Investigating the Electrocoagulation Treatment of Landfill Leachate by Iron/Graphite Electrodes: Process Parameters and Efficacy Assessment

Application of electrocoagulation process for the disposal of COD, NH3-N and turbidity from the intermediate sanitary landfill leachate

This study aims to determine the COD, NH3-N and turbidity disposal efficiencies from leachate in the Bingöl landfill and highlight the electrocoagulation (EC) process's performance in removing these pollutants. After establishing that landfill leachate was intermediate aged, its characteristics were identified using physical, chemical and elemental analyses. Six parallel-connected electrode plates with stainless steel as the cathode and aluminium as the anode were used to construct an electrocoagulation cell. After a 40-min treatment interval, the optimal disposal efficiencies for COD and turbidity from the leachate were determined to be 87% and 62%, respectively, at pH 5. Following a 40-min reaction, BOD5 concentration and BOD5/COD ratio were determined to be 85.75 mg O2/L and 0.64, respectively, at pH 5. At a NaCl concentration of 10 mM, the optimum disposal efficiency for NH3-N was determined to be 33%. The reaction kinetics matched pseudo-first-order (PFO) kinetics due to high correlation coefficients (R2 = 0.93-0.99) in removing COD, NH3-N and turbidity under different experimental conditions. The optimal reaction rate constants were determined as 2.93 × 10-2 min-1, 1.92 × 10-2 min-1 and 7.3 × 10-3 min-1 for the disposal of COD, NH3-N and turbidity, respectively. Energy consumption, unit energy consumption and total consumption cost rose in the EC process when the current density was augmented from 15 to 25 mA/cm2.

A pilot-scale electrocoagulation-treatment wetland system for the treatment of landfill leachate

In the present study, the technical feasibility of an electrocoagulation-treatment wetland continuous flow system, for the removal of organic matter from landfill leachate (LL), was evaluated. The response surface methodology (MSR) was used to assess the individual and combined effects of the applied potential and distance between electrodes, on the removal efficiency and optimization of the electrocoagulation process. The hybrid treatment wetland system consisted of a vertical flow system coupled to a horizontal subsurface flow system, both planted with Canna indica. For a chemical oxygen demand (COD) concentration - without pretreatment of 5142.8 ± 2.5 mg L-1, the removal percentage for the electrocoagulation system was 79.4 ± 0.16%, under the optimal working conditions (Potential: 20 V; Distance: 2.0 cm). The COD removal efficiency in the treatment wetland with Canna indica showed a dependence with the hydraulic retention time, reaching 59.2 ± 0.2 % over 15 days. The overall efficiency of the system was about 91.5 ± 0.02 % removal of COD. In addition, a decrease in the biochemical oxygen demand (94.8 ± 0.14%) and total suspended solids (88.2 ± 0.22%), also related to the contamination levels of the LL, were obtained. This study, for the first time, shows that the coupling of electrocoagulation together with a treatment wetland system is a good alternative for the removal of organic contaminants present in LL.

Hybrid electrochemical/membrane couplings processes for enhancing seawater pretreatment and desalination

This research focuses on boosting seawater pretreatment and desalination through electrocoagulation (EC)/ultrafiltration (UF) and electrocoagulation (EC)/nanofiltration (NF) processes. We first optimized the key parameters of the EC process using aluminum (Al) and iron (Fe) electrodes. Experimental results show EC process is efficient under optimal conditions. Second, membrane filtration using UF (ES10B), NF(UTC60) and NF(200) as post-processing steps to the EC process were experimented with. EC(Al)/NF(UTC60) combination resulted in the highest removal rate of organic matter (COD 98%, TOC 95%, fluorescence [humic and fulvic acids] 68%), optical density (OD600nm 75%, turbidity 70%, conductivity 64%). In terms of major ions removal, up to 55% was achieved as NF decreases conductivity, salinity, and hardness. EC(Al)/NF(UTC60) seawater permeate demonstrated the best results in terms of lowest flux decline (J/Jo  = 0.9) and fouling, which was realized by resistance in series and recovery factor rate (%). Additionally, NF(UTC60) fouling reversibility led to a longer lifetime and higher recovery factor (93%). PRACTITIONER POINTS: Pretreatment by hybrid processes was experimented with to enhance the saline water treatment. Organic matter (COD 98%, TOC 95%, fluorescence [humic and fulvic acids] 68%) and turbidity were successfully removed. Salinity and hardness (conductivity 64%) were highly reduced by NF. Flux decline, retention rate, and membrane fouling were studied.

