an important technology to converse the biomass into valuable biofuel. The common technologies for liquefaction of biomass are indirect liquefaction and direct liquefaction. The indirect liquefaction refers to the Fischer-Tropsch (F-T) process using the syngas of biomass as the raw material to produce the liquid fuel, including methyl alcohol, ethyl alcohol, and dimethyl ether. The direct liquefaction of biomass refers to the conversion biomass into bio-oil, and the main technologies are hydrolysis fermentation and thermodynamic liquefaction. For thermodynamic liquefaction, it could be divided into fast pyrolysis and hydrothermal liquefaction. In addition, this review provides an overview of the physicochemical properties and common upgrading methods of bio-oil.