Preparation of Functional Nanoparticles-Loaded Magnetic Carbon Nanohorn Nanocomposites towards Composite Treatment

Preclinical evaluation of modified carbon nanohorns and their complexation with insulin

The current study emphasizes the minimal toxicity observed in vitro and in vivo for carbon nanohorns (CNHs) modified with third generation polyamidoamine (PAMAM) dendrimers. Initially, we investigated the interactions between CNH-PAMAM and lipid bilayers, which were utilized as representative models of cellular membranes for the evaluation of their toxicity in vitro. We found that the majority of those interactions occur between the modified CNHs and the polar groups of phospholipids, meaning that CNH-PAMAM does not incorporate into the lipid chains, and thus, disruption of the lipid bilayer structure is avoided. This outcome is a very important observation for further evaluation of CNH-PAPAM in cell lines and in animal models. Next, we demonstrated the potential of CNH-PAMAM for complexation with insulin, as a proof of concept for its employment as a delivery platform. Importantly, our study provides comprehensive evidence of low toxicity for CNH-PAMAM both in vitro and in vivo. The assessment of cellular toxicity revealed that the modified CNHs exhibited minimal toxicity, with concentrations of 151 μg mL-1 and 349 μg mL-1, showing negligible harm to EO771 cells and mouse embryonic fibroblasts (MEFs), respectively. Moreover, the histological analysis of the mouse livers demonstrated no evidence of tissue necrosis and inflammation, or any visible signs of severe toxicity. These findings collectively indicate the safe profile of CNH-PAMAM and further contribute to the growing body of knowledge on the safe and efficient utilization of CNH-based nanomaterials in drug and protein delivery applications.

Effects of Nano-CeO2 on Microstructure and Properties of WC/FeCoNiCrMo0.2 Composite High Entropy Alloy Coatings by Laser Cladding

FeCoNiCrMo0.2 high entropy alloy has many excellent properties, such as high strength, high wear resistance, high corrosion resistance, and high ductility. To further improve the properties of this coating, FeCoNiCrMo high entropy alloy (HEA) coatings, and two composite coatings, FeCoNiCrMo0.2 + WC and FeCoNiCrMo0.2 + WC + CeO₂, were prepared on the surface of 316L stainless steel by laser cladding technology. After adding WC ceramic powder and CeO₂ rare earth control, the microstructure, hardness, wear resistance, and corrosion resistance of the three coatings were carefully studied. The results show that WC powder significantly improved the hardness of the HEA coating and reduced the friction factor. The FeCoNiCrMo0.2 + 32%WC coating showed excellent mechanical properties, but the distribution of hard phase particles in the coating microstructure was uneven, resulting in unstable distribution of hardness and wear resistance in each region of the coating. After adding 2% nano-CeO₂ rare earth oxide, although the hardness and friction factor decreased slightly compared with the FeCoNiCrMo0.2 + 32%WC coating, the coating grain structure was finer, which reduced the porosity and crack sensitivity of the coating, and the phase composition of the coating did not change; there was a uniform hardness distribution, a more stable friction coefficient, and the flattest wear morphology. In addition, under the same corrosive environment, the value of polarization impedance of the FeCoNiCrMo0.2 + 32%WC + 2%CeO₂ coating was greater, the corrosion rate was relatively low, and the corrosion resistance was better. Therefore, based on various indexes, the FeCoNiCrMo0.2 + 32%WC + 2%CeO₂ coating has the best comprehensive performance and can extend the service life of 316L workpieces.