Effect of Heat Treatment on Tensile Properties and Microstructure of Co-Free, Low Ni-10 Mo-1.2 Ti Maraging Steel

Optimization of Heat Treatment for 38Si7 Spring Steel with Excellent Mechanical Properties and Controlled Decarburization

Optimizing the heat treatment procedure with 13 mm diameter 38Si7 spring steel is critical for developing high-performance, low-cost, large spring steel for railway clips. The effects of quenching temperature, holding time, tempering temperature, and tempering time on the microstructure and mechanical properties were investigated using an orthogonal experiment, designed with four factors and three levels. The best heat treatment settings were explored, as well as the variation laws of mechanical properties, decarburization behavior, and fracture morphology. The results demonstrated that quenching temperature and tempering temperature had the most impact on plasticity and tempering temperature, while time had the most effect on strength. The optimized heat treatment schemes made the elongation increase by up to 106% and the reduction in area increase by up to 67%, compared with the standard BS EN 10089-2002, and there were mixed fractures caused by ductility and brittleness. The fracture tests showed a good performance of 20.2 GPa·%, and the heat treatment processes’ minimum decarburization depth of 93.4 μm was determined. The optimized process would obtain stronger plastic deposition and better decarburization performance. The microstructure was simply lightly tempered martensite, and the matrix still retained the acicular martensite. The optimal heat treatment process is quenching at 900 °C for 30 min (water cooling), followed by tempering at 430 °C for 60 min (air cooling). The research led to a solution for increasing the overall mechanical characteristics and decreasing the surface decarburization of 38Si7 spring steel with a diameter of 13 mm, and it set the foundation for increasing the mass production of railway clips of this size.