A New Perspective on Adsorbent Materials Based Impregnated MgSiO3 with Crown Ethers for Palladium Recovery

The study of new useful, efficient and selective structures for the palladium ions’ recovery has led to the development of a new series of macromolecules. Thus, this study presents a comparative behavior of two crown benzene ethers that modify the magnesium silicate surface used as adsorbent for palladium. These crown ethers are dibenzo18-crown-6 (DB18C6) and dibenzo 30-crown-10 (DB30C10). The obtained materials were characterized by scanning electron microscope (SEM), energy-dispersive X-ray spectroscopy (EDX) and Fourier-transform infrared spectroscopy (FT-IR). The specific surface area (BET) and point of zero charge (PZC) of the two materials were determined. The palladium ions’ recovery from synthetic aqueous solutions studies aimed to establish the adsorption mechanism. For this desideratum, the kinetic, equilibrium and thermodynamic studies show that MgSiO₃-DB30C10 have a higher adsorption capacity (35.68 mg g⁻¹) compared to MgSiO₃-DB18C6 (21.65 mg g⁻¹). Thermodynamic studies highlight that the adsorption of Pd(II) on the two studied materials are spontaneous and endothermic processes. The positive values of the entropy (ΔS⁰) suggest that the studied adsorption processes show a higher disorder at the liquid/solid interface. Desorption studies were also performed, and it was found that the degree of desorption was 98.3%.

Evaluation of Performance of Functionalized Amberlite XAD7 with Dibenzo-18-Crown Ether-6 for Palladium Recovery

Due to the increased demand for palladium, as well due to its reduced availability in nature, its recovery from diluted waste solutions becomes a necessity, and perhaps an emergency. As a result of economic and technological development, new materials with improved adsorbent properties that are more efficient for metallic ions' recovery were synthesized and introduced to market. The goal of this study was to obtain a new adsorbent material by functionalizing through impregnation a commercial polymeric support that was both inexpensive and environmentally friendly (Amberlite XAD7) with crown ether (di-benzo-18-crown-6-DB18C6). Crown ethers are known for their ability to form complexes within metallic ions, by including them inside of the ring, regardless of its atomic size. Adsorbent material was prepared by impregnation using the solvent-impregnated resin method (SIR). To highlight the presence of crown ether on the resin surface, a new synthesized material was characterized by scanning electron microscopy (SEM), elemental analysis X-ray energy dispersive spectroscopy (EDX) and Fourier transform infrared spectroscopy (FT-IR). The specific surface of the adsorbent material was also determined by the Brunauer-Emmett-Teller (BET) method. Adsorbent performances of the prepared material were highlighted by kinetic, thermodynamic and equilibrium studies and a possible mechanism was also proposed. The influence of specific parameters for the adsorption process (contact time, temperature, Pd(II) initial concentration) on the maximum adsorption capacity was pursued.