Open surgery for abdominal aortic aneurysm in the era of endovascular repair: comparison with long term results of endovascular repair using zenith stentgraft

A new approach for the pre-clinical optimization of a spatial configuration of bifurcated endovascular prosthesis placed in abdominal aortic aneurysms

Complexity of the spatial configuration of an aortic implant with bifurcation in the distal part is related to changes in blood hemodynamic in the area of bifurcation which may disturb blood flow and lead to thrombus formation. This study was designed to characterize parameters which define spatial configuration of an aortic implant for which the risk of thrombus formation is the smallest. We used AngioCT data from 74 patients, aged 55 ±10 years, after endovascular procedure to prepare 3D geometries of stent-grafts. Computational Fluid Dynamics (CFD) simulations were used to reconstruct blood hemodynamic and simulate thrombus formation. Next, geometric parameters of stent-grafts included the ratio of volume of upper part to the bifurcations, the relation of inlet and outlet diameters of a stent-graft and deformations in the iliac part of the stent-graft were analyzed. We also analyzed tortuosities (spiral twisting of the flow around the flow direction) and bends (the largest angulation in distal part of a stent-graft). The CFD results were confronted with AngioCT data to verify if computer generated thrombus appeared in particular patient. Additionally, geometric parameters of analyzed stent-grafts were used to propose a mathematical tool for prediction of thrombus appearance. The results showed that tortuosities and bends of a stent-graft had the highest impact on thrombus formation. Formation of thrombi was observed in 22% to 31% of cases (at blood hematocrit Hct = 40%) even for small values of tortuosities and bends indicating that these parameters are dominant in determining blood clotting. Our calculated results overlapped with clinical data in 80% to 91%. Therefore, we conclude that tortuosities and bends have high impact on thrombus formation and should be under special attention during stent-graft recommendation and patients’ follow-ups.

A Novel Attempt to Standardize Results of CFD Simulations Basing on Spatial Configuration of Aortic Stent-Grafts

Currently, studies connected with Computational Fluid Dynamic (CFD) techniques focus on assessing hemodynamic of blood flow in vessels in different conditions e.g. after stent-graft’s placement. The paper propose a novel method of standardization of results obtained from calculations of stent-grafts' “pushing forces” (cumulative WSS—Wall Shear Stress), and describes its usefulness in diagnostic process. AngioCT data from 27 patients were used to reconstruct 3D geometries of stent-grafts which next were used to create respective reference cylinders. We made an assumption that both the side surface and the height of a stent-graft and a reference cylinder were equal. The proposed algorithm in conjunction with a stent-graft “pushing forces” on an implant wall, allowed us to determine which spatial configuration of a stent-graft predispose to the higher risk of its migration. For stent-grafts close to cylindrical shape (shape factor φ close to 1) WSS value was about 267Pa, while for stent-grafts different from cylindrical shape (φ close to 2) WSS value was about 635Pa. It was also noticed that deformation in the stent-graft’s bifurcation part impaired blood flow hemodynamic. Concluding the proposed algorithm of standardization proved its usefulness in estimating the WSS values that may be useful in diagnostic process. Angular bends or tortuosity in bifurcations of an aortic implant should be considered in further studies of estimation of the risk of implantation failure.