Design, Fabrication and Mass-spectrometric Studies of a Micro Ion Source for High-Field Asymmetric Waveform Ion Mobility Spectrometry

Multi-Channel MEMS-FAIMS Gas Sensor for VOCs Detection

Aimed at the problems of a large equipment size, long time and high price of environmental VOC gas detection, the FAIMS-VOC gas sensor was designed and prepared according to the principle that the ionization energy of the common VOC gas is less than 10.6 eV. The sensor is small in size, fast in detection, low in power consumption, and can work continuously. The sensor was fabricated through the MEMS process, a specific process which included photolithography, etching, anodic bonding, etc. The sensor is 5160 μm long, 5300 μm wide and 800 μm high. We built a test system to detect two typical VOC gases: isobutylene and acetone. The results show that in the detection of isobutylene gas and acetone gas, the sensor voltage value changes with the change of gas concentration. The linearity of testing isobutylene is 0.961, and the linearity of testing acetone is 0.987. When the isobutylene gas concentration is 50 ppm, the response time is 8 s and the recovery time is 6 s; when the acetone gas concentration is 50 ppm, the response time is 9 s and the recovery time is 10 s. In addition, the sensor demonstrates good repeatability and stability, which are conducive to the detection of VOCs in the environment.

Wideband MOEMS for the Calibration of Optical Readout Systems

The paper proposes a technology based on UV-LIGA process for microoptoelectromechanical systems (MOEMS) manufacturing. We used the original combination of materials and technological steps, in which any of the materials does not enter chemical reactions with each other, while all of them are weakly sensitive to the effects of oxygen plasma. This made it suitable for long-term etching in the oxygen plasma at low discharge power with the complete preservation of the original geometry, including small parts. The micromembranes were formed by thermal evaporation of Al. This simplified the technique compared to the classic UV-LIGA and guaranteed high quality and uniformity of the resulting structure. To demonstrate the complete process, a test MOEMS with electrostatic control was manufactured. On one chip, a set of micromembranes was created with different stiffness from 10 nm/V to 100 nm/V and various working ranges from 100 to 300 nm. All membranes have a flat frequency response without resonant peaks in the frequency range 0–200 kHz. The proposed technology potentially enables the manufacture of wide low-height membranes of complex geometry to create microoptic fiber sensors.

A Miniature Four-Channel Ion Trap Array Based on Non-silicon MEMS Technology

With the increasing application field, a higher requirement is put forward for the mass spectrometer. The reduction in size will inevitably cause a loss of precision; therefore, it is necessary to develop a high-performance miniature mass spectrometer. Based on the researches of rectangular ion trap, the relationship between mass resolution and structural parameters of the ion trap array was analyzed by further simulation. The results indicate that, considering the balance of mass resolution and extraction efficiency, the preferable values for the field radius of exit direction y₀ and ion exit slot width s₀ are 1.61 mm and 200 μm, respectively. Afterwards, a miniature four-channel ion trap array (MFITA) was fabricated, by using MEMS and laser etching technology, and mass spectrometry experiments were carried out to demonstrate its performance. The mass resolution of butyl diacetate with m/z = 230 can reach 324. In addition, the consistency of four channels is verified within the error tolerance, by analyzing air samples. Our work can prove the correctness of the structural design and the feasibility of MEMS preparation for MFITA, which will bring meaningful guidance for its future development and optimization.