Preparation and Characterization of an Invasive Plant-Derived Biochar-Supported Nano-Sized Lanthanum Composite and Its Application in Phosphate Capture from Aqueous Media

Invasive plants pose a great threat to natural ecosystems owing to their rapid propagation and spreading ability in nature. Herein, a typical invasive plant, Solidago canadensis, was chosen as a novel feedstock for the preparation of nano-sized lanthanum-loaded S. canadensis-derived biochar (SCBC-La), and its adsorption performance for phosphate removal was evaluated by batch adsorption experiment. The composite was characterized by multiple techniques. Effects of parameters, such as the initial concentration of phosphate, time, pH, coexisting ions, and ionic strength, were studied on the phosphate removal. Adsorption kinetics and isotherms showed that SCBC-La shows a faster adsorption rate at a low concentration and SCBC-La exhibits good La utilization efficiency than some of the reported La-modified adsorbents. Phosphate can be effectively removed over a relatively wide pH of 3-9 because of the high pH _pzc of SCBC-La. Furthermore, the SCBC-La shows a strong anti-interference capability in terms of pH value, coexisting ions, and ionic strength, exhibiting a highly selective capacity for phosphate removal. Additionally, Fourier transform infrared spectroscopy (FT-IR) and X-ray photoelectron spectroscopy (XPS) measurements reveal that hydroxyl groups on the surface of SCBC-La were replaced by phosphate and manifest the reversible transformation between La(OH)₃ and LaPO₄. Considering its high adsorption capacity and excellent selectivity, SCBC-La is a promising material for preventing eutrophication. This work gives a new method of pollution control with waste treatment since the invasive plant (S. canadensis) is converted into biochar-based nanocomposite for effective removal of phosphate to mitigate eutrophication.

Simultaneous removal of fluoride and nitrate from synthetic aqueous solution and groundwater by the electrochemical process using non-coated and coated anode electrodes: A human health risk study

Co-presence of fluoride (F^-) and nitrate (NO₃^-) in water causes numerous health complications. Thus, they should be eliminated by an appropriate method like the EC process. In this research, simultaneous removal of F^- and NO₃^- from synthetic aqueous solution and groundwater has been considered by the EC technique under operational parameters like anode materials (un-coated (Al and Fe) and synthesized coated (Ti/TiRuSnO₂ and Ti/PbO₂)), cathode materials (Cu, St, and Gr), current density (12, 24, and 36 mA/cm²), inter-electrode distance (0.5, 1, and 2 cm), pH (5.5, 7, and 8.5), NaCl concentrations (0.5, 1, and 1.5 g/L), electrolysis time (15, 30, 45, 60, 90, and 120 min), NO₃^- concentrations (75, 150, and 225 mg/L), and F^- concentrations (2, 4, 6, and 8 mg/L) for the first time in this research. The results proved that Al as non-coated anode and Cu as cathode electrodes were more effective in the co-removal of F^- and NO₃^-. The maximum removal efficiencies of 94.19 and 95% were observed at the current density of 36 mA/cm², 1 cm of inter-electrode distance, pH 7, 1 g/L of NaCl, and 90 min electrolysis time by Al-Cu electrode for F^- (2 mg/L) and NO₃^- (75 mg/L), respectively. The higher efficiency of Al-Cu electrodes was due to the simultaneous occurrence of electrocoagulation, electroreduction, and electrooxidation processes. Al-Cu electrode application considerably diminished f- and NO3- concentrations in the groundwater. Health risk assessment proved that HQ of F^- was significantly decreased after treatment by the Al-Cu electrode. Thus, the EC process using an appropriate and effective electrode is a promising technique for treating aqueous solutions containing F^- and NO₃^-.

A hybrid process for leachate wastewater treatment: Evaporation and reverse osmosis/sequencing batch reactor

In this study, a hybrid process for leachate wastewater treatment including evaporation and reverse osmosis (RO) membrane or biological treatment systems was suggested. Experiments were performed on a real landfill leachate wastewater. The leachate was subjected to evaporation; as a result, a distillate was obtained containing less organic matter and less substantial amounts of other pollutants, as ammonium salts and total phenols were removed. Tests were carried out at different evaporation temperatures and times. The initial leachate pH was adjusted and optimized. For optimum conditions, each of chemical oxygen demand (COD), total phenol, and ammonium salt concentrations were reduced to 99.99%, 95.00%, and 83.00%, respectively. The distillate of the first stage of the proposed process was then exposed to RO membrane system, as a first study, under different transmembrane pressure of 20, 30, and 40 bar and at different pH values of 7, 8, and 9. As a second suggested treatment system, the distillate was subjected to a biological treatment process for 30 days as a retention time, pH = 6, and room temperature 25°C ± 1°C. At the end of the research study, a comparison was conducted between results obtained with RO membrane separation and biological treatment system as two distinct treatment systems proposed for leachate landfill wastewater treatment. Although both systems were effective for landfill leachate wastewater treatment, however, with the RO membrane separation system, COD removal efficiency reached 99.99%. In the other hand, with biological treatment process, COD elimination was as much as 90.00%. Certainly, evaporation and RO are not novel ways of landfill leachate treatment; however, few studies have attempted to use similar combined system for landfill leachate wastewater treatment and attained effective results of treated water. PRACTITIONER POINTS: A hybrid process of evaporation and RO membrane or biological treatment systems was suggested for leachate wastewater treatment. For optimum conditions, COD, total phenols, and ammonium salt reductions were achieved to 99.99%, 95%, and 83%, respectively, after the first evaporation stage. The distillate of the first stage of the proposed process was then exposed to RO membrane system and biological treatment system. Different transmembrane pressure and different pH values were optimized for RO.