Friction and Shear Properties of Pine Biomass and Pellets

Wood pellets transport with vibrating conveyor: experimental for DEM simulations analysis

This work presents a comprehensive overview of the mechanical-physical parameters of the transport material affecting the vibratory transport. For this purpose, spruce pellets of different lengths, oak rods and spruce crush were tested. The determined parameters were particle size distribution and shape, internal friction, static and dynamic angle of repose. The samples were transported by a patented validation vibrating conveyor. Various settings were used. The results show that by changing the shape, it is possible to reduce friction or resistance as well as energy intensity during transport. It was observed that perfect shapes and lighter particles have lower friction, but a more pronounced bounce. Therefore, it does not form a typical pattern during transport, as in the case of an imperfectly shaped one. There is also included a simulation of the discrete element method. The study shows the possibility of the vibration machine where the material can be conveyed either directionally or sorted.

Determination of the Influence of Mechanical Properties of Capsules and Seeds on the Susceptibility to Feeding of Mononychus pubctumalbum in Endangered Plant Species Iris aphylla L. and Iris sibirica L

The aim of the study was to determine the correlation between the mechanical resistance of iris seed capsules and seeds to Mononychus punctumalbum foraging. The principal component analysis (PCA) demonstrated that the first main component referred to the variety type in 68%, and the second main component described the stage of the ontogenetic development of the plant in 26%. As indicated by the values of each parameter measured, all the parameters were found to exert a strong impact on the variability of the analyzed system. The occurrence of weevil infestation was also strongly but negatively correlated with seed wall thickness and capsule wall thickness. There was a correlation of seed max load and seed mass with the occurrence of the weevil. The analysis of the mechanical resistance of iris seed capsules (in June 9.28 N and September 6.27 N for I. sibirica and in June 6.59 N and September 2.94 N for I. aphylla) and seeds (in June 15.97 N and September 344.90 N for I. sibirica and in June 16.60 N and September 174.46 N for I. aphylla) showed significant differences between the terms and species. The PCA analysis revealed that the first variable was correlated with the occurrence of weevil foraging.

Effect of the Drying Method of Pine and Beech Wood on Fracture Toughness and Shear Yield Stress

The modern wood converting processes consists of several stages and material drying belongs to the most influencing future performances of products. The procedure of drying wood is usually realized between subsequent sawing operations, affecting significantly cutting conditions and general properties of material. An alternative methodology for determination of mechanical properties (fracture toughness and shear yield stress) based on cutting process analysis is presented here. Two wood species (pine and beech) representing soft and hard woods were investigated with respect to four diverse drying methods used in industry. Fracture toughness and shear yield stress were determined directly from the cutting power signal that was recorded while frame sawing. An original procedure for compensation of the wood density variation is proposed to generalize mechanical properties of wood and allow direct comparison between species and drying methods. Noticeable differences of fracture toughness and shear yield stress values were found among all drying techniques and for both species, but only for beech wood the differences were statistically significant. These observations provide a new highlight on the understanding of the effect of thermo-hydro modification of wood on mechanical performance of structures. It can be also highly useful to optimize woodworking machines by properly adjusting cutting power requirements.