Electrospun Bimetallic NiCr Nanoparticles@Carbon Nanofibers as an Efficient Catalyst for Hydrogen Generation from Ammonia Borane

Electrospun NiPd Nanoparticles Supported on Polymer Membrane Nanofibers as an Efficient Catalyst for NaBH4 Dehydrogenation

Sodium borohydride (SBH) hydrolysis in the presence of cheap and efficient catalysts has been proposed as a safe and efficient method for generating clean hydrogen energy for use in portable applications. In this work, we synthesized bimetallic NiPd nanoparticles (NPs) supported on poly(vinylidene fluoride-co-hexafluoropropylene) nanofibers (PVDF-HFP NFs) via the electrospinning approach and reported an in-situ reduction procedure of the NPs being prepared by alloying Ni and Pd with varying Pd percentages. The physicochemical characterization provided evidence for the development of a NiPd@PVDF-HFP NFs membrane. The bimetallic hybrid NF membranes exhibited higher H₂ production as compared to Ni@PVDF-HFP and Pd@PVDF-HFP counterparts. This may be due to the synergistic effect of binary components. The bimetallic Ni_1-xPd_x(x = 0, 0.05, 0.1, 0.15, 0.2, 0.25, 0.3)@PVDF-HFP nanofiber membranes exhibit composition-dependent catalysis, in which Ni₇₅Pd₂₅@PVDF-HFP NF membranes demonstrate the best catalytic activity. The full H₂ generation volumes (118 mL) were obtained at a temperature of 298 K and times 16, 22, 34 and 42 min for 250, 200, 150, and 100 mg dosages of Ni₇₅Pd₂₅@PVDF-HFP, respectively, in the presence of 1 mmol SBH. Hydrolysis utilizing Ni₇₅Pd₂₅@PVDF-HFP was shown to be first order with respect to Ni₇₅Pd₂₅@PVDF-HFP amount and zero order with respect to the [NaBH₄] in a kinetics study. The reaction time of H₂ production was reduced as the reaction temperature increased, with 118 mL of H₂ being produced in 14, 20, 32 and 42 min at 328, 318, 308 and 298 K, respectively. The values of the three thermodynamic parameters, activation energy, enthalpy, and entropy, were determined toward being 31.43 kJ mol^-1, 28.82 kJ mol^-1, and 0.057 kJ mol^-1 K^-1, respectively. It is simple to separate and reuse the synthesized membrane, which facilitates their implementation in H₂ energy systems.

CuNi Alloy NPs Anchored on Electrospun PVDF-HFP NFs Catalyst for H2 Production from Sodium Borohydride

Non-noble Cu_xNi_1-x (x = 0, 0.1, 0,2, 0.3, 0.4, 0.5, 0.6, 0.7, 0.8, 0.9, 1) alloy nanoparticles supported on poly(vinylidene fluoride-co-hexafluoropropene) (PVDF-HFP) nanofibers (NFs) are successfully fabricated. The fabrication process is executed through an electrospinning technique and in situ reduction in Cu²⁺ and Ni²⁺ salts. The as-synthesized catalysts are characterized using standard physiochemical techniques. They demonstrate the formation of bimetallic NiCu alloy supported on PVDF-HFP. The introduced bimetals show better catalytic activity for sodium borohydride (SBH) hydrolysis to produce H₂, as compared to monometallic counterparts. The Cu_0.7 Ni_0.3/PVDF-HFP catalyst possesses the best catalytic performance in SBH hydrolysis as compared to the others bimetallic formulations. The kinetics studies indicate that the reaction is zero order and first order with respect to SBH concentration and catalyst amount, respectively. Furthermore, low activation energy (Ea = 27.81 kJ/mol) for the hydrolysis process of SBH solution is obtained. The excellent catalytic activity is regarded as the synergistic effects between Ni and Cu resulting from geometric effects over electronic effects and uniform distribution of bimetallic NPs. Furthermore, the catalyst displays a satisfying stability for five cycles for SBH hydrolysis. The activity has retained 93% from the initial activity. The introduced catalyst has broad prospects for commercial applications because of easy fabrication and lability.

Electrospun Donor/Acceptor Nanofibers for Efficient Photocatalytic Hydrogen Evolution

We prepared a series of one-dimensional conjugated-material-based nanofibers with different morphologies and donor/acceptor (D/A) compositions by electrospinning for efficient photocatalytic hydrogen evolution. It was found that homogeneous D/A heterojunction nanofibers can be obtained by electrospinning, and the donor/acceptor ratio can be easily controlled. Compared with the single-component-based nanofibers, the D/A-based nanofibers showed a 34-fold increase in photocatalytic efficiency, attributed to the enhanced exciton dissociation in the nanofibrillar body. In addition, the photocatalytic activity of these nanofibers can be easily optimized by modulating the diameter. The results show that the diameter of the nanofibers can be conveniently controlled by the electrospinning feed rate, and the photocatalytic effect increases with decreasing fiber diameter. Consequently, the nanofibers with the smallest diameter exhibit the most efficient photocatalytic hydrogen evolution, with the highest release rate of 24.38 mmol/(gh). This work provides preliminary evidence of the advantages of the electrospinning strategy in the construction of D/A nanofibers with controlled morphology and donor/acceptor composition, enabling efficient hydrogen evolution.

Catalytic and Photocatalytic Electrospun Nanofibers for Hydrogen Generation from Ammonia Borane Complex: A Review

Hydrogen (H₂) is a promising renewable energy source that can replace fossil fuels since it can solve several environmental and economic issues. However, the widespread usage of H₂ is constrained by its storage and safety issues. Many researchers consider solid materials with an excellent capacity for H₂ storage and generation as the solution for most H₂-related issues. Among solid materials, ammonia borane (abbreviated hereafter as AB) is considered one of the best hydrogen storage materials due to its extraordinary H₂ content and small density. However, the process must be conducted in the presence of efficient catalysts to obtain a reasonable amount of generated H₂. Electrospun nanofibrous catalysts are a new class of efficient catalysts that involves the usage of polymers. Here, a comprehensive review of the ceramic-supported electrospun NF catalysts for AB hydrolysis is presented, with a special focus on catalytic and photolytic performance and preparation steps. Photocatalytic AB hydrolysis was discussed in detail due to its importance and promising results. AB photocatalytic hydrolysis mechanisms under light were also explained. Electrospun catalysts show excellent activity for AB hydrolysis with good recyclability. Kinetics studies show that the AB hydrolysis reaction is independent of AB concentration and the first-order reaction of NF catalysts.

Novel Low Temperature Route to Produce CdS/ZnO Composite Nanofibers as Effective Photocatalysts

In this work, CdS/ZnO composite nanofibers (NFs) were prepared by the electrospinning of a sol–gel comprised of poly(caprolactone), zinc acetate dihydrate, cadmium acetate dihydrate, and ammonium sulfide. The electrospun NF mats were calcined under vacuum in an argon (Ar) atmosphere at 200 °C for 1 h. Standard physiochemical analysis techniques demonstrated the formation of the crystalline hexagonal phase of CdS and ZnO. Composite NFs showed good photocatalytic degradation of methylene blue (MB) dye under visible light irradiation compared to their counterparts. CdS nanoparticles, ZnO nanofibers, and composite NFs photodegraded 35.5%, 47.3%, and 90% of the MB dye, respectively, within 100 min. The reaction kinetics of MB photodegradation using the composite NFs followed the pseudo-first-order relation. Owing to their facile preparation and good photodegradation ability, the proposed method can be used to prepare various photocatalysts for wastewater treatment